The latest generation of fighter aircraft utilizes a 270Vdc power system [1]. Such high voltage DC power systems are difficult to protect with conventional circuit breakers because the current does not automatically go to zero twice per cycle during a fault like it does in an AC power system and thus arcing of the contacts is a problem. Solid state power controllers (SSPCs) are the solid state equivalent of a circuit breaker that do not arc and which can respond more rapidly to a fault than a mechanical breaker [2]. Present SSPCs are limited to lower voltages and currents by the available power semiconductors [8,9]. This dissertation presents design and experimental results for a SSPC that utilizes SiC power JFETs for the SSPC power switch to extend SSPC capability to higher voltages and currents in a space that is smaller than what is practically achievable with a Si power switch. The research started with the thermal analysis of the SSPCs power switch, which will guide the development of a SiC JFET multi-chip power module to be fabricated by Solid State Devices Inc. (SSDI) using JFETs from SiCED and/or Semisouth LLC. Multiple multi-chip power modules will be paralleled to make the SSPC switch. Fabricated devices were evaluated thermally both statically and dynamically and electrically both statically and dynamically. In addition to the SiC module research a detailed design of the high voltage SSPC control circuit capable of operating at 200andamp;ordm;C was completed including detailed analysis, modeling and simulations, detailed schematic diagrams and detailed drawings. Finally breadboards of selected control circuits were fabricated and tested to verify simulation results. Methods for testing SiC JFET devices under transient thermal conditions unique to the SSPC application was also developed.

This paper studies the possibility of building a modular multilevel converter (M2C) using silicon carbide (SiC) switches. The main focus is on a theoretical investigation of the conduction losses of such a converter and a comparison to a corresponding converter with silicon-insulated gate bipolar transistors. Both SiC BJTs and JFETs are considered and compared in order to choose the most suitable technology. One of the submodules of a down-scaled 3 kVA prototype M2C is replaced with a submodule with SiC JFETs without antiparallel diodes. It is shown that the diode-less operation is possible with the JFETs conducting in the negative direction, leaving the possibility to use the body diode during the switching transients. Experimental waveforms for the SiC submodule verify the feasibility during normal steady-state operation. The loss estimation shows that a 300 MW M2C for high-voltage direct current transmission would potentially have an efficiency of approximately 99.8% if equipped with future 3.3 kV 1.2 kA SiC JFETs. / © 2011 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works.QC 20111220