Small amounts of cementation in a sand increase its ability to sustain static and dynamic loads, even in a liquefaction type environment. This has been shown in previous research examining the behavior of both naturally cemented and artificially prepared samples. Cemented sands are present in many parts of the world and can be caused by either a variety of cementing agents or by cold welding at points of grain contact. They are generally quite difficult to sample, but artificially cemented sands have been shown to aptly model the behavior of natural materials, and allow for better test controls. Consequently, artificial samples were used exclusively for the present investigation which has three major objectives: to investigate the effects of a weakly cemented lens within a stronger mass; to determine how cementation affects the volume change characteristics of statically loaded samples; and, to describe the pore pressure generation of sands subjected to cyclic loading. Prior to commencing the test program, a number of index tests were performed on the uncemented and cemented sand used during the laboratory investigation. It was revealed that cementation leads to increased void ratios which distort relative density calculations used to compare cemented and uncemented samples of similar dry unit weight. The practice of identifying samples by dry unit weight was adopted for this report. Static triaxial compression tests were performed on 17 samples. Test results indicate that although the magnitude of volumetric strain at failure does not seem to be dictated by the level of cementation, there is a relationship with cementation and the rate of volume change at failure. A weak lens was seen to lower the static strength of the stronger mass. 26 stress controlled cyclic triaxial tests revealed that a weak lens lowers the liquefaction resistance of the stronger mass. The cyclic strength of the nonhomogeneous material, however, is higher than the independent strength of the weak lens. A weak lens has greater influence at relatively higher levels of cyclic stress. Pore pressure generation in cemented sands are seen to be controlled by strain. At shear strain levels below about 1%, cemented sands behave similarly to uncemented sands with pore pressures increasing more rapidly beyond that amount of strain. Consequently, pore pressure development during cyclic loading is described by a broken-back curve which is defined in the early stages by existing empirical relationships for uncemented sand. Pore pressure prediction may then be achieved using an equation for cemented sand, such as that developed in the present work. / Master of Science