1 |
Large Scale Visualization of Pulsed Vortex Generator JetsMoore, Kenneth Jay, Jr. January 2005 (has links)
No description available.
|
2 |
Effects of Spanwise and Discrete Disturbances on Separating Boundary Layers on Low Pressure Turbine BladesReimann, Daniel D. 20 March 2007 (has links) (PDF)
Flow measurements were made on two highly loaded, low pressure turbine blade configurations in a low-speed, linear cascade facility. The L1M blade has a design Zweifel coefficient of 1.34 with a peak cp near 47% cx (mid-loaded) and the Pack B blade has a design Zweifel coefficient of 1.15 with a peak cp at 63% cx (aft-loaded). Flow velocity and surface pressure measurements were taken for Rec=20,000 and 3% inlet freestream turbulence. For these operating conditions, a large separation bubble forms on the blade suction surface, beginning at 59% cx and reattaching at 86% cx on the L1M blade and a non-reattaching bubble beginning at 68% cx on the Pack B. A spanwise row of discrete vortex-generating jets located at 59% cx on the Pack B and 50% cx on the L1M were used as a separation control device and were pulsed at a frequency of 5 Hz with a duty cycle of 25%. The Pack B with its open separation bubble proved to be a better candidate for VGJ control than the L1M with its closed separation bubble. Further studies were made on the Pack B blade comparing wake and VGJ effects. A wake generator was used to simulate the periodic passing of upstream wakes through the blade passage for the Pack B configuration. The wake passing frequency of 4.5Hz was set to match a typical engine flow coefficient for a low pressure turbine. Data were taken using PIV and a hot-film anemometer mounted on a blade following device. Velocity, turbulence, and intermittency measurements were made along the suction surface of the blade to characterize the bubble dynamics and transitional behaviors for both the presence of unsteady wakes and pulsing VGJs. The wakes caused early breakdown of the separated free shear layer resulting in a thinning of the separation region. The VGJs caused an upstream disturbance which convects downstream, temporarily pushing off the separation bubble. Overall, both wakes and VGJs suppress the size of the steady-state separation bubble, though through different mechanisms. Three-dimensional aspects of the jet disturbance are studied by investigating the effects of the VGJs at two spanwise locations.
|
3 |
The Effects of Vortex Generator Jet Frequency, Duty Cycle, and Phase on Separation Bubble DynamicsBloxham, Matthew J. 20 March 2007 (has links) (PDF)
Vortex generator jets (VGJs) have proven to be effective in minimizing the separation losses on low-pressure turbine blades at low Reynolds numbers. Experimental data collected using phase-locked particle image velocimetry and substantiated with a hot-film anemometer were used to answer fundamental questions about the influence of VGJs on a separated boundary layer. The data were collected on the suction surface of the Pack B blade profile, which has a non-reattaching separation bubble beginning at 68% axial chord. Two VGJ pulse histories were created with different frequencies, jet durations, and duty cycles. The mechanisms responsible for boundary layer separation control were shown to be a combination of boundary layer transition and streamwise vortical structures. Jet duration and relaxation time were important VGJ characteristics in determining the extent of control. The unsteady environment characterisitic of the low-pressure turbine section in a gas turbine engine effectively reduces the time-averaged separation zone by as much as 35%. Upstream blade rows create unsteady flow disturbances (wakes) that transition the flow. This transitioned flow propagates downstream, re-attaching the separation bubbles on the subsequent blade row. Phase-locked PIV and hot-film measurements were used to document the characteristics of this separation zone when subjected to synchronized unsteady wakes and VGJs. The phase difference between VGJ actuation and the wake passing, blowing ratio, and VGJ duration were optimized to achieve the greatest time-averaged control of the separation zone. The experimental data were used to identify the important characteristics of the wake/jet interaction. Phase-locked PIV measurements were taken to isolate the wake event (wake only), the VGJ event (jets only), and the synchronized combination of unsteady wakes and jets. The synchronized conditions achieved maximum separation bubble control. The presence of wake and jet induced calmed zones are also noted.
|
4 |
FLOW SEPARATION CONTROL FOR CYLINDER FLOW AND CASCADE FLOW USING GENERATOR JETSKASLIWAL, AMIT 03 April 2006 (has links)
No description available.
|
Page generated in 0.0274 seconds