Thesis (MScEng)-- Stellenbosch University, 2013. / ENGLISH ABSTRACT: Concrete is used in most of the modern day infrastructure. It is a building material for which there exist various design codes and guidelines for its use and construction. It is strong in compression, but lacks tensile strength in its fresh and hardened states and, when unreinforced, fails in a brittle manner. The structural use of synthetic fibres in concrete is investigated in this study to determine its effect on enhancing the mechanical properties of concrete. Slabs on grade are used as the application for which the concrete is tested. The material behaviour is investigated in parallel with two floor design theories. These are the Westegaard theory and the Yield-Line theory. The Westegaard theory uses elastic theory to calculate floor thicknesses while the Yield-Line theory includes plastic behaviour. Conceptual designs are performed with the two theories and material parameters are determined from flexural tests conducted on synthetic fibre reinforced concrete (SynFRC) specimens. Large scale slab tests are performed to verify design values from the two theories. Higher loads till first-crack were measured during tests with concrete slabs reinforced with polypropylene fibres than for unreinforced concrete. It is found that the use of synthetic fibres in concrete increases the post-crack ductility of the material. The Westegaard theory is conservative in its design approach by over-estimating design thicknesses. This was concluded as unreinforced slabs reached higher failure loads than predicted by this theory. The Yield-Line theory predicts design thicknesses more accurately while still accounting for the requirements set by the ultimate- and serviceability limit states. By using SynFRC in combination with the Yield-Line theory as design method, thinner floor slabs can be obtained than with the Westegaard theory. / AFRIKAANSE OPSOMMING: Beton word gebruik as boumateriaal in meeste hedendaagse infrastruktuur. Daar bestaan verskeie ontwerp kodes en riglyne vir die gebruik en oprig van beton strukture. Alhoewel beton sterk in kompressie is, het beton ‘n swak treksterkte in beide die vars- en harde fases en faal dit in ‘n bros manier indien onbewapen. Die gebruik van sintetiese vesels in beton word in hierdie projek ondersoek om die invloed daarvan op die eienskappe van die meganiesegedrag van beton te bepaal. Grond geondersteunde vloere word as toepassing gebruik. Parallel met die materiaalgedrag wat ondersoek word, word twee ontwerpsteorieë ook ondersoek. Dit is die teorie van Westegaard en die Swig-Lyn teorie. Die teorie van Westegaard gebruik elastiese teorie in ontwerpsberekeninge terwyl die Swig-Lyn teorie ‘n plastiese analise gebruik. ‘n Konseptuele vloerontwerp is gedoen deur beide die ontwerpsmetodes te gebruik. Materiaalparameters is bepaal deur buig-toetse uit te voer op sintetiesevesel-bewapende beton. Grootskaalse betonblaaie is gegiet en getoets om die akkuraatheid van die twee metodes te verifieer. Die betonblaaie wat bewapen was met polipropileen vesels het groter laste gedra tot by faling as die blaaie wat nie bewapen was nie. Die vesels verbeter die gedrag van beton in die plastiese gebied van materiaalgedrag deurdat laste ondersteun word nadat die beton alreeds gekraak het. Die Westegaard teorie kan as konserwatief beskou word deurdat dit vloerdiktes oorskat. Hierdie stelling is gegrond op eksperimentele data wat bewys dat onbewapende betonblaaie groter laste kan dra as wat voorspel word deur die Westegaard teorie. Die Swig-Lyn teorie voorspel ontwerpsdiktes meer akkuraat terwyl daar steeds aan die vereistes van swigting en diensbaarheid voldoen word. Deur gebruik te maak van sintetiese vesels en die Swig-Lyn teorie kan dunner betonblaaie ontwerp word as met die Westegaard teorie.

The structure and composition of denim jeans is complex. In addition to cotton, which is the dominating type of textile fibre, there may be up to about 20 % synthetic fibres. The synthetic fibres are found in the sewing thread and in the elastic yarns that are used to make stretch denim jeans. In total it was found that up to six different types of textile fibres may be present in the material. To be able to recycle cotton in jeans by producing regenerated cellulose fibres a very high purity with respect to cotton is required. The purpose with this project was to investigate the possibility to fractionate the textile material found in denim jeans to obtain a pure cotton fraction that can be used in the viscose process to produce regenerated cellulose fibres, which then can be used to manufacture new clothes. In this project traditional wet mechanical separation equipment found in the pulp and paper industry, in the form of a laboratory screen (used as a model for a pressure screen) and hydrocyclone, was used to fractionate the textile material from cut and shredded denim jeans. The degree of separation of synthetic fibres from cotton fibres was quantitatively evaluated by measuring the glucose content after acid hydrolysis. The results from the experimental work showed that there were runnability problems both regarding disintegration and fractionation. Regarding the fractionation, plugging was found to be a problem and no significant separation of synthetic fibres from cotton fibres was obtained with the conditions of the experiment. / Strukturen och sammansättningen i denimjeans är komplex. Utöver bomull, vilken är den dominerande typen av textilfiber, kan de innehålla upp till 20 % syntetiska fibrer i tyget. De syntetiska fibrerna finns i sytråden och i elastiska garner som används för att tillverka stretchdenimjeans. Den här studien visade att upp till sex olika typer av textilfibrer kan förekomma i materialet. För att kunna återvinna bomull i denimjeans genom att producera regenererade cellulosafibrer krävs en mycket hög renhet med avseende på bomull. Syftet med projektet var att undersöka möjligheten att fraktionera textilmaterialet i denimjeans för att erhålla en ren bomullsfraktion som kan användas i viskosprocessen för att tillverka regenererade textilfibrer, vilka sedan kan användas för att tillverka nya kläder. I projektet användes, inom massa och pappersindustrin traditionell våtmekanisk separationsutrustning i form av en laboratoriesil (här använd som en modell av en trycksil) och en hydrocyklon, för att fraktionera textilmaterialet från klippta och sönderslitna denimjeans. Separationsgraden av syntetiska fibrer från bomullsfibrer bestämdes kvantitativt genom att mäta glukoshalten efter sur hydrolys. Resultatet från det experimentella arbetet visade att det finns körbarhetsproblem både gällande uppslagning och fraktionering. För fraktioneringen visade sig pluggning vara ett problem och ingen signifikant separation av syntetiska fibrer från bomullsfibrer erhölls med förhållandena i experimentet.

This diploma thesis is focused on a suitable midification of acoustic and thermal insulation materials from recycled textile fibres of lower quality due to improvement of their reaction to fire. The aim is to find an effective flame retardant and to verify suitable method of flame retardant application onto this type of insulation material.

The increasing quantity of waste represents serious environmental, social and economic problem. Wastes produced from industry and households. A large part of the economy transforms a certain amount of raw materials to waste in their production, because it is currently emphasis is placed on finding sustainable sources of raw materials. One of the suitable secondary raw materials can be discarded textiles or waste from the textile industry. These kinds of textile waste often ends up in landfills or incinerators, so it is from an ecological and environmentally advantageous to their further use. The diploma thesis deals with the study and development of thermal and acoustic insulation materials based on textile fibers. It focuses on the legislative requirements for waste management for the sorting of textile wastes and their subsequent modification before reuse. Further it contains kinds of textile fibers and bonding technologies thermal and acoustic insulation materials. Finally, an evaluation of thermal insulation, acoustic and mechanical properties of fibrous insulation materials.