Spelling suggestions: "subject:"space time"" "subject:"space lime""
51 |
Performance Analysis of Maximal-Ratio Combining and Space-Time Block Codes with Transmit Antenna Selection over Nakagami-m Fading ChannelsChi, Zhanjiang January 2007 (has links)
Master of Engineering (Research) / The latest wireless communication techniques such as highspeed wireless internet application demand higher data rates and better quality of service (QoS). However, transmission reliability is still degraded by harsh propagation channels. Multiple-input multiple-output (MIMO) systems can increase the system capacity and improve transmission reliability. By transmitting multiple copies of data, a MIMO system can effectively combat the effects of fading. Due to the high hardware cost of a MIMO system, antenna selection techniques have been applied in MIMO system design to reduce the system complexity and cost. The Nakagami-m distribution has been considered for MIMO channel modeling since a wide range of fading channels, from severe to moderate, can be modeled by using Nakagami-m distribution. The Rayleigh distribution is a special case of the Nakagami-m distribution. In this thesis, we analyze the error performance of two MIMO schemes: maximal-ratio combining with transmit antenna selection (the TAS/MRC scheme) and space-time block codes with transmit antenna selection (the TAS/STBC scheme) over Nakagami-m fading channels. In the TAS/MRC scheme, one of multiple transmit antennas, which maximizes the total received signal-to-noise ratio (SNR), is selected for uncoded data transmission. First we use a moment generating function based (MGF-based) approach to derive the bit error rate (BER) expressions for binary phase shift keying (BPSK), the symbol error rate (SER) expressions for M-ray phase shift keying (MPSK) and M-ray quadrature amplitude modulation (MQAM) of the TAS/MRC scheme over Nakagami-m fading channels with arbitrary and integer fading parameters m. The asymptotic performance is also investigated. It is revealed that the asymptotic diversity order is equal to the product of the Nakagami fading parameter m, the number of transmit antenna Lt and the number of receive antenna Lr as if all transmit antenna were used. Then a Gaussian Q-functions approach is used to investigate the error performance of the TAS/STBC scheme over Nakagami-m fading channels. In the TAS/STBC scheme, two transmit antennas, which maximize the output SNR, are selected for transmission. The exact and asymptotic BER expressions for BPSK are obtained for the TAS/STBC schemes with three and four transmit antennas. It is shown that the TAS/STBC scheme can provide a full diversity order of mLtLr.
|
52 |
ARQ techniques for MIMO communication systems /Ding, Zhihong, January 2006 (has links) (PDF)
Thesis (Ph. D.)--Brigham Young University. Dept. of Electrical and Computer Engineering, 2006. / Includes bibliographical references (p. 97-101).
|
53 |
Design and Implementation of an Object-Oriented Space-Time GIS Data ModelZhao, Ziliang 01 August 2011 (has links)
Geographic data are closely related to both spatial and temporal domains. Geographic information systems (GIS) can capture, manage, analyze, and display spatial data. However, they are not suitable for handling temporal data. Rapid developments of data collection and location-aware technologies stimulate the interests of obtaining useful information from the historical data. Researchers have been working to build various spatio-temporal data models to support spatio-temporal query. Nevertheless, the existing models exhibit weaknesses in various aspects. For instance, the snapshot model is plagued with data redundancy and the event-based spatio-temporal data model (ESTDM) is limited to raster dataset. This study reviews existing spatio-temporal data models in order to design an object-oriented space-time GIS data model that makes additional contributions to processing spatio-temporal data. A binary large object (BLOB) data type, labeled Space-Time BLOB, is added to ArcGIS geodatabase data model to store instantiated space-time objects. A Space-Time BLOB is associated with an array that contains the spatial and temporal information for an object at different time points and time intervals. This study also implements a space-time GIS prototype system, along with a set of spatio-temporal query functions, based on the proposed space-time GIS data model.
|
54 |
Low-complexity iterative receivers for multiuser space-time block coding systemsYang, Yajun 31 October 2006
Iterative processing has been shown to be very effective in multiuser space-time block coding (STBC) systems. The complexity and efficiency of an iterative receiver depend heavily on how the log-likelihood ratios (LLRs) of the coded bits are computed and exchanged at the receiver among its three major components, namely the multiuser detector, the maximum a posterior probability (MAP) demodulators and the MAP channel decoders. This thesis first presents a method to quantitatively measure the system complexities with floating-point operations (FLOPS) and a technique to evaluate the iterative receiver's convergence property based on mutual information and extrinsic information transfer (EXIT) charts.<p>Then, an integrated iterative receiver is developed by applying the sigma mappings for M-ary quadrature amplitude modulation (M-QAM) constellations. Due to the linear relationship between the coded bits and the transmitted channel symbol, the multiuser detector can work on the bit-level and hence improves the convergence property of the iterative receiver. It is shown that the integrated iterative receiver is an attractive candidate to replace the conventional receiver when a few receive antennas and a high-order M-QAM constellation are employed.<p> Finally, a more general two-loop iterative receiver is proposed by introducing an inner iteration loop between the MAP demodulators and the MAP convolutional decoders besides the outer iteration loop that involves the multiuser detection (MUD) as in the conventional iterative receiver. The proposed two-loop iterative receiver greatly improves the iteration efficiency. It is demonstrated that the proposed two-loop iterative receiver can achieve the same asymptotic performance as that of the conventional iterative receiver, but with much less outer-loop iterations.
|
55 |
Monorail: An Alternative Transportation Mode For MetuGokbulut, Alev 01 September 2003 (has links) (PDF)
The aim of this thesis is to investigate an alternative mode of transportation for METU and the impacts of spatial transformations generated by the proposed system in an
architectural context. This study embraces modern concepts of space-time in the practice of architectural design, and involves a sensitive consideration of the perception of space
relative to position, speed and movement. In an urban context, the thesis unfolds spatial transformations affected by new movement technology. While the notions of movement
and speed fundamentally shape the image of the contemporary city, METU campus will be reanalyzed within this framework.
|
56 |
Low-complexity iterative receivers for multiuser space-time block coding systemsYang, Yajun 31 October 2006 (has links)
Iterative processing has been shown to be very effective in multiuser space-time block coding (STBC) systems. The complexity and efficiency of an iterative receiver depend heavily on how the log-likelihood ratios (LLRs) of the coded bits are computed and exchanged at the receiver among its three major components, namely the multiuser detector, the maximum a posterior probability (MAP) demodulators and the MAP channel decoders. This thesis first presents a method to quantitatively measure the system complexities with floating-point operations (FLOPS) and a technique to evaluate the iterative receiver's convergence property based on mutual information and extrinsic information transfer (EXIT) charts.<p>Then, an integrated iterative receiver is developed by applying the sigma mappings for M-ary quadrature amplitude modulation (M-QAM) constellations. Due to the linear relationship between the coded bits and the transmitted channel symbol, the multiuser detector can work on the bit-level and hence improves the convergence property of the iterative receiver. It is shown that the integrated iterative receiver is an attractive candidate to replace the conventional receiver when a few receive antennas and a high-order M-QAM constellation are employed.<p> Finally, a more general two-loop iterative receiver is proposed by introducing an inner iteration loop between the MAP demodulators and the MAP convolutional decoders besides the outer iteration loop that involves the multiuser detection (MUD) as in the conventional iterative receiver. The proposed two-loop iterative receiver greatly improves the iteration efficiency. It is demonstrated that the proposed two-loop iterative receiver can achieve the same asymptotic performance as that of the conventional iterative receiver, but with much less outer-loop iterations.
|
57 |
Space-time forecasting and evaluation of wind speed with statistical tests for comparing accuracy of spatial predictionsHering, Amanda S. 2009 August 1900 (has links)
High-quality short-term forecasts of wind speed are vital to making wind power a
more reliable energy source. Gneiting et al. (2006) have introduced a model for the average
wind speed two hours ahead based on both spatial and temporal information. The
forecasts produced by this model are accurate, and subject to accuracy, the predictive distribution
is sharp, i.e., highly concentrated around its center. However, this model is split
into nonunique regimes based on the wind direction at an off-site location. This work both
generalizes and improves upon this model by treating wind direction as a circular variable
and including it in the model. It is robust in many experiments, such as predicting at new
locations. This is compared with the more common approach of modeling wind speeds and
directions in the Cartesian space and use a skew-t distribution for the errors. The quality
of the predictions from all of these models can be more realistically assessed with a loss
measure that depends upon the power curve relating wind speed to power output. This
proposed loss measure yields more insight into the true value of each model's predictions.
One method of evaluating time series forecasts, such as wind speed forecasts, is to
test the null hypothesis of no difference in the accuracy of two competing sets of forecasts. Diebold and Mariano (1995) proposed a test in this setting that has been extended and
widely applied. It allows the researcher to specify a wide variety of loss functions, and the
forecast errors can be non-Gaussian, nonzero mean, serially correlated, and contemporaneously
correlated. In this work, a similar unconditional test of forecast accuracy for spatial
data is proposed. The forecast errors are no longer potentially serially correlated but spatially
correlated. Simulations will illustrate the properties of this test, and an example with
daily average wind speeds measured at over 100 locations in Oklahoma will demonstrate
its use. This test is compared with a wavelet-based method introduced by Shen et al. (2002)
in which the presence of a spatial signal at each location in the dataset is tested.
|
58 |
Integration of Space-Time Coding and Complementary Code CDMA System: System Design and Theoretical AnalysisYeh, Yu-Ching 20 August 2004 (has links)
This thesis mainly focuses on the integration of Space-Time Block Coding (STBC) and Complementary Code based CDMA system. Our proposed integration systems have not only the merit of complementary code but also the extra advantage of diversity gain from STBC. Especially, when the different frequency channel gain has strong correlation, the complementary code will cancel most of interference.
We also present a lot of improved structures for our proposed systems. We utilize special filters in receiver such as Zero-Forcing filter and Turbo Filter to assist complementary code in canceling interference.
|
59 |
Integration of Space-Time Differential Coding and Complementary Code Based CDMALiu, Ming-Jiun 02 September 2006 (has links)
Differential space time block coding is a technology that combining traditional space time block coding and differential coding. Differential space time block coding could exploit full spatial diversity gain where the channel state information is not known. Each user in CC-CDMA system is assigned a fold of codes which sent via different carriers to reconstruct perfect auto-correlation and cross-correlation function. Complete Complementary codes could offer MAI-free and MI-free operation for DS-spreading. In this thesis we combine differential space time block coding and CC-CDMA, and discuss the character of the system.
|
60 |
Concatenated codes for the multiple-input multiple-output quasi-static fading channelGulati, Vivek 17 February 2005 (has links)
The use of multiple antennas at the transmitter and/or the receiver promises
greatly increased capacity. This can be useful to meet the ever growing demand
of wireless connectivity, provided we can find techniques to efficiently exploit the
advantages of the Multiple-Input Multiple-Output (MIMO) system.
This work explores the MIMO system in a flat quasi-static fading scenario. Such
a channel occurs, for example, in packet data systems, where the channel fade is constant
for the duration of a codeword and changes independently from one transmission
to another. We first show why it is hard to compute the true constrained modulation
outage capacity. As an alternative, we present achievable lower bounds to this capacity
based on existing space-time codes. The bounds we compute are the fundamental
limits to the performance of these space-time codes under maximum-likelihood decoding,
optimal outer codes and asymptotically long lengths. These bounds also indicate
that MIMO systems have different behavior under Gaussian signaling (unconstrained
input) and under the finite alphabet setting. Our results naturally suggest the use of
concatenated codes to approach near-capacity performance. However, we show that a
system utilizing an iterative decoder has a fundamental limit it cannot be universal
and therefore it cannot perform arbitrarily close to its outage limit.
Next, we propose two different transceiver structures that have good performance.
The first structure is based on a novel BCJR-decision feedback decoder which
results in performance within a dB of the outage limit. The second structure is based
on recursive realizations of space-time trellis codes and uses iterative decoding at the
receiver. This recursive structure has impressive performance even when the channel
has time diversity. Thus, it forms the basis of a very flexible and robust MIMO
transceiver structure.
|
Page generated in 0.5711 seconds