Power dividers are vital components and widely used in radio technology, such as antenna arrays, power amplifiers, multiplexers and mixers. A good example is the well-known Wilkinson power divider with its distinctive feeding network characteristics. A comprehensive review indicated that limited research is carried out in the area of planar multiport and reconfigurable power dividers in terms of the power levels between output ports. The main objectives of this work were to develop a small size power divider, a planer multi-output ports power divider and a power divider with a reconfigurable power division ratio. These power dividers were designed to operate over either an ultra-wideband frequency (3.1-10.6 GHz) or WLAN bands (2.4 or 5.2 GHz). A novel multi-layered topology solved the complexity of interconnecting isolation resistors by introducing an additional layer below the ground layer. The prototype was fabricated and tested to validate the results. The measurements and simulation were in good agreement. Finally, a novel uniplanar power divider with reconfigurable output power level difference was developed. The configurability feature was achieved by tuning the quarter wave transformer using one varactor diode. The power divider was applied to improve a full duplex system cancellation performance at the receiver element caused by interference from in-site transmitting antennas. This study investigated fixed power dividers, multi-output power dividers and reconfigurable power dividers. The measurements validated by the simulation results and applications proved the designed power dividers could be used in practical applications. / Higher Committee for Education Development (HCED), Iraq