Solar energy installations located in dry, arid regions chosen for their availability of sunlight often face the problem of dust accumulation, or "soiling", on their solar collector surfaces, requiring this dust to be cleaned regularly in order to maintain optimal power production. The electrodynamic screen (EDS) is a technology that can clean this dust off the surfaces of photovoltaic panels and concentrating solar power mirrors using no water and a minimum of power. The EDS is a series of conductive electrodes embedded between two thin dielectric layers, where voltages applied across the electrodes create a patterned electric field which directs the motion of charged dust particles off the EDS surface. As the dust in different desert regions across the world have different physical characteristics, a different set of design parameters is required for the optimal EDS for each region. This optimization work could be easily conducted using a computer model of the physics of an EDS and the dust it clears off its surface. In this thesis, a computer model of the EDS system is created using COMSOL Multiphysics. This model simulates the voltages applied across the electrodes and the resulting electric fields, and then use these to simulate the trajectories of the charged dust particles as they move across the EDS surface. This particle tracing work is validated using experimental data from high-speed camera trials and performance data for different EDS designs. This validation work shows both agreements and disagreements between the predicted and observed dust particle motion, and the beginnings of the investigation into this difference is presented. Finally, the ability to further develop this model for EDS design optimization is discussed.

abstract: Photovoltaic (PV) systems are one of the next generation's renewable energy sources for our world energy demand. PV modules are highly reliable. However, in polluted environments, over time, they will collect grime and dust. There are also limited field data studies about soiling losses on PV modules. The study showed how important it is to investigate the effect of tilt angle on soiling. The study includes two sets of mini-modules. Each set has 9 PV modules tilted at 0, 5, 10, 15, 20, 23, 30, 33 and 40°. The first set called "Cleaned" was cleaned every other day. The second set called "Soiled" was never cleaned after the first day. The short circuit current, a measure of irradiance, and module temperature was monitored and recorded every two minutes over three months (January-March 2011). The data were analyzed to investigate the effect of tilt angle on daily and monthly soiling, and hence transmitted solar insolation and energy production by PV modules. The study shows that during the period of January through March 2011 there was an average loss due to soiling of approximately 2.02% for 0° tilt angle. Modules at tilt anlges 23° and 33° also have some insolation losses but do not come close to the module at 0° tilt angle. Tilt anlge 23° has approximately 1.05% monthly insolation loss, and 33° tilt angle has an insolation loss of approximately 0.96%. The soiling effect is present at any tilt angle, but the magnitude is evident: the flatter the solar module is placed the more energy it will lose. / Dissertation/Thesis / M.S.Tech Engineering 2011