<p>An experimental investigation has been carried out in order to investigate the effect of surface initial conditions, concentration, nanoparticles size and deposition pattern on pool boiling and jet impingement boiling of nanofluids. A flat copper surface with initial conditions of Ra = 420 nm, Ra = 80 nm and Ra = 20 nm has been used as the boiling surface. Al₂O₃ and CuO nanoparticles have been used with de-ionized water to prepare the nanofluids. At 0.01 vol. % concentration of Al₂O_3, the rate of heat transfer enhanced by 41% and 34% for the Ra = 80 nm and Ra = 20 nm, respectively. While, in the case of Ra = 420 nm, the rate of heat transfer deteriorated by 49%. At 0.005 vol. % concentration the rate of heat transfer deteriorated for all three surfaces. It is believed that the deterioration was due to the uniformity of the deposition. Using 0.01 vol. % concentration of CuO nanofluids resulted in the same trend, however, the rate of heat transfer is less compared to using Al₂O₃nanofluids. For example, in the case of Ra = 80 nm, the rate of heat transfer was reduced by 14%.</p> <p>The effect of nanoparticles size has been investigated by changing the nanoparticles size from 50 nm to 10 nm. The change in nanoparticles size resulted in a significant deterioration in the rate of heat transfer for all three surfaces. It is believed that the deterioration was due to the deposition uniformity. As the deposition uniformity has been found to be a major factor that affects the rate of heat transfer, new approach was introduced to quantify the effect of the rate of deposition on the pool boiling of nanofluids.</p> <p>An experimental investigation has been carried out in order to investigate using submerged impingement jet on the rate of heat transfer using nanofluids. At of 0.005 vol. % concentration of Al₂O₃, surface with Ra = 80 nm, jet to surface vertical distance of 3 mm and Reynolds number of 101311, the rate of heat transfer deteriorated by 19%.</p> <p>Comparing the pool boiling and jet impingement boiling of nanofluids showed that, in the case of jet impingement boiling, the rate of heat transfer was enhanced compared to the case of pool boiling and the deposition was less. However, jet impingement boiling experiments showed deterioration in the rate of heat transfer by 19% compared with pure water.</p> / Master of Applied Science (MASc)