No description available.

The purpose of this work was to make a proposal for input parts of receiver for band 430 to 440 MHz. A model of chosen semiconductor triode BFP540 was created in simulation software. Possibilities how to decrease consumption of this semiconductor triode, keeping the profit, were investigated through the simulation.In compromise consumption, keeping the profit of the amplifier - an optimal operating point for this semiconductor triode UCE = 1,2 V and IC = 2 mA was found. It was tested through the testing wiring with noise microstrips conformity. Ascertained knowledge was used for construction of tuner for UHF receiver. An operating point of input amplifier of UHF receiver was owing to power supply amplifier forced for bigger effectiveness to UCE = 2,65 V and IC = 2,0 mA. Suppression of mirror frequency is provided with Helix filter of the third order, because of intermediate frequency 10,7 MHz. Mixing on intermediate frequency is made again by semiconductor triode BFP540. Selectivity of receiver is provided with intermediate frequency crystal filter 10,7 MHz with bandwidth 15 kHz. Designed input part enables reception of SSB, FM and digital types of modulation.Bandwidth intermediate frequency exit is adapted to this request To receive particular modulation , it is necessary to complete intermediate frequency signal way with appropriate intermediate frequency filter.

The aim of this master thesis is to design a wireless system which would be primarily used for a control of stage lighting. Our idea is to establish wireless links, that will carry DMX512 protocol, between individual lighting devices based on wireless transceiver nRF2401A. The foundation of our project comes from a previous design, which was not completely suitable for a practical use because of its rather large proportions and a short RF range. The project resolves the issue of relatively short range coverage through the deployment of RF amplifier RF5722. In the same tme, it also takes into account other technical aspects such as the use of antenas with a higher gain, front-end circuits or increased transmission reliability through frequency hopping scheme. Proper attention is also given to a minimalization of the module dimensions by using SMD components and layout adjustements, so it would be possible to place the whole board inside XLR connector. Set of printed circuit boards with the specified characteristics, which is the expected outcome of our project, were designed with Eagle PCB design environment.

This diploma thesis deals with optimization of transmitter amplifier parameters for LoRaWAN network. The issue of optimization is first based on the conditions of ETSI EN 300 220, which takes into account the eventuality of interference the adjacent channels in the band. The optimizations are designed specifically for the Qorvo RF5110g integrated circuit, so that the amplifier meets the requirements of the above standard at the limit of the maximum allowed output power and also with respect to radio ecology.