A human factors experiment was conducted to assess the intelligibility of synthesized speech under a variety of noise conditions for both hearing-impaired and normal-hearing subjects. Modified Rhyme Test stimuli were used to determine intelligibility in four speech-to-noise (S/N) ratios (0, 5, 10, and 15 dB), and three noise types, consisting of flat-by-octaves (pink) noise, interior noise of a currently produced heavy truck, and truck cab noise with added background speech. A quiet condition was also investigated. During recording of the truck noise for the experiment, in-cab noise measurements were obtained. According to OSHA standards, these data indicated that drivers of the sampled trucks have a minimal risk for noise-induced hearing loss due to in-cab noise exposure when driving at freeway speeds because noise levels were below 80 dBA. In the intelligibility experiment, subjects with hearing loss had significantly lower intelligibility than normal-hearing subjects, both in quiet and in noise, but no interaction with noise type or S/N ratio was found. Intelligibility was significantly lower for the noise with background speech than the other noises, but the truck noise produced intelligibility equal to the pink noise. An analytical prediction of intelligibility using Articulation Index calculations exhibited a high positive correlation with the empirically obtained intelligibility data for both groups of subjects. / Master of Science

Thesis (MScEng (Mechanical and Mechatronic Engineering))--University of Stellenbosch, 2005. / Vehicle Noise, Vibration and Harshness (NVH) is now a more important component of the vehicle design process than ever. Road noise is one of the key criteria used by potential buyers (albeit subconsciously) to choose what they perceive as the best vehicle. Road rumble is a key concern for vehicle manufacturers. Light Utility Vehicles (LUVs) are especially sensitive to a low frequency booming noise due to the fundamental acoustic mode that exists in the vehicle cabin. An investigation into this booming noise in an LUV is documented. The noise is identified and quantified after which the source of the noise in the vehicle cabin is identified using NVH techniques such as Acoustic Modal Analysis (AMA), Experimental Modal Analysis (EMA) and Transfer Path Analysis (TPA). The cabin’s fundamental acoustic mode lay at 100 Hz. Finally the source of the vibrations in the vehicle leading to the booming noise in the cabin is identified, along with its transfer path to the cabin. Solutions for the specific vehicle’s booming noise are proposed, two of which are tested with some success. Solutions to the problems associated with the fundamental acoustic mode of LUVs are also proposed and discussed.