Spelling suggestions: "subject:"pulseduration modulation"" "subject:"burstduration modulation""
21 |
Design optimization of off-line power converters: from PWM to LLC resonant converteresYu, Ruiyang., 余睿阳. January 2012 (has links)
High power conversion efficiency is desirable in power supplies. Design optimization of on-line power converter is presented in this thesis.
High efficiencies over a wide load range, for example 20%, 50% and 100% load, are often required. It is a challenge for on-line pulse-width modulation (PWM) converters to maintain good efficiencies with light load as well as full load. A two-stage multi-objective optimization procedure is proposed to optimization power converter efficiencies at 20%, 50% and 100% load. Two-FET forward prototype converters are built to verify the optimization results.
The LLC (abbreviation of two resonant inductor L and one resonant capacitor C ) series resonant converter can provide high power conversion efficiency because of the resonant nature and soft switching. The design of LLC resonant converter is more difficult than that of PWM converters since the LLC resonant converter has many resonant modes. Furthermore, the LLC resonant converter does not have analytical solution for its resonant operation. In this thesis, a systematic optimization procedure is proposed to optimize LLC series resonant converter efficiency. A mode solver technique is developed to solve LLC resonant converter operations. The proposed mode solver employs non-linear programming techniques to solve a set of LLC state equations and determine the resonant modes. Loss models are provided which serve as the objective-function to optimize converter efficiency. Optimization results show outstanding efficiency performance and experimental agreement with optimization.
The optimization work extends to the LLC resonant converter with power factor correction (PFC) circuits where the effect of LLC converter input voltage variation cased by the PFC circuit is considered.
Detail comparisons of PWM converter and LLC resonant converter loss profiles are also presented. The reasons that LLC resonant converter has higher efficiency are given and supported by quantitative data. Converter lifetime is highly related to component losses and temperature. The lifetime analysis is presented. The analysis reveals that the LLC resonant converter output capacitor is the weakest component concerning life. / published_or_final_version / Electrical and Electronic Engineering / Doctoral / Doctor of Philosophy
|
22 |
Adjustable speed drive bearing fault detection via support vector machine incorporating feature selection using genetic algorithmTeotrakool, Kaptan, January 2007 (has links)
Thesis (Ph. D.)--University of Missouri-Columbia, 2007. / The entire dissertation/thesis text is included in the research.pdf file; the official abstract appears in the short.pdf file (which also appears in the research.pdf); a non-technical general description, or public abstract, appears in the public.pdf file. Title from title screen of research.pdf file (viewed on March 3, 2008) Vita. Includes bibliographical references.
|
23 |
Evaluation and DSP based implementation of PWM approaches for single-phase DC-AC converters.Zhou, Lining. Chang, Jie. January 2005 (has links)
Thesis (M.S.)--Florida State University, 2005. / Advisor: Dr. Jie Chang, Florida State University, FAMU-FSU College of Engineering, Dept. of Electrical and Computer Engineering. Title and description from dissertation home page (viewed June 9, 2005). Document formatted into pages; contains xiii, 76 pages. Includes bibliographical references.
|
24 |
Digital control of pulse width modulated inverters for high performance uninterruptible power suppliesMarwali, Mohammad Nanda Rahmana, January 2004 (has links)
Thesis (Ph. D.)--Ohio State University, 2004. / Title from first page of PDF file. Document formatted into pages; contains xviii, 224 p.; also includes graphics. Includes bibliographical references (p. 199-211).
|
25 |
Digital pixel sensor (DPS) array based on pulse width modulation (PWM) scheme /Yung, Yat Fong. January 2004 (has links)
Thesis (M. Phil.)--Hong Kong University of Science and Technology, 2004. / Includes bibliographical references. Also available in electronic version. Access restricted to campus users.
|
26 |
Three-phase power conversion using soft-switching PWM techniquesVlatkovic, Vlatko 21 October 2005 (has links)
This dissertation addresses several key issues related to high-frequency soft-switching PWM three-phase power converters. These are:
1. Analysis, synthesis, and design of three-phase soft-switching PWM power converter topologies
2. Design of input EMI filters for three-phase converters
3. Design of microprocessor controllers for three-phase converters.
An analysis of existing soft-switching PWM techniques is performed, and two generalized soft-switching PWM converter circuit representations are derived.
Based on these representations and common topological properties of three-phase and dc-dc PWM converters, two new procedures for synthesis of three-phase soft-switching PWM converters are derived. The two procedures are used to synthesize five new three-phase soft-switching PWM converter topologies suitable for wide range of applications.
A digital signal processor-based controller implementation example is presented. It demonstrates the feasibility of producing versatile, high performance, reliable, low-cost digital controllers for soft-switching PWM three-phase power converters operating at high switching frequencies.
A new approach to the design of input filters for ac power electronic circuits is presented here. This approach is based on the application of a vast body of knowledge about passive L-C filters that has existed for many years, but has not been used in power electronics. New passive and active filter pole damping schemes are applied to high-order elliptic filters, resulting in significant filter size reduction compared to the standard filter designs. / Ph. D.
|
27 |
A pulse-width-modulated controlled-transformer post regulatorSun, Ning 24 January 2009 (has links)
The theory of operation of a controlled transformer is described. A PWM controlled transformer is proposed and implemented in a forward converter to provide post regulation. Experimental results are presented to verify the new control scheme. Overall efficiency of 82%-86% is achieved in a 200khz, 500-watt, 5V-output off-line regulator. A discussion of design issues of the controlled transformer is also presented. / Master of Science
|
28 |
A numerical procedure for computing errors in the measurement of pulse time-of-arrival and pulse-widthHaden, Lonnie A. January 2010 (has links)
Typescript (photocopy). / Digitized by Kansas Correctional Industries
|
29 |
Numerical alogrithms for PWM modulators.Green, Walter Battman. January 1989 (has links)
The development of a simple efficient Pulse Width Modulation (PWM) modulator has
been a goal for many research workers. In general three techniques have been used,
namely; the analogue triangular wave technique; the use of look-up tables, and the use of
Analogue to Digital converters together with analogue circuitry. The modulator
described in this thesis is based on an iterative numerical algorithm, and is thus
fundamentally different from all previous techniques. The algorithm is limited only by
the speed and precision of the associated digital circuitry and can achieve higher
modulating frequencies with greater accuracy than can be realised using any of the
methods that have previously been investigated. The use of high switching frequencies
simplifies the design of filters to reduce both unwanted harmonics and acoustic noise.
In this thesis, an equation of a multiphase digital oscillator is derived which is simple to
implement and will operate over a wide range of frequencies. The conditions for stable
oscillation are derived, and two classes of oscillator are developed. It is shown how the
frequency and amplitude of oscillations can be independently and continuously varied.
The errors in computing the amplitude and frequency are analysed, and are shown to be
cyclic. Upper bounds for the amplitude errors are derived.
Single and three phase PWM modulators are described and the implementation
procedures for their practical realisation are developed. Two specific implementations of
the algorithm are investigated and experimental results confirm theoretical analyses.
The algorithm can be incorporated in the Space Vector Modulation (SVM) method of
PWM, to improve the resolution at low speeds and to enable the SVM technique to be
applied at high gear ratios.
A 3-phase 16-bit PWM modulator was built and operated satisfactorily with a pulse
switching frequency of 20 kHz and an output frequency range of 1000:1. / Thesis (Ph.D.)-University of Natal, Durban, 1989.
|
30 |
Computer controlled generation of PWM waveform using harmonic distortion minimization schemeDalvi, Mahesh. January 1997 (has links)
Thesis (M.S.)--Ohio University, June, 1997. / Title from PDF t.p.
|
Page generated in 0.1578 seconds