Spelling suggestions: "subject:"shear strength off soils"" "subject:"shear strength oof soils""
51 |
The influence of wetting on the dynamic properties of completely decomposed granite in Hong Kong /Chan, Man Yiu. January 2002 (has links)
Thesis (M. Phil.)--Hong Kong University of Science and Technology, 2002. / Includes bibliographical references (leaves 131-136). Also available in electronic version. Access restricted to campus users.
|
52 |
Soil property determination through a knowledge-based system with emphasis on undrained shear strength /Fung, Ho-tat. January 1997 (has links)
Thesis (Ph. D.)--University of Hong Kong, 1998. / Includes bibliographical references (leaves [213]-223).
|
53 |
Physical modeling of railroad ballast using the parallel gradation scaling technique within the cyclical triaxial frameworkSevi, Adam F. January 2008 (has links) (PDF)
Thesis (Ph. D.)--Missouri University of Science and Technology, 2008. / Vita. The entire thesis text is included in file. Title from title screen of thesis/dissertation PDF file (viewed June 1, 2009) Includes bibliographical references (p. 117-124).
|
54 |
Theoretical approach to quantify influence of inherent anisotropy on undrained steady state strength of sand /Ho, Man Lee. January 2005 (has links)
Thesis (M.Phil.)--Hong Kong University of Science and Technology, 2005. / Includes bibliographical references (leaves 131-136). Also available in electronic version.
|
55 |
The shearing effect of suction /Mui, Tak Sang. January 2005 (has links)
Thesis (M.Phil.)--Hong Kong University of Science and Technology, 2005. / Includes bibliographical references (leaves 178-182). Also available in electronic version.
|
56 |
Stiffness of unsaturated compacted clays at small strainsSalem, Manal Abdelsalam, January 1900 (has links) (PDF)
Thesis (Ph. D.)--University of Texas at Austin, 2006. / Vita. Includes bibliographical references.
|
57 |
Dynamic properties of an undisturbed clay from resonant column testsZavoral, Dan January 1990 (has links)
The dynamic properties of clay deposits under seismic or wave loading conditions must be well understood to assure dynamic stability of structures founded on such soil. The dynamic shear modulus and damping appear to be a complex function of many variables, and a wide range of values have been reported in the literature. Consequently, considerable uncertainty exists in choosing the appropriate values of shear modulus and damping for a particular problem.
This thesis presents a study of the influence of various factors on the shear modulus and damping of a marine clay using a resonant column/torsional shear device. In particular, the influence of factors such as shear strain amplitude, effective confining stress, stress history, frequency (strain rate), and secondary time-dependent behaviour are examined. The pore pressure response is also studied.
The shear modulus was found to degrade for shear strains above 0.005%. The strain dependency was found to be well represented by a single normalized modulus reduction curve regardless of the confining pressure or overconsolidation ratio. Slower strain rates resulted in smaller values of shear modulus.
Of the variables studied, the duration of sample confinement was found to be the most imporant factor affecting the material damping. Above 0.005% strain, the damping of the marine clay increased with shearing strain amplitude. No significant effect of confining pressure and stress history on damping was observed at any strain level. As well, the material damping was found to be relatively independent of loading frequency.
Both the shear wave velocity and damping obtained in this study were found to be consistent with the in situ values determined using the seismic cone penetration test. / Applied Science, Faculty of / Civil Engineering, Department of / Graduate
|
58 |
Effect of internal erosion on the mechanical behaviour of soilsMacRobert, Charles John January 2017 (has links)
A thesis submitted to the Faculty of Engineering and Built Environment, University of the Witwatersrand, Johannesburg, in fulfilment of the requirements for the Degree of Doctor of Philosophy, 2017 / The effect of internal erosion on the mechanical behaviour of soils was investigated experimentally, using sodium chloride grains as an analogue for erodible soil grains. With this technique, the loss of controlled quantities of finer particles could be simulated under more realistic hydro-mechanical conditions than in previous research, but within practical experimental time scales. Two experimental programs were undertaken. The first looked at general changes in volume and shear strength using a large diameter oedometer adapted to perform a punch test following salt dissolution. The second program investigated particular changes in volume and shear strength following salt dissolution using an adapted direct shear box
Previous studies have shown shear strength reductions following the loss of finer particles representing as little as 5 % of the total mass of the original soil. Findings here show shear strength can be largely unaffected if the erodible finer fraction (F) makes up less than a transition value (Ft) of approximately 10 – 15 % by mass of the original soil. This threshold represents F above which the coarser fabric is looser than at its minimum void ratio. As F increases further, finer particles increasingly hinder the coarser particles from achieving their densest packing, such that the coarser fabric remaining after finer particle loss is in a looser state than the original fabric, the remaining fabric reaching its maximum void ratio at a critical finer fraction (Fc) of approximately 25 – 35 %. For F < Fc, finer particle loss results in limited collapse of the coarser fabric and it was found that the state of this initial coarser fabric determines the shear behaviour of the soil following the loss of finer particles. The shear behaviour of initially dense specimens with F < Ft remained similar to that of a dense soil following finer particle loss, whereas shear behaviour of initially dense specimens with Ft < F < Fc approached that of a loose soil as F increased. Soils with higher internal filter ratios (D15c/D85f) were found to have higher values of Ft and Fc.
Soils with F > Fc, settled and weakened significantly following finer particle loss, reflecting the load-bearing role finer particles play in this case. This load bearing nature of the finer particles in soils with F > Fc decreases the risk of internal erosion. / CK2018
|
59 |
Consolidated-drained shear-strength of unsaturated soilLacoul, Sriranjan. January 1986 (has links)
No description available.
|
60 |
Reconstruction, characterization, modeling and visualization of inherent and induced digital sand microstructuresLu, Ye 15 November 2010 (has links)
Strain localization, the phenomenon of large shear deformation within thin zones of intensive shearing, commonly occurs both in-situ and in the laboratory tests on soils specimens. The intriguing mechanism of strain localization and how it will affect the general behavior of soil specimens have been investigated by many researchers. Some of the efforts have focused on finding the links between material properties (void space, fabric tensor) and mechanical behavior (stress, strain, volumetric strain). In the last ten years, several extensive studies have been conducted at Georgia Tech to investigate the mechanism of strain localization and link the microstructural properties with the engineering behavior of Ottawa sands. These studies have included 2-D and 3-D characterization of soil microstructures under either triaxial or biaxial shearing conditions. To extend and complement these previous studies, the current study focuses particularly on 3-D reconstruction, analysis and modeling of specimens of Ottawa sand subject to triaxial or biaxial loading. The 3-D microstructure of biaxial specimens was reconstructed using an optical microscopy based montage and serial sectioning technique. Based on the reconstructed 3-D digital volumes, a series of 2-D and 3-D characterizations and analyses, including local void ratio distributions, extent of shear bands, influence of soil fabrics and packing signature effects, were conducted. In addition to the image analysis based reconstruction and characterization, the 3-D discrete element method (DEM) code, PFC3D, was used to explore both biaxial and triaxial shear related soil behaviors at the global and particulate scale. Void ratio distributions, coordination numbers, particle rotations and displacements, contact normal distributions and normal contact forces as well as global stress and strain responses were investigated and analyzed to help understand the mechanism of strain localization. The microstructures of the numerical specimens were also characterized in the same way as the physical specimens and similar strain localization patterns were identified. Combined with the previous related studies, the current study provides new insights into the strain localization phenomenon of Ottawa sands subject to triaxial and biaxial loading. In addition, the reconstructed digital specimens were subject to a series of dissection studies which revealed exciting new insights into "microstructure signatures" which exist at both meso and micro scales within the real and simulated specimens.
|
Page generated in 0.092 seconds