Graduation date: 1995

No description available.

In recent years, there has been increasing interest in the idea of using a superheated superconducting colloid (SSC) as a detector for neutrinos and dark matter candidates. The primary objective of this work has been to investigate the basic properties of an SSC, consisting of 7 μm radius tin grains imbedded in epoxy, using a pumped ⁴He cryostat with a low vibrational noise RF-SＱUID readout system. The superheating-supercooling hysteresis curves of the colloid have been measured in applied magnetic fields ranging from 3.1 x 10⁻⁴T to 1.4 x 10⁻²T. The superconducting to normal phase transition in individual grains inside the colloid has been observed and the measured signal size is in reasonable agreement with the calculated values. Finally, it was demonstrated that the colloid could withstand up to 20Mrad of [omitted]-radiation without incurring a significant change in its superconducting-normal phase transition. A new type of sample, consisting of a planar array of 1 μm thick metal squares deposited on a mylar substrate, was developed. Both indium and tin were used as a. fabrication material. The characteristics of such samples were investigated, again using the pumped ⁴He cryostat. The full Meissner effect was only observed for applied magnetic fields less than 5 x 10⁻⁵T. For higher applied fields, the samples behaved like type-[omitted] superconductors in the mixed state regime, exhibiting flux penetration and trapping. / Science, Faculty of / Physics and Astronomy, Department of / Graduate

Ballistic measurements were made of the critical magnetic fields of superconducting. cylinders of cerium-doped lead. Within the accuracy of our measurements, the introduction of the paramagnetic impurity, cerium, in lead has no effect other than a slight broadening of the transition. The samples, containing 0.00, 0.10, 1.0, and 1.5 atomic percent cerium in lead had been vacuum cast in pyrex tubes. The relative fractions of the cerium in these samples and their final purities were tested by the techniques of neutron activation analysis. / Master of Science

No description available.

A high resolution pressure gauge has been developed for use in thermodynamic measurements along the lambda line in liquid helium. The gauge was designed to operate at cryogenic temperatures and provide pressure measurements up to 30bar, with an accuracy of 3 × 10¯¹ºbar in a 1Hz bandwidth. Experiments reported here show the gauge to have met these specifications; at least for measurements close to zero pressure, at temperatures close to 4.5K. It is expected that operation at higher pressures, and at temperatures closer to the lambda transition, will result in similar or even improved performance. The gauge consists of a titanium-alloy diaphragm with a superconducting position transducer read-out. Compensation techniques internal to the superconducting circuit were used to eliminate any significant sensitivity to temperature fluctuations and in-line acceleration. For high values of common-mode rejection, thermal compensation revealed a non-linear temperature characteristic which was exploited to provide a further reduction in the temperature sensitivity. Acceleration compensation was achieved up to a common-mode rejection of more than 78dB. Present performance appears to be limited by thermal gradient fluctuations at low frequencies and at higher frequencies by a noise source which appears to originate beyond the superconducting transducer. It is expected that some further improvement may be gained in this higher frequency band simply by trapping a larger persistent current in the superconducting circuit. In the course of development and characterization of the gauge several anomalous effects were discovered and investigated. In response to changes in temperature, the gauge was found to exhibit irreversible behaviour in a variety of ways. These phenomena were fully investigated and found to be complex in nature. A critical state model was employed which was successful in explaining many of the observed effects. Other authors have observed apparently related behaviour in samples of niobium and some have developed similar critical state models which give results generally consistent with those reported here. However, these latter works have not investigated the presence of such effects within superconducting wires; neither have they considered the implications for devices based upon superconducting wire circuits. It appears this anomalous behaviour may be relevant to a broad range of instruments employing superconducting wire circuits similar to that used here. If this is the case, the results presented here have significant consequences for the performance of such devices