Thesis (Ph. D.)--University of Wisconsin--Madison, 1980. / Typescript. Vita. eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references (leaves 246-251).

Thesis (Ph. D.)--Cornell University. / Reprinted from the Physical review, vol. XVIII, no. 1, July, 1903.

Thesis--(Ph.D.)--University of Wisconsin--Madison, 1978. / Typescript. Vita. eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references.

Thesis (Ph. D.)--University of Texas at Austin, 2005. / Supervisor: Thomas E. Milner. Vita. Includes bibliographical references.

Dissertation (Ph.D.)--University of Toledo, 2005. / Typescript. "A dissertation [submitted] as partial fulfillment of the requirements of the Doctor of Philosophy degree in Engineering." Bibliography: leaves 106-120.

In this study, the Jones matrix eigenanalysis (JME), optical spectrum analyzer (OSA) and polarization scrambling methods were used to investigate polarization dependent loss (PDL) in the presence of polarization mode dispersion (PMD) in optical components and fibres. The PDL measurements were conducted both in the laboratory and in the field. For field measurements, a buried link (28.8 km) and an aerial fibre (7.1 km) were extensively studied. The findings obtained from these studies are very important for network operators who must assess the impact of PDL on the network reliability. The three different PDL measurement methods (JME, OSA and polarization scrambling) were compared and their PDL values were found to agree very well at the selected wavelength of 1550 nm. Concatenation of PDL components showed that as expected, PDL increase as the number of PDL components were added. The interactions between PMD and PDL measurements were analyzed. A PMD/PDL emulator was constructed. We observed that PMD decreased while PDL increased. The PMD decrease was a result of the PMD vector cancellation enhanced by the randomly distributed mode coupling angles while PDL increase was a result of each PM fibre segments contributing to the overall global PDL. It was observed that the presence of PMD in a link containing PDL, results in PDL being wavelength dependent and this resulted in the extraction of the PMD information from the PDL data. PDL was found to be Maxwellian distributed when considering low values of PMD. High PMD values resulted in the PDL distribution deviating from Maxwellian. Long-term PDL and PMD (average DGD) measurements indicated that the PDL and PMD varied slowly with time and wavelength for both the laboratory and field measurements. It was observed that the BER increase as both PDL and PMD increased for simulated optical link.

Polarization mode dispersion (PMD) causes significant impairment in high bit-rate optical telecommunications systems. Knowledge of a fibre’s PMD mean value, and the relevant confidence interval, is essential for determining a fibre’s maximum allowable bit-rate. Various methods of confidence interval construction for time series data were tested in this dissertation using simulation. These included the autocovariance-matrix methods as suggested by Box and Jenkins, as well as the more practical and simpler batch means methods. Some of these methods were shown to be significantly better than the standard method of calculating confidence intervals for non time series data. The best of the tested methods were used on actual PMD data. The effect of using polarization scramblers was also tested.

In this study, two polarization effects, namely the state of polarization (SOP) and polarization mode dispersion (PMD) in optical fibre cable are investigated. The change in polarization effects introduces errors in optical fibre communication system. We find that the SOP drifts slowly in buried cables, and rapidly in aerial cables. This is because buried cables are located in a static environment, whereas aerial cables are exposed directly to a dynamic environment. The SOP change in aerial cable shows significant correlation with its environment (the global radiation, temperature and wind). The autocorrelation function (ACF) was not performed in buried cable, since they do not satisfy the ACF assumption, whereas in aerial cable it is found that the ACF of the SOP decorrelates quite quickly during the day. The 50 percent decorrelation time during the day and night are 9.6 and 30.4 minutes, respectively. During the day the properties of the optical fibre change rapidly as a result of the rapidly changing environmental conditions, whereas at night the environmental conditions change relatively slowly. Fast Fourier Transform (FFT) of the SOP fluctuations show discrete peaks, which corresponds to the wind induced vibrational frequency of the cable. The PMD fluctuations for undeployed and deployed aerial optical fibre cable are monitored using the generalized interferometric technique (GINTY). It is found that the PMD measured with polarization scrambling is more scattered but more reliable than the PMD measured without polarization scrambling. This is because the PMD obtained with polarization scrambling is averaged over different input and output (I/O) SOP pairs. For deployed aerial cable, it is found that the PMD measured without polarization scrambling fluctuates rapidly during high wind speed conditions. Furthermore, there is a correlation between the measured PMD and the change in temperature. It is found that the change in temperature has a stronger influence than the wind on the PMD of the optical fibre link.

The work presented in this dissertation is a comparative study of polarization mode dispersion (PMD) measurement performance where the fixed analyzer (FA) technique was built and tested for the first time in South Africa. Techniques involved in the study are: the Jones matrix eigenanalysis (JME), generalised interferometric technique (GINTY) and the FA technique, with a particular focus on the FA technique. The FA PMD measurement technique determines the average differential group delay (DGD) from the transmitted intensity spectrum through a polarizer and has three analysis methods (extrema counting, mean level crossing and Fourier analysis) which were all evaluated. PMD measurements were performed in the laboratory on several different fibre types and in the field on buried deployed Telkom fibre links (28.8 km). The techniques showed good agreement in the measured PMD value, both in the laboratory and field measurements. In particular very good agreement was found between the JME average DGD and the extrema counting analysis PMD value. The GINTY and FA Fourier analysis method also gave very similar PMD values. It was found that the fibre birefringence and the mode coupling manifest in different ways on the intensity spectrum. By using the FA ratio method, the length regimes of the different fibre types were determined. Three characteristics of the FA technique were investigated, namely: wavelength window variation, sampling and input SOP scrambling. It was found that the wavelength window and the PMD are inversely proportional. Correct sampling plays a significant role in determining the correct measured PMD value. Lastly an average PMD value over the PMD values for different input SOPs serves as a better representation of the true PMD value. An additional study showed that the FA technique and a developed Poincaré sphere analysis method agree very well regarding the PMD value.

In this study, the generalized and traditional interferometric techniques (GINTY and TINTY) are used to investigate some of the important aspects of Polarization Mode Dispersion (PMD) phenomenon in optical fibres. Measurements of PMD and chromatic dispersion (CD) are performed on buried optical fibre cable in the Pretoria Telkom’s metropolitan network. The upgradeability of this network was investigated, and it was observed that just over a half of the fibres are upgradeable to 10 Gb.s-1 transmissions. Long-haul aerial network in the Northern Cape was also tested for upgradeability to 10 Gb.s-1. It was found that 41 percent of the fibres tested are upgradeable to 10 Gb.s-1. Long-term monitoring showed that PMD varies rapidly in aerial fibres and, on the other hand, it is relatively stable in buried cables. Investigations on the accuracy of the techniques showed that polarization scrambling is essential for the reduction of the measurements uncertainties. Furthermore, it was observed that TINTY underestimates the single scan PMD distributions. The study on the effect of the change in mode coupling on various fibre configurations was performed, and fibres showed a reduction in PMD after the introduction of mode coupling. Measurements of PMD conducted in the laboratory on cabled fibre with low PMD showed the floor sensitivity of TINTY. Comparison between GINTY and Jones Matrix Eigeanalysis (JME) PMD measurements methods were performed on an emulator, and the results showed a good agreement in the measured PMD.