<p> This thesis focuses on the thermal plasma treatment of non-point source pollutants accumulating in stormwater ponds. Stormwater ponds are constructed as a part of urban non-point source pollution control systems. Pollutants from various sources are collected in the stormwater ponds as sediments. In this work, stormwater sediments were first separated by a filter with an opening of 208μm. The filtered sludge-water was subjected to pulsed arc electrohydraulic discharge (PAED) treatment while the solid part (i.e., wet sludge and dried PAED treated sludge) was subjected to thermal plasma treatment under non-DC transferred and partial transferred operation modes. The results from the PAED sludge-water treatment show that the reduction of TOC in sludge-water was approximately 80% and was greater than 90%, respectively, after 5 minutes and 2 hours of PAED treatment. The accumulated gaseous concentrations of CxHy, CO, C02, S02, H2S and NO emission from sludge-water treatment were 8.2, 3.1, 1.9, 0.32, 0.29 and 0.07 mg/L, respectively, after 2 hours of PAED treatment. The concentrations of volatile elements in sediments such as S, Br, Cl and K decreased approximately 80, 90, 30 and 20% respectively. The solid-phase carbon was observed to be approximately completely removed after treatment. Based on the above results, it can be concluded that PAED successfully degraded organic compounds into C02, CO and CxHy, and converted sulfur and nitrate compounds into S02, HzS and NO. </p> <p> Thermal plasma wet-sludge treatments showed that a reduction of TOC was approximately 52% with argon plasma gas and air flow rates (in the reaction zone) of 24 and 2.4 L/min, respectively. Based on SEM images, wet sludge was melted under partial transferred mode. Thirteen elements with concentration relationships of 0 > Si > Al > Ca > S >Fe> K > Mg > Na > Cu > C > Ti > Cl were quantified by the X-ray energy dispersion technique. The elemental weight percentages of Si, K, Fe and 0 increased with increasing reaction zone air flow rate, while Ca and Cu decreased with increasing air flow rate. Thirty two elements were quantified by Neutron Activation Analyses (NAA) but only 27 elements were above the detection limits. Major elements (concentration> 1000 ppm) with relative concentrations of Ca > Al >Fe> K > Mg > Na > Ti > Cl; minor elements (100 - 1000 ppm) with relative concentrations of Mn > Ba > Sr > Zn; and trace elements(< 100 ppm) with relative concentration were Mo > V > Cr > Br >La> As > Sc > Th> As > Co > Dy > W > Sb > Eu; were determined. Concentrations of Zn, La and Co were enriched 90, 50 and 30% on average respectively, while concentrations of Br, W and As decreased by 80, 50 and 20% on average respectively. The chemical compositions in sludge were quite different after thermal plasma treatment. The average percentages of sand (Si02) and calcite (CaC03) decreased 35 and 10% respectively, while compounds such as KAlSi08, Fe304, NaCl and CaS04 were formed after thermal plasma treatment. Gaseous hydrocarbons, H2S, CO and NO were emitted continuously during the thermal plasma treatment of sludge. Higher reduction of organics and sulfur compounds and suppression of NOx formation were observed in the thermal plasma treatment of wet sludge. The integrated system consisting of PAED sludge-water treatment and thermal plasma wet sludge treatment under partial transferred mode may provide a potential for stormwater pond sediment treatment control. </p> / Thesis / Doctor of Philosophy (PhD)

The dissertation deals with clogging of reservoirs and ponds by redundant sediments which penetrate water system by erosion. It describes methods of extracting pond sediments. It contains measurement of dewatering of sediments on hydrocyclone and design of laboratory hydrocyclone and filter unit. In the conclusion there is design of technology of dewatering sediments which were extracted by wet method by drainage excavator. Numerical simulation of flowing in hydrocyclones is simulated in the CFX programme and dewatering technology is simulated in the CHEMCAD programme.

This thesis is a study of naturally occurring radioactive materials (NORM) activity concentration, gamma dose rate and radon (222Rn) exhalation from the waste streams of large-scale onshore petroleum operations. Types of activities covered included; sludge recovery from separation tanks, sludge farming, NORM storage, scaling in oil tubulars, scaling in gas production and sedimentation in produced water evaporation ponds. Field work was conducted in the arid desert terrain of an operational oil exploration and production region in the Sultanate of Oman. The main radionuclides found were 226Ra and 210Pb (238U - series), 228Ra and 228Th (232Th - series), and 227Ac (235U - series), along with 40K. All activity concentrations were higher than the ambient soil level and varied over several orders of magnitude. The range of gamma dose rates at a 1 m height above ground for the farm treated sludge had a range of 0.06 0.43 µSv h 1, and an average close to the ambient soil mean of 0.086 ± 0.014 µSv h 1, whereas the untreated sludge gamma dose rates had a range of 0.07 1.78 µSv h 1, and a mean of 0.456 ± 0.303 µSv h 1. The geometric mean of ambient soil 222Rn exhalation rate for area surrounding the sludge was mBq m 2 s 1. Radon exhalation rates reported in oil waste products were all higher than the ambient soil value and varied over three orders of magnitude. This study resulted in some unique findings including: (i) detection of radiotoxic 227Ac in the oil scales and sludge, (ii) need of a new empirical relation between petroleum sludge activity concentrations and gamma dose rates, and (iii) assessment of exhalation of 222Rn from oil sludge. Additionally the study investigated a method to determine oil scale and sludge age by the use of inherent behaviour of radionuclides as 228Ra:226Ra and 228Th:228Ra activity ratios.