In the past decades, mobile traffic generated by devices such as smartphones, iphones, laptops and mobile gateways has been growing rapidly. While traditional direct connection techniques evolve to provide better access to the Internet, a new type of wireless network, mobile ad hoc network (MANET), has emerged. A MANET differs from a direct connection network in the way that it is multi-hopping and self-organizing and thus able to operate without the help of prefixed infrastructures. However, challenges such dynamic topology, unreliable wireless links and resource constraints impede the wide applications of MANETs. Routing in a MANET is complex because it has to react efficiently to unfavourable conditions and support traditional IP services. In addition, Quality of Service (QoS) provision is required to support the rapid growth of video in mobile traffic. As a consequence, tremendous efforts have been devoted to the design of QoS routing in MANETs, leading to the emergence of a number of QoS support techniques. However, the application independent nature of QoS routing protocols results in the absence of a one-for-all solution for MANETs. Meanwhile, the relative importance of QoS metrics in real applications is not considered in many studies. A Best Effort QoS support (BEQoS) routing model which evaluates and ranks alternative routing protocols by considering the relative importance of multiple QoS metrics is proposed in this thesis. BEQoS has two algorithms, SAW-AHP and FPP for different scenarios. The former is suitable for cases where uncertainty factors such as standard deviation can be neglected while the latter considers uncertainty of the problems. SAW-AHP is a combination of Simple Additive Weighting and Analytic Hierarchical Process in which the decision maker or network operator is firstly required to assign his/her preference of metrics with a specific number according to given rules. The comparison matrices are composed accordingly, based on which the synthetic weights for alternatives are gained. The one with the highest weight is the optimal protocol among all alternatives. The reliability and efficiency of SAW-AHP are validated through simulations. An integrated architecture, using evaluation results of SAW-AHP is proposed which incorporates the ad hoc technology into the existing WLAN and therefore provides a solution for the last mile access problems. The protocol selection induced cost and gains are also discussed. The thesis concludes by describing the potential application area of the proposed method. Fuzzy SAW-AHP is extended to accommodate the vagueness of the decision maker and complexity of problems such as standard deviation in simulations. The fuzzy triangular numbers are used to substitute the crisp numbers in comparison matrices in traditional AHP. Fuzzy Preference Programming (FPP) is employed to obtain the crisp synthetic weight for alternatives based on which they are ranked. The reliability and efficiency of SAW-FPP are demonstrated by simulations.

Quality of Service (QoS) routing considered as one of the major components of the QoS framework in communication networks. The concept of QoS routing has emerged from the fact that routers direct traffic from source to destination, depending on data types, network constraints and requirements to achieve network performance efficiency. It has been introduced to administer, monitor and improve the performance of computer networks. Many QoS routing algorithms are used to maximize network performance by balancing traffic distributed over multiple paths. Its major components include bandwidth, delay, jitter, cost, and loss probability in order to measure the end users' requirements, optimize network resource usage and balance traffic load. The majority of existing QoS algorithms require the maintenance of the global network state information and use it to make routing decisions. The global QoS network state needs to be exchanged periodically among routers since the efficiency of a routing algorithm depends on the accuracy of link-state information. However, most of QoS routing algorithms suffer from scalability problems, because of the high communication overhead and the high computation effort associated with marinating and distributing the global state information to each node in the network. The goal of this thesis is to contribute to enhancing the scalability of QoS routing algorithms. Motivated by this, the thesis is focused on localized QoS routing that is proposed to achieve QoS guarantees and overcome the problems of using global network state information such as high communication overhead caused by frequent state information updates, inaccuracy of link-state information for large QoS state update intervals and the route oscillating due to the view of state information. Using such an approach, the source node makes its own routing decisions based on the information that is local to each node in the path. Localized QoS routing does not need the global network state to be exchanged among network nodes because it infers the network state and avoids all the problems associated with it, like high communication and processing overheads and oscillating behaviour. In localized QoS routing each source node is required to first determine a set of candidate paths to each possible destination. In this thesis we have developed localized QoS routing algorithms that select a path based on its quality to satisfy the connection requirements. In the first part of the thesis a localized routing algorithm has been developed that relies on the average residual bandwidth that each path can support to make routing decisions. In the second part of the thesis, we have developed a localized delay-based QoS routing (DBR) algorithm which relies on a delay constraint that each path satisfies to make routing decisions. We also modify credit-based routing (CBR) so that this uses delay instead of bandwidth. Finally, we have developed a localized QoS routing algorithm for routing in two levels of a hierarchal network and this relies on residual bandwidth to make routing decisions in a hierarchical network like the internet. We have compared the performance of the proposed localized routing algorithms with other localized and global QoS routing algorithms under different ranges of workloads, system parameters and network topologies. Simulation results have indicated that the proposed algorithms indeed outperform algorithms that use the basics of schemes that currently operate on the internet, even for a small update interval of link state. The proposed algorithms have also reduced the routing overhead significantly and utilize network resources efficiently.

Quality of Service (QoS) routing considered as one of the major components of the QoS framework in communication networks. The concept of QoS routing has emerged from the fact that routers direct traffic from source to destination, depending on data types, network constraints and requirements to achieve network performance efficiency. It has been introduced to administer, monitor and improve the performance of computer networks. Many QoS routing algorithms are used to maximize network performance by balancing traffic distributed over multiple paths. Its major components include bandwidth, delay, jitter, cost, and loss probability in order to measure the end users¿ requirements, optimize network resource usage and balance traffic load. The majority of existing QoS algorithms require the maintenance of the global network state information and use it to make routing decisions. The global QoS network state needs to be exchanged periodically among routers since the efficiency of a routing algorithm depends on the accuracy of link-state information. However, most of QoS routing algorithms suffer from scalability problems, because of the high communication overhead and the high computation effort associated with marinating and distributing the global state information to each node in the network.The goal of this thesis is to contribute to enhancing the scalability of QoS routing algorithms. Motivated by this, the thesis is focused on localized QoS routing that is proposed to achieve QoS guarantees and overcome the problems of using global network state information such as high communication overhead caused by frequent state information updates, inaccuracy of link-state information for large QoS state update intervals and the route oscillating due to the view of state information. Using such an approach, the source node makes its own routing decisions based on the information that is local to each node in the path. Localized QoS routing does not need the global network state to be exchanged among network nodes because it infers the network state and avoids all the problems associated with it, like high communication and processing overheads and oscillating behaviour. In localized QoS routing each source node is required to first determine a set of candidate paths to each possible destination. In this thesis we have developed localized QoS routing algorithms that select a path based on its quality to satisfy the connection requirements. In the first part of the thesis a localized routing algorithm has been developed that relies on the average residual bandwidth that each path can support to make routing decisions. In the second part of the thesis, we have developed a localized delay-based QoS routing (DBR) algorithm which relies on a delay constraint that each path satisfies to make routing decisions. We also modify credit-based routing (CBR) so that this uses delay instead of bandwidth. Finally, we have developed a localized QoS routing algorithm for routing in two levels of a hierarchal network and this relies on residual bandwidth to make routing decisions in a hierarchical network like the internet. We have compared the performance of the proposed localized routing algorithms with other localized and global QoS routing algorithms under different ranges of workloads, system parameters and network topologies. Simulation results have indicated that the proposed algorithms indeed outperform algorithms that use the basics of schemes that currently operate on the internet, even for a small update interval of link state. The proposed algorithms have also reduced the routing overhead significantly and utilize network resources efficiently.

QoS routing is one of the major building blocks for supporting QoS in communication networks and, hence, a necessary component of future communication networks. Bandwidth- Constrained Routing Algorithm (BCRA) may help to satisfy QoS requirements such as end-to-end delay, delay-jitter etc when WFQ-like (Weighted Fair Queuing) scheduling mechanisms are deployed. The existing algorithms for bandwidth constrained routing suffer from high message overhead and have a high computational and space complexity. The work presented in the thesis, therefore, focuses on the different techniques that an be used to reserve bandwidth for a unicast connection with low protocol overhead in terms of number of messages. We have compared the performance of the proposed routing algorithms using simulation studies with other bandwidth constrained routing algorithms. The call blocking ratio and message overhead have been used as the performance metric to compare the proposed algorithm with the existing ones. We present three source routing algorithms for unicast connections satisfying the band- width requirement. The first two routing algorithms are based on the partitioning of the network. The link-state broadcasts are limited to the partition. In the first algorithm, the source node queries the other partitions for the state information on a connection request and computes the path based on the information received from the other partitions. The second algorithm is based on state aggregation. The aggregated state of other partitions is maintained at every node. The source node finds a feasible path based on the aggregated information. The path is expanded in every partition, if required, at the time of resource reservation. The third QoS routing algorithm uses the Distance Vector Tables to find a route for a connection. If the shortest path satisfies the bandwidth requirement, then it is selected; otherwise a random deviation is taken at the point where bandwidth requirement is not satisfied and shortest path algorithm is again followed. In all the three algorithms presented, the packets carry the entire path information to the destination node. Therefore, no per connection information is required to be maintained at the intermediate nodes. Simulation results indicate that the proposed algorithms indeed help educing the protocol overhead considerably, and at the same time they give comparable or better performance in terms of resource utilization across a wide range of workloads.