Thesis (M.S.)--University of Missouri-Columbia, 2006. / The entire dissertation/thesis text is included in the research.pdf file; the official abstract appears in the short.pdf file (which also appears in the research.pdf); a non-technical general description, or public abstract, appears in the public.pdf file. Title from title screen of research.pdf file viewed on (February 23, 2006) Includes bibliographical references.

As a result of changes in design code requirement for wind loads, the increase in power demand, and the growing communication industry, many existing steel lattice transmission and communiction towers now require strengthening to meet increased load requirements. Various strengthening methods are being utilised by engineers in this area, with leg reinforcement being one of the most common methods. However, even though it has been used in practice for some time, there has been little reasearch done into its effectiveness, until this study. / Thesis (PhDCivilEngineering)--University of South Australia, 2008.

High frequency, HF (3 - 30 MHz), radio communications are greatly affected by ionospheric conditions. Both civilian and military users need reliable, real time propagation information to show at any time the feasibility of communicating to any part of the world on a particular frequency band. For this thesis, an automated receiving/monitoring station for the Northern California DX Foundation (NCDXF)/ International Amateur Radio Union (IARU) International Beacon Project was setup at the Hermanus Magnetic Observatory, HMO (34.42oS, 19.22oE) to monitor international beacons on 20 m, 17 m, 15 m, 12 m and 10 m bands. The beacons form a world wide multiband network. The task of monitoring the beacons was broken down into two steps. Initially the single band station, at 14.10 MHz, was installed and later it was upgraded to a multiband station capable of automatically monitoring all the five HF bands. The single band station setup involved the construction and installation of the half-wave dipole antenna, construction and installation of an HF choke balun; and the choice of Faros 1.3 as the appropriate monitoring software. The multiband monitoring station set-up involved the installation of an MFJ-1778 G5RV multiband antenna, construction and installation of a Communication Interface - V (CI-V) level converter and configuring the Faros 1.3 software to monitor the beacons on all five HF bands. Then a web page was created on the HMO space weather website (http://spaceweather.hmo.ac.za). Here, the real-time signal to noise ratio (SNR) and short path (SP)/long path (LP) plots are uploaded every 3 minutes, showing real time HF propagation conditions on the five HF bands. Historical propagation data are archived for later analysis. A preliminary data analysis was done to confirm the peration of the monitoring station. The archived data were analysed and compared to ICEPAC (Ionospheric Communications Enhanced Profile Analysis and Circuit) predictions. Results show that the real-time signal plots as well as the archive of historical signal plots, convey information on ropagation conditions to users in terms that are easy to interpret and understand.

Thesis (Ph. D.)--University of Missouri-Columbia, 2007. / The entire dissertation/thesis text is included in the research.pdf file; the official abstract appears in the short.pdf file (which also appears in the research.pdf); a non-technical general description, or public abstract, appears in the public.pdf file. Title from title screen of research.pdf file (viewed on February 29, 2008) Vita. Includes bibliographical references.