The research addresses the effect of diagonal and horizontal stiffeners on shear transfer in rigid frame square knees. Rigid frame square knees are an integral component of pre-manufactured metal building systems. This paper examined a more efficient design of the rigid frame square knee. Five full-scale laboratory tests on square knee joints were performed to verify the effects of a diagonal stiffener on shear transfer. Two frames were fabricated without diagonal stiffeners, and three frames were fabricated with 1/8- inch- thick diagonal stiffeners, not extending the full diagonal length of the knee web. Experimental results, coupled with a finite element analysis, are compared to AISC provisions in Section F4: shear yielding and shear buckling, and in Section G3: tension field action. This research shows that if diagonal stiffeners are needed, then thin, shortened diagonal stiffeners are sufficient to restrain shear buckling of the knee web until shear yielding occurs.

During the fabrication of solid electrical insulation, small cavities known as micro voids may form in the material. As electrical stress increases in this micro void, the breakdown probability also increases. This type of electrical breakdown is commonly known as partial discharge. Magnitudes of partial discharge currents are typically small but enough to cause degradation of the electrical insulation. To study degradation for fast-rise time voltage square pulse train, partial discharge measurement is needed. In current studies, partial discharge pulse widths have been measured in the range of nanoseconds. The best approach for measurement at ultra wide band frequencies is a bridge type measurement system, to reduce external noise and improve sensitivity to PD currents. The bridge configuration can be used with samples instead of one sample and one coupling capacitor. Identically created samples will have a close match for impedance and frequency response. This type of bridge also helps to reduce other sources of measured current such as the high displacement currents due to fast rise time square pulse voltage on the samples. Further improvement includes simultaneous measurements using a “linked” bridge configuration, where bridges share a common sample. A directly connected measurement current shunt should be used for high sensitivity with a uniform ultra wide band frequency response. Post-measurement digital signal processing (DSP) algorithms will perform the task of pulse discrimination and time delay from the pulse front. This research presents a method to improve the measurement of partial discharge when applied voltage is non-sinusoidal, with high frequency components. The improvements are apparent when square pulse voltage rise times are less than 50 ns. Ultra wide band measurements of physical samples will be performed for short time duration with a digital storage oscilloscope. A DSP algorithm is used to filter residual noise from the partial discharge current. The presented measurement technique for samples for this study is an original approach. Sample results demonstrate the effectiveness of the technique.

No description available.

No description available.

No description available.

No description available.

No description available.

No description available.

No description available.

No description available.