published_or_final_version / Civil and Structural Engineering / Master / Master of Philosophy

Settling basins can be shortened by using a stack of horizontal parallel plates which develop boundary layers in which sedimentation can occur. The purpose of this study is to examine the design parameters for such a system and to apply this approach to a fish rearing channel in which settling length is strictly limited. Flow between parallel rough and smooth plates has been modelled together with sediment concentration profile. Accurate description of boundary layer flow requires the solution of Navier-Stokes equations, and due to the complexity of the equations to be solved for turbulent flow some assumptions are made to relate the Reynolds stresses to turbulent kinetic energy and turbulent energy dissipation rate. The simplified equations are solved using a numerical method which uses the approach given by the TEACH code. The flow parameters obtained from the turbulent flow model are used to obtain the sediment concentration profile within the settling plates. Numerical solution of the sedimentation process is obtained by adopting the general transport equation. The lower plate is assumed to retain sediments reaching the bottom. The design of a sedimentation tank for a fish rearing unit with high velocity of flow has been investigated. The effectiveness of the sedimentation tank depends on the uniformity of flow attained at the inlet, and experiments were conducted to obtain the most suitable geometric system to achieve uniform flow distribution without affecting other performances of the fish rearing unit. The main difficulties to overcome were the heavy circulation present in the sedimentation tank and the clogging of the distributing system by suspended particles. Several distributing systems were investigated, the best is discussed in detail. It was concluded that a stack of horizontal parallel plates can be used in fish rearing systems where space is limited for settling sediments. Flow distribution along the vertical at the entrance to the plates determines the efficiency of the sediment settling process and a suitable geometrical configuration can be constructed to distribute the high velocity flow uniformly across the vertical. Numerical modelling of sediment removal ratio for flow between smooth and rough parallel plates has been calculated. The results show that almost the same pattern of sediment deposition occurs for both the smooth-smooth and rough-smooth plate arrangements. / Applied Science, Faculty of / Civil Engineering, Department of / Graduate

An experimental study is presented on the non-linear twisting of plates with free edges, through the application of self-equilibrating corner loads. A simple apparatus was designed and various sizes of plates were twisted while measuring the surface strains on both sides at the centre. Initial difficulty was encountered due to unwanted deflection of the plate under its own weight. The Rayleigh-Ritz method is used to determine an analytical relationship between midsurface strains and curvatures in the pre- and post-bifurcation regions of twisting. In both the experimental and analytical results, the midsurface strains are found to vary linearly with the Gaussian curvature. Non-dimensional groups are identified which collapse the experimental load-strain, load-curvature and midsurface strain-Gaussian curvature relationships. These non-dimensional groups collapse the results in both the linear and non-linear regions. The curvature at the point of bifurcation is identified as a function of plate dimensional parameters. Also shown are the expressions for critical surface strain and corner load at which bifurcation occurs. The experimental load-curvature relationship and point of bifurcation are compared with analytical results found in the literature. A large discrepancy in the literature is resolved for the theoretical point of bifurcation. The present results form a basis for verification of future analytical results, and are important in the measurement of constitutive relationships using the twisted plate test. / Applied Science, Faculty of / Mechanical Engineering, Department of / Graduate