Issued also as the author's thesis, Zürich, 1933. / At head of title: Ouvrage publié sous les auspices du Laboratoire de Recherches Hydrauliques annexé à l'École Polytechnique Fédérale, à Zurich. "Bibliographie": p. [267]-268.

Ce mémoire de maîtrise présente le travail effectué pour concevoir et réaliser un canal hydrodynamique. Ce canal permettra un étalonnage rapide et précis de capteurs de frottement de type film chaud. Lors de ce projet, des simulations numériques ont été effectuées pour valider le rapport de forme et la longueur de développement du canal permettant d’atteindre un écoulement pleinement développé et bidimensionnel. Une étude structurelle et hydraulique du canal a ensuite permis de vérifier le respect du cahier des charges. Enfin, des mesures de vitesse dans la veine d’essai ont été effectuées à l’aide d’un système LDV. Les profils obtenus ont montré que l’écoulement peut être considéré pleinement développé et bidimensionnel dans cette zone. Cependant, quelques différences par rapport à la littérature et aux simulations numériques ont été détectées. L’étude de l’influence de certains paramètres a permis de déterminer des pistes d’amélioration pour une estimation plus précise du frottement. / This Master’s thesis presents the design of a hydraulic tunnel. The bench should allow calibrating wall shear stress hot-film probes easily and rapidly. During this project, 3D CFD simulations have been performed to find minimum aspect ratio and minimum length of development to reach 2D fully developed flow. Then, mechanical and hydraulic analyses have been carried out to determine if the design conforms to specifications. After manufacturing, velocity and pressure measurements have been performed respectively with a LDV system and differential pressure sensor. By comparing different velocity profiles, it has been confirmed that the flow in test section is 2D fully developed. However, some discrepancies with the literature and the CFD simulations have been detected. The study of some parameters allowed to determine possible causes for these differences and to propose future studies to improve wall shear stress estimation.

Pour combler l'écart entre l'augmentation de la demande énergétique et l'épuisement de la production d'hydrocarbures onshore, l'exploitation des hydrocarbures offshore est de plus en plus envisagée, en particulier les gisements de gaz / pétrole dans les eaux plus profondes. En attendant, un grand nombre d'unités de traitement déployées pour la production d'hydrocarbures doivent respecter les contraintes environnementales conçues pour la protection maritime. Les systèmes tels que les réacteurs et les épurateurs à lit fixe embarqués deviennent inévitablement l'une des options les plus prometteuses pour atteindre ces deux objectifs. De nombreux efforts dans la littérature pour dévoiler l'hydrodynamique de l'écoulement multiphasé dans les lits garnis révèlent que des défis persistent soit dans leur conception / mise à l'échelle, soit dans leurs opérations. De plus, exposer ces réacteurs à des conditions marines difficiles telles que la convolution de la dynamique des navires et de l'hydrodynamique à l'intérieur des réacteurs à lit fixe conduit à des situations encore plus compliquées pour maintenir des performances de fonctionnement acceptables dans les conditions flottantes. Un grand nombre de preuves issues de la littérature a jusqu'à présent mis en évidence l'échec des colonnes garnies avec des garnissages aléatoires, des garnissages structurés ou des mousses à alvéoles ouvertes, pour empêcher la maldistribution des liquides dans les lits fixes destinés à fonctionner à bord de navires ou de platesformes flottantes. Les efforts de recherche doivent donc se poursuivre dans le but de trouver des composants internes robustes et capables de résilience contre la maldistribution des liquides dans les réacteurs / unités de séparation gaz-liquide. Ce projet de doctorat s’est proposé des recherches visant dans un premier temps de tester des internes disponibles commercialement pouvant préserver des performances similaires à celles des unités terrestres classiques. Au meilleur de notre connaissance, la sensibilité et la susceptibilité des réacteurs monolithes à une mauvaise distribution soumis à des conditions offshore n'ont pas encore été étudiées. Plutôt que de se concentrer uniquement sur une étude des lits monolithiques, le chapitre 1 opte pour une campagne expérimentale plus large comprenant un garnissage aléatoire et un garnissage en mousse à cellules ouvertes pour des comparaisons systématiques de la distribution des liquides en conditions flottantes. La distribution liquide des colonnes embarquées garnies de divers garnissages et pour une large plage de débit gaz / liquide est systématiquement comparée à l'aide d'un capteur à treillis métallique (WMS) et d'un émulateur hexapode à six degrés de liberté. La vraisemblance de conditions météorologiques extracôtières rudes pourrait menacer la sureté de l'exploitation des lits fixes, en particulier dans des situations extrêmes telles que des cyclones, des épisodes d'icebergs, etc. Pour assurer la sécurité du personnel et des installations, l’opération des colonnes garnies à bord doit être immédiatement interrompue pour éviter des problèmes de sécurité critiques sous de telles circonstances. Par conséquent, la base de connaissances sur la dynamique de drainage des liquides dans les lits flottants est iv essentielle pour assurer une vidange rapide du liquide. Néanmoins, l'étude de la dynamique du drainage liquide des lits fixes en conditions flottantes est à tout le moins rare. Par conséquent, le chapitre 2 se propose de comparer expérimentalement le drainage du liquide dans des colonnes garnies dans les conditions marines à celui observé dans une colonne statique verticale à l’instar des applications terrestres. En dehors de cela, l'influence des mouvements du navire (par exemple, cavalement, embardée, pilonnement, roulis, tangage, et lacet) à différentes amplitudes et périodes d'oscillation sur la dynamique de drainage des liquides est étudiée pour approfondir nos connaissances. Parallèlement à l'étude expérimentale, un modèle numérique Euler-Euler transitoire et en trois dimensions est utilisé en complément pour tenter de prédire la dynamique du drainage des liquides dans les lits flottants. D'autres facteurs susceptibles d'affecter la dynamique de drainage sont analysés par la simulation numérique. Ainsi, le chapitre 3 met en évidence l'influence globale des propriétés des liquides, de la structure du lit et des types de mouvement associé à la sollicitation marine. Par ailleurs, la campagne expérimentale en fournissant des données mesurables a permis de valider le modèle dans les conditions de roulis et de tangage testées au laboratoire. / To fill the gap between increasing energy demand and depletion of onshore hydrocarbon production, offshore hydrocarbon exploitation is increasingly contemplated especially the gas/oil fields in the deeper water. Meantime, large amount of deployed processing units for hydrocarbon productions must comply with the environmental codes designated for maritime protection. Systems such as embarked packed-bed reactors and scrubbers inevitably become one of the most promising options to achieve both purposes. Numerous efforts in literature to unveil the hydrodynamics of multiphase flow in packed beds reveal that challenges persist either in their design/scale-up or during the operations. Moreover, exposing these reactors to harsh marine conditions such as the convolution of ship dynamics and hydrodynamics inside packed-bed reactors leads to even more complex situations to maintain the proper operation performance of packed-bed reactors under floating conditions. A lot of evidence from literature has pointed out the failure of random and structured packings and open-cell foams, to prevent liquid maldistribution in packed beds destined to operate on-board sailing ships and floating platforms. Research efforts must therefore continue in the quest for robust internals capable of resilience against liquid maldistribution in gas-liquid reactors/separation units. The proposed Ph.D. research aims at firstly following a sound path to adapt commercially existing internals being capable of preserving performance similar to landbased packed beds. To the best of literature exploring, the sensitivity and susceptibility of monolith reactors to maldistribution subjected to offshore conditions have yet to be investigated. Rather than focusing on a study of monolith beds alone, Chapter 1 opts for a broader experimental campaign including a random packing and an open-cell foam packing for the sake of systematic comparisons of the liquid distribution under floating conditions. Liquid distribution of embarked columns packed with various internals under wide gas/liquid flow range is systematically compared with the assistance of wire mesh sensor (WMS) and six-degree-of-freedom emulator hexapod. Severe offshore weather conditions threaten the operation safety of floating packed beds especially encountering extreme situations such as cyclone, iceberg episodes and so forth. To ensure the safety of staff and facilities, the onboard packed columns must be immediately shutdown to avoid critical safety concerns under such circumstances. Therefore, knowledgebase of liquid draining dynamics in floating packed beds is the essence to ensure timely discharge of liquid. Nevertheless, the study regarding liquid drainage dynamics of packed beds under floating conditions is scarce to say the least. Then, Chapter 2 compares liquid draining of packed columns embarking on floating platforms with static land-based one experimentally. Other than that, the influence of ship motions (e.g., roll, roll & pitch, heave etc.) with different oscillation amplitudes and periods on liquid draining dynamics is investigated to deepen the insights. vi In parallel with the experimental study, a 3D transient Euler-Euler CFD model is employed as a supplementary analysis to further deepen the understanding of liquid drainage dynamics in floating packed beds. More factors possibly affecting the draining dynamics are exploited by numerical simulation. Consequently, Chapter 3 highlights the comprehensive influence of liquid properties, bed structure and moving types instead of focusing on impact of movements alone. Meanwhile, with sufficient body of experimental campaign, the validity and accuracy of model are strongly endorsed.

Québec Université Laval, Bibliothèque 2014

The overall objective is to improve the one-dimensional numerical prediction of the fine and non-cohesive bed material load in alluvial rivers, especially during high intensity episodes during which sediment beds are strongly remobilized. For this reason, we attempt to reduce the major inaccuracy sources coming from the alluvial resistance and bed material load relations needed to close the mathematical system. Through a shared parameter called the control factor m, the interactions occurring in alluvial rivers are incorporated more deeply into the mathematical model and more particularly into the closure laws: bed material load (SVRD, Suction-Vortex Resuspension Dynamics) and the energy slope (Verbanck et al. 2007). The control factor m is assumedly related to the Rossiter resonance modes of the separated flow downstream the bed form crest. <p><p>To further improve the representation of the flow-sediment-morphology interactions, a fully coupled model approach has been naturally chosen. In this work the terminology fully coupled means that the three equations forming the system are solved synchronously and that the terms often neglected by more traditional decoupled models are kept. <p><p>The feasibility of the new closure methodology has been drawn up by reproducing numerically the silt-flushing experiment conducted by the Yellow River Conservancy Commission (Y.R.C.C.) in the Lower Yellow River (LYR) in Northern China. The objective of the silt flushing experiment is to reverse the aggradation trend of the Lower Yellow River which, in the last decades, has become a perched river. The numerical simulation specifically reproduces the silt-flush effects in a reach of LYR located in the meandering part of the river. This reach (around 100 km) is delimited by Aishan and Luokou hydrometric stations.<p><p>Since the SVRD formulation has been developed from flume observations, the law has first been confronted to river datasets. The confrontation has revealed that the SVRD law becomes less suitable for fine sediment fluxes (ratio of water depth over median particle size > 5000). Therefore, a modified equation SVRD-2 has been built to enlarge the validity range.<p><p>The suitability of the SVRD-2 equation to predict fine sediment fluxes has been tested on data available from several hydrometric stations located in the meandering reach of the LYR: historical observations and measures collected during the flushes. The SVRD-2 has also been compared with relations specifically calibrated for this configuration. The comparison has pointed out that the performance of the two formulas is similar, which is encouraging for the SVRD-2 approach as it has not been calibrated on those data. <p><p>The closed equation system has been written on its quasi-linear form and is solved by a Finite Volume Method combined with a linearized Riemann algorithm. The numerical model has been checked up on two test cases: deposition upstream of a dam and the aggradation experiment conducted by Soni 1975. <p><p>As it is not yet possible to predict dynamically the value of the control factor m, a possible solution would be to extract its value from the measured data at the inlet cross section. Unfortunately, the necessary data are not measured locally. Moreover, a uniform value of the control factor m may not suffice to reproduce the flow along the whole reach. Therefore, it has been proposed to work temporarily in the reverse way. <p><p>From the comparison between the numerical results and the experimental data, a time evolution of the control factor m has effectively been extracted and it has been shown that it varies along the reach. At Aishan, the evolution of the control factor m corresponds to the evolution expected from the data analysis previously conducted on other data sets: the value of the control factor m decreases during the flush as it tries to reach the optimal value m=1. The time evolution at Luokou behaves differently to the one at Aishan, but remains in agreement with m evolution patterns observed historically for the river section flowing round Jinan City walls. For Luokou, the highlighted differences may come from three dimensional effects coming from the meander bend upstream the station.<p><p>Generally, the results obtained for the hydraulics, the sediment transport and bed adaptation are encouraging but still need improvements and additional feeding from the experimental data. The results for the concentration and therefore the bed elevation are very sensitive to the value of the control factor m as it influences most of the terms of the bed material load equation (SVRD-2). <p><p>The major remaining difficulties are, firstly, to deal with the rapid transients for which the model is less suitable and, secondly, to improve the prediction of the value of control factor m. Before paying more attention into the transients, enhancements concerning the flow along the reach (initial condition and discharge rates during the first days of the flush) must be conducted in priority. Indeed as the prediction of the bed or the cross section evolutions depend directly on the quality of the prediction of the sediment concentration and the hydraulics, one should first improve these aspects. To perform this study, more information about the water levels or sediment concentrations is necessary at some intermediate stations. One solution is to lengthen the studied reach, upstream to Sunkou and downstream to Lijin, totaling a river length of 456 Km.<p><p>A more entire signal of the energy slopes and the associated bed configurations at different stations would enlighten how the control factor m evolves along the reach during the silt-flush events. <p><p> / Doctorat en Sciences de l'ingénieur / info:eu-repo/semantics/nonPublished