Many issues related to the design and implementation of a maximum power point tracking (MPPT) converter as part of a photovoltaic (PV) system are addressed. To begin with, variations of the single diode model for a PV module are compared, to determine whether the simplest variation may be used for MPPT PV system modeling and analysis purposes. As part ot this determination, four different DC/DC converters are used in conjunction with these different PV models. This is to verify consistent behavior across the different PV models, as well as across the different converter topologies. Consistent results across the different PV models, will allow a simpler model to be used for simulation ana analysis. Consistent results with the different converters will verify that MPPT algorithms are converter independent. Next, MPPT algorithms are discussed. In particular,the differences between the perturb and observe, and the incremental conductance algorithms are explained and illustrated. A new MPPT algorithm is then proposed based on the deficiencies of the other algorithms. The proposed algorithm's parameters are optimized, and the results for different PV modules obtained. Realistic system losses are then considered, and their effect on the PV system is analyzed ; especially in regards to the MPPT algorithm. Finally, a PV system is implemented and the theoretical results, as well as the behavior of the newly proposed MPPT algorithm, are verified. / by Thomas Bennett. / Thesis (Ph.D.)--Florida Atlantic University, 2012. / Includes bibliography. / Mode of access: World Wide Web. / System requirements: Adobe Reader.

The needs to the sustainable development of electricity, energy efficiency improvement, and environment pollution reduction have favored the development of distributed generation (DG). But the problems come with increasing DG penetration in distribution networks. This thesis presents the Solar Energy Grid Integration System (SEGIS) Stage III project done by Portland General Electric (PGE), Advanced Energy, Sandia National Lab on a PGE selected distribution feeder. The feeder has six monitored commercial solar PV systems connected. The total power output from the PV systems has the potential to reach 30% of the feeder load. The author analyzes the performance of the solar feeder on both generation and voltage effects. As a project report, it introduced a new islanding detection done by other team members to give an islanding solution of future high penetration distribution networks. At last, the author describes micro-grid and grid support concepts in a SEGIS concept paper with some examples.