Gears are machine elements essential for mechanical transmission. Wear of gear teeth can causechanges in their profile geometry, causing vibration, noise, and subsequent gear failure. In this thesisproject, a twin disc tribometer has been used to mimic the actual Alfa Laval separator screw gearsystems. An investigation of the wear of different material pairs has been done using a twin disctribometer machine. In the twin disc tribometer, the material surface for one disc was bronze and thematerial for the counter disc surface was varied with steel of different types. Each bronze-steel pair wastested against different loading, lubricating and surface roughness conditions. For the wear tests, twodifferent loads, 75 N and 150 N and two different types of lubricants, Polyalphaolefin (PAO) andPolyalkylene Glycol (PAG) were taken. Wear tests were also done with the Applied Nano Surfaces(ANS) triboconditioning (TCG) steel disc samples which are surface treated to obtain a lower surfaceroughness. To obtain the wear volume and wear rate values the disc pairs were further analysed usinglaboratory equipment and computer software such as the digital microscope, optical interferometer andMountainsLab premium 9. Analytical calculations for minimum film thickness and thermally correctedminimum film thickness between the disc surfaces were obtained using the Dowson-Hamrock equationand Gupta formula, respectively. It has been found that the wear on the bronze disc is minimum if thecounter steel discs are Applied Nano Surfaces (ANS) of TCG 1 type followed by counter disc as casehardened steel, all of it at 75 N and with Polyalphaolefin (PAO) lubricant oil.