Spelling suggestions: "subject:"atolerance satisficing"" "subject:"atolerance satisficing1""
1 |
Automated Iterative Tolerance Value Allocation and AnalysisJanuary 2016 (has links)
abstract: Tolerance specification for manufacturing components from 3D models is a tedious task and often requires expertise of “detailers”. The work presented here is a part of a larger ongoing project aimed at automating tolerance specification to aid less experienced designers by producing consistent geometric dimensioning and tolerancing (GD&T). Tolerance specification can be separated into two major tasks; tolerance schema generation and tolerance value specification. This thesis will focus on the latter part of automated tolerance specification, namely tolerance value allocation and analysis. The tolerance schema (sans values) required prior to these tasks have already been generated by the auto-tolerancing software. This information is communicated through a constraint tolerance feature graph file developed previously at Design Automation Lab (DAL) and is consistent with ASME Y14.5 standard.
The objective of this research is to allocate tolerance values to ensure that the assemblability conditions are satisfied. Assemblability refers to “the ability to assemble/fit a set of parts in specified configuration given a nominal geometry and its corresponding tolerances”. Assemblability is determined by the clearances between the mating features. These clearances are affected by accumulation of tolerances in tolerance loops and hence, the tolerance loops are extracted first. Once tolerance loops have been identified initial tolerance values are allocated to the contributors in these loops. It is highly unlikely that the initial allocation would satisfice assemblability requirements. Overlapping loops have to be simultaneously satisfied progressively. Hence, tolerances will need to be re-allocated iteratively. This is done with the help of tolerance analysis module.
The tolerance allocation and analysis module receives the constraint graph which contains all basic dimensions and mating constraints from the generated schema. The tolerance loops are detected by traversing the constraint graph. The initial allocation distributes the tolerance budget computed from clearance available in the loop, among its contributors in proportion to the associated nominal dimensions. The analysis module subjects the loops to 3D parametric variation analysis and estimates the variation parameters for the clearances. The re-allocation module uses hill climbing heuristics derived from the distribution parameters to select a loop. Re-allocation Of the tolerance values is done using sensitivities and the weights associated with the contributors in the stack.
Several test cases have been run with this software and the desired user input acceptance rates are achieved. Three test cases are presented and output of each module is discussed. / Dissertation/Thesis / Masters Thesis Mechanical Engineering 2016
|
Page generated in 0.0654 seconds