The recent demand for wireless transceivers has created a flurry of research into nontraditional receiver architectures. The homodyne receiver, because of its high degree of integration, low complexity and low power consumption, has surfaced a desirable alternative to the well-known heterodyne receiver. However, distortions such as gain and phase imbalance severely degrade the performance of the homodyne receiver. These imbalances, which are caused by impairments of the employed analog devices, are intensified because quadrature demodulation is performed at very high frequencies with a weak input signal. Thus, there exists a great need for low complexity techniques to compensate for these imbalances. In this thesis, we present a new, simplified method for the estimation and the correction of the gain and phase imbalances in a homodyne receiver. The estimation process is based upon carrier re-injection during idle periods of the mobile unit and thus requires only few additional analog components. This approach will be shown to yield tight estimates of the gain and the phase error. Additionally, the correction is performed in the digital domain and thus can be implemented on a digital signal processor. The effectiveness of this method is demonstrated via simulations of an IS-54 transceiver. IS-54 is the North American TDMA standard for dual-mode cellular systems. / Graduation date: 1998

Thesis (M. Eng.)--Carleton University, 2001. / Includes bibliographical references (p. 133-134). Also available in electronic format on the Internet.

Thesis (Ph. D.)--Ohio State University, 2006. / Title from first page of PDF file. Includes bibliographical references (p. 95-99).

Oscillator circuits are an integral component of wireless communications systems and are increasingly in demand. As such systems gain widespread use, price becomes a very important factor in the design process, and the design cycle must be optimized. This puts an increasing emphasis on the proficiency of oscillator design automation tools. At the same time, as the performance requirements of such systems are becoming more stringent, the required simulation complexity is also increasing. More specifically, high frequency selectivity and low phase noise require very high quality factor oscillators, which in turn negatively affect the convergence performance of current simulation techniques. This thesis proposes a new continuation method for improving the convergence of oscillator simulations and compares this method to some of the methods reported in the literature. The proposed approach does not require a very good initial guess in order to converge to a final solution.

Thesis(M.S.)--Auburn University, 2005. / Abstract. Vita. Includes bibliographic references.

No description available.

Thesis (M. Phil.)--Hong Kong University of Science and Technology, 2003. / Includes bibliographical references (leaves 59-61). Also available in electronic version. Access restricted to campus users.

Thesis (Ph. D.)--Carleton University, 2003. / Includes bibliographical references (p. 114-127). Also available in electronic format on the Internet.

Thesis (M. Eng.)--Carleton University, 1999. / Includes bibliographical references. Also available in electronic format on the Internet.

Yip Kim-fung. / Thesis (M.Phil.)--Chinese University of Hong Kong, 2002. / Includes bibliographical references (leaves 95-100). / Abstracts in English and Chinese. / Abstract --- p.I / Acknowledgement --- p.III / Table of Contents --- p.IV / Chapter Chapter 1 --- Introduction --- p.1 / Chapter 1.1 --- Motivation --- p.1 / Chapter 1.2 --- Objective --- p.6 / Chapter Chapter 2 --- Theory of Oscillators --- p.7 / Chapter 2.1 --- Oscillator Design --- p.7 / Chapter 2.1.1 --- Loop-Gain Method --- p.7 / Chapter 2.1.2 --- Negative Resistance-Conductance Method --- p.8 / Chapter 2.1.3 --- Crossed-Coupled Oscillator --- p.10 / Chapter Chapter 3 --- Noise Analysis --- p.15 / Chapter 3.1 --- Origin of Noise Sources --- p.16 / Chapter 3.1.1 --- Flicker Noise --- p.16 / Chapter 3.1.2 --- Thermal Noise --- p.17 / Chapter 3.1.3 --- Noise Model of Varactor --- p.18 / Chapter 3.1.4 --- Noise Model of Spiral Inductor --- p.19 / Chapter 3.2 --- Derivation of Resonator --- p.19 / Chapter 3.3 --- Phase Noise Model --- p.22 / Chapter 3.3.1 --- Leeson's Model --- p.23 / Chapter 3.3.2 --- Phase Noise Model defined by J. Cranincks and M Steyaert --- p.24 / Chapter 3.3.3 --- Non-linear Analysis of Phase Noise --- p.26 / Chapter 3.3.4 --- Flicker-Noise Upconversion Mechanism --- p.31 / Chapter 3.4 --- Phase Noise Reduction Techniques --- p.33 / Chapter 3.4.1 --- Conventional Tank Circuit Structure --- p.33 / Chapter 3.4.2 --- Enhanced Q tank circuit Structure --- p.35 / Chapter 3.4.3 --- Tank Circuit with parasitics --- p.37 / Chapter 3.4.4 --- Reduction of Up-converted Noise --- p.39 / Chapter Chapter 4 --- CMOS Technology and Device Modeling --- p.42 / Chapter 4.1 --- Device Modeling --- p.42 / Chapter 4.1.1 --- FET model --- p.42 / Chapter 4.1.2 --- Layout of Interdigitated FET --- p.46 / Chapter 4.1.3 --- Planar Inductor --- p.48 / Chapter 4.1.4 --- Circuit Model of Planar Inductor --- p.50 / Chapter 4.1.5 --- Inductor Layout Consideration --- p.54 / Chapter 4.1.6 --- CMOS RF Varactor --- p.55 / Chapter 4.1.7 --- Parasitics of PMOS-type varactor --- p.57 / Chapter Chapter 5 --- Design of Integrated CMOS VCOs --- p.59 / Chapter 5.1 --- 1.5GHz CMOS VCO Design --- p.59 / Chapter 5.1.1 --- Equivalent circuit model of differential LC VCO --- p.59 / Chapter 5.1.2 --- Reference Oscillator Circuit --- p.61 / Chapter 5.1.3 --- Proposed Oscillator Circuit --- p.62 / Chapter 5.1.4 --- Output buffer --- p.63 / Chapter 5.1.5 --- Biasing Circuitry --- p.64 / Chapter 5.2 --- Spiral Inductor Design --- p.65 / Chapter 5.3 --- Determination of W/L ratio of FET --- p.67 / Chapter 5.4 --- Varactor Design --- p.68 / Chapter 5.5 --- Layout (Cadence) --- p.69 / Chapter 5.6 --- Circuit Simulation (SpectreRF) --- p.74 / Chapter Chapter 6 --- Experimental Results and Discussion --- p.76 / Chapter 6.1 --- Measurement Setup --- p.76 / Chapter 6.2 --- Measurement results: Reference Oscillator Circuit --- p.81 / Chapter 6.2.1 --- Output Spectrum --- p.81 / Chapter 6.2.2 --- Phase Noise Performance --- p.82 / Chapter 6.2.3 --- Tuning Characteristic --- p.83 / Chapter 6.2.4 --- Microphotograph --- p.84 / Chapter 6.3 --- Measurement results: Proposed Oscillator Circuit --- p.85 / Chapter 6.3.1 --- Output Spectrum --- p.85 / Chapter 6.3.2 --- Phase Noise Performance --- p.86 / Chapter 6.3.3 --- Tuning Characteristic --- p.87 / Chapter 6.3.4 --- Microphotograph --- p.88 / Chapter 6.4 --- Comparison of Measured Results --- p.89 / Chapter 6.4.1 --- Phase Noise Performance --- p.89 / Chapter 6.4.2 --- Tuning Characteristic --- p.90 / Chapter Chapter 7 --- Conclusion and Future Work --- p.93 / Chapter 7.1 --- Conclusion --- p.93 / Chapter 7.2 --- Future Work --- p.94 / References --- p.95 / Author's Publication --- p.100 / Appendix A --- p.101 / Appendix B --- p.104 / Appendix C --- p.106