Distribution system analysis and design has experienced a gradual development over the past three decades. The once loosely assembled and largely ad hoc procedures have been progressing toward being well-organized. The increasing power of computers now allows for managing the large volumes of data and other obstacles inherent to distribution system studies. A variety of sophisticated optimization methods, which were impossible to conduct in the past, have been developed and successfully applied to distribution systems. Among the many procedures that deal with making decisions about the state and better operation of a distribution system, two decision support procedures will be addressed in this study: phase balancing and phase prediction. The former recommends re-phasing of single- and double-phase laterals in a radial distribution system in order to improve circuit loss while also maintaining/improving imbalances at various balance point locations. Phase balancing calculations are based on circuit loss information and current magnitudes that are calculated from a power flow solution. The phase balancing algorithm is designed to handle time-varying loads when evaluating phase moves that will result in improved circuit losses over all load points. Applied to radial distribution systems, the phase prediction algorithm attempts to predict the phases of single- and/or double phase laterals that have no phasing information previously recorded by the electric utility. In such an attempt, it uses available customer data and kW/kVar measurements taken at various locations in the system. It is shown that phase balancing is a special case of phase prediction. Building on the phase balancing and phase prediction design studies, this work introduces the concept of integrated design, an approach for coordinating the effects of various design calculations. Integrated design considers using results of multiple design applications rather than employing a single application for a distribution system in need of improvement relative to some system aspect. Also presented is a software architecture supporting integrated design. / Ph. D.

Indiana University-Purdue University Indianapolis (IUPUI) / This thesis proposes a family of non-isolated bidirectional converter in order to interface dc and ac variables. Such power electronics solutions guarantee: (i) bidirectional power flow between dc and ac converter sides, (ii) independent control in both converter sides, (iii) high level of integration with a reduction of one power switch and its drive circuits, (iv) implementation of two functions by using a unique power conversion stage and (v) reduction of the capacitor losses. Despite proposing new power converter solutions, this thesis presents an analysis of the converters in terms of pulse-width-modulation (PWM) strategy, dc-link capacitor variables, and suitable a control approach. Solutions for single-phase, three-phase and three-phase four-wire systems are proposed by employing a converter leg with three switches. A possible application of this converter is in Vehicle-to-Grid (V2G) systems and interfacing dc microgrid with a utility grid. In addition to the new power electronics converters proposed in this thesis, an experimental setup has been developed for validation of the simulated outcomes. The proof-of-concept experimental setup is constituted by: DSP, Drivers & Integrating Board, Power Supply and, Power Converter & Heat-Sink .