Organic molecules based photovoltaic cells were fabricated in an open laboratory conditions without the use of glove box or clean room. Conducting polymers such as P3HT and PCBM were used as a photo-active layer of the devices. We found significant difference in the performance of the devices by employing two laboratory conditions of the polymer solutions. Enhanced current density has been observed from P3HT/PCBM bulkheterojunction solar cell after diluting a well sonicated polymers solution with fresh chloroform solvent. As the result of such current surge in the devices the efficiency rose to more than double compared to those devices without dilution of the P3HT/PCBM solution. An average power conversion efficiency of 4.5% was then recorded from the new preparation condition. This is an encouraging development toward achieving low cost organic photovoltaic devices. / Thesis (M.Sc.)-University of KwaZulu-Natal, Pietermaritzburg, 2013.

"Submitted in partial fulfillment of the requirements for the degree of Master of Business Administration from the Naval Postgraduate School, June 2008." / Advisor(s): Dew, Nicholas ; Ventresca, Marc. "June 2008." "MBA professional report"--Cover. Description based on title screen as viewed on August 7, 2008. Includes bibliographical references (p. 91-97). Also available in print.

Thesis (M.S.)--Ohio University, March, 1997. / Title from PDF t.p.

Thesis (Ph. D.)--University of Oregon, 2007. / Typescript. Includes vita and abstract. Includes bibliographical references (leaves 127-132). Also available online in Scholars' Bank; and in ProQuest, free to University of Oregon users.

Dissertation (Ph.D.)--University of Toledo, 2008. / Typescript. "Submitted as partial fulfillment of the requirements for the Doctor of Philosophy Degree in Physics." Bibliography: leaves 124-132.

Thesis (Ph.D.)--Electrical and Computer Engineering, Georgia Institute of Technology, 2008. / Committee Chair: Honsberg, Christiana; Committee Co-Chair: Citrin, David; Committee Member: Doolittle, Alan; Committee Member: First, Phillip; Committee Member: Ralph, Stephen; Committee Member: Rohatgi, Ajeet

Thesis (M.S. in Electrical Engineering)--Naval Postgraduate School, September 2009. / Thesis Advisor(s): Michael, Sherif. "September 2009." Description based on title screen as viewed on 5 November 2009. Author(s) subject terms: Thin-Film photovoltaics, CIGS, unmanned aerial systems, UAV, solar plane, Maximum Power Point Tracker (MPPT), lithium polymer. Includes bibliographical references (p. 115-125). Also available in print.

Thesis (M.S.)--California Polytechnic State University, 2009. / Mode of access: Internet. Title from PDF title page; viewed on August 6, 2009. "Presented to the faculty of Architecture, California Polytechnic State University, San Luis Obispo." "In partial fulfillment of the requirements for the degree [of] Master of Science in Architecture." Major professor: Dr. Jens Pohl. "June 2009." Includes bibliographical references (p. 109-111).

Thesis (Ph. D.)--Rutgers University, 2008. / "Graduate Program in Ceramic and Materials Science and Engineering." Includes bibliographical references.

Thesis (M.S.)--Brigham Young University. Dept. of Mechanical Engineering, 2007. / Includes bibliographical references (p. 71).