When a concentrated load is introduced perpendicular to the flanges of a steel beam, this condition is referred to as Patch loading (Gozzi, 2007). This occurrence is common in many steel structures, for example at supports or during launching of bridges. Because of the usual slenderness of I-beams and other plated structures, these are sometimes reinforced with stiffeners in order to avoid buckling. Modifications, such as adding stiffeners to a beam, are done to make greater plastic deformations possible before buckling can occur; thereby increasing the resistance against failure. Transverse stiffeners are added in areas where the beam is exposed to concentrated loads (Lagerqvist, 1994). The descriptions of calculating patch loading in the Eurocode are presented for cases of double stiffeners, with the load applied in between two stiffeners with same distance to each of them, or when there is one single stiffener that is acting in line with the load. In the Eurocode there are also descriptions on how to calculate on the resistance against patch loading when there are no stiffeners added. However, the Eurocode lacks descriptions for cases when the stiffeners are misaligned. The purpose of this paper is the evaluation of the impact from transverse stiffeners to the resistance of welded I-beams, when the stiffeners are misaligned and where the length of the beam varies. Because of the complexity of such of problems it is almost impossible to find theoretical solutions (Lagerqvist & Johansson, 1996). Therefore, in this study as well as in almost all studies that aim to predict the ultimate resistances of steel beams subjected to patch loading, the results are gained empirically. The tests herein were done by FE-modeling and the results from the physical experiments done in Lagerkvist’s doctoral thesis were used for validation of the model, as conducting experiments ourselves was not economically possible. 6 The study was made in two steps. In the first step FE-models were produced under the same circumstances as the results obtained by Lagerqvist (1994). Those analyses were not part of the aim of the study; the intention for making the initial analyses was to strengthen the reliability of the results. From there, the final analyses were made with the aim in investigating the influence of stiffeners on the resistance, when these are misaligned. In this step, observations were also made with regards to the impact of the bending moment of the beam on its resistance. The initial analyses, which were made for validation of the modeling, had a satisfying correspondence to the physical experiments; hence the final analyses are assumed valid of acceptance. From observations of the results in the final analyses it is noticed that adding stiffeners is a highly preferred way of increasing the resistance for slender beams. For full utilization it is however important to have the stiffeners optimally placed, because a small deviation from this position gives an unwanted decrease in resistance.