No description available.

Title from PDF of title page (University of Missouri--Columbia, viewed on Feb 11, 2010). The entire thesis text is included in the research.pdf file; the official abstract appears in the short.pdf file; a non-technical public abstract appears in the public.pdf file. Dissertation advisor: Dr. Naz E. Islam Vita. Includes bibliographical references.

Thesis (Ph. D.)--Electrical and Computer Engineering, Georgia Institute of Technology, 2007. / Gordon L. Stuber, Committee Chair ; Guillermo Goldsztein, Committee Member ; Gregory D. Durgin, Committee Member ; John R, Barry, Committee Member ; Mary Ann Ingram, Committee Member.

Thesis (M.S. in Engineering Acoustics)--Naval Postgraduate School, March 2007. / Thesis Advisor(s): Andrés Larraza, Bruce C. Denardo. "March 2007." Includes bibliographical references (p. 63-64). Also available in print.

A transmission-line metamaterial design of a material-embedded electric line source radiating inside a ground recess is investigated. The media embedding the recessed line source are designed such that the embedded current creates the same radiation pattern as a line source over a flat conducting ground plane. Transmission-line metamaterial unit cell designs for the embedding media obtained from the transformation electromagnetics design technique are shown. The metamaterial design of the overall embedded source configuration is numerically tested using circuit simulations. It is shown that the embedded-source design creates the same radiation characteristics as the line source above a flat ground plane at the design frequency.

No description available.

This dissertation presents beamforming designs. Using novel techniques and methods, the performance of the beamforming is improved on dual-band, tri-band, flexible function, tunable function in THz, and dynamic controllability on incident wave.

No / Radiation efficiency of antennas is shown to be measurable by a modified radiometric technique where the antenna's physical temperature is varied, rather than the noise temperature of its surroundings. The method is accurate, flexible and much more convenient for routine use. A means of avoiding errors caused by temperature-dependent antenna impedance is described. The accuracy of the method is verified by measuring the radiation efficiency of a horn antenna with a 3 dB attenuator to simulate a 50% efficient antenna, and by using microstrip patch antennas, whose measured efficiencies compared well with values computed from a transmission-line model.

The modulated scattering technique is used in conjunction with a Software Defined Radio (SDR) dongle to obtain a software-based modulated signal output. SDR# is the software package used to get spectrum analysis of the modulated signal. A transmitter yagi antenna sends a 2.304GHz signal on to an antenna connected to a reflector coefficient modulator (700Hz) and the modulated waves are received by another yagi. The receiver yagi antenna is then connected to a frequency converter to convert a 2.304GHz signal to a 144MHz dongle input signal which finally puts the scattered output on computer software with a SDR dongle. The output has a center frequency with modulated spectral lines on either side of the measured frequency. Finally, antenna patterns are measured with different types of antennas by rotating the antennas and observing the baseband modulation sidebands.

Thesis (Ph. D.)--Ohio State University, 2006. / Title from first page of PDF file. Includes bibliographical references (p. 161-164).