1 |
Placement of Mineral Trioxide Aggregate Using Two Different TechniquesAminoshariae, Anita 01 January 2002 (has links)
AbstractTHE PLACEMENT OF MINERAL TRIOXIDE AGGREGATE USING TWO DIFFERENT TECHNIQUESBy Anita Aminoshariae, D.D.S.A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science at Virginia Commonwealth UniversityVirginia Commonwealth University, 2003Major Director: Gary R. Hartwell, D.D.S., M.S.Chairman and Professor, Department of EndodonticsThe purpose of this study was to determine if the adaptation of Mineral Trioxide Aggregate (MTA) to the walls of the samples would differ when placed into simulated root canals of varying length using two different placement and condensation methods. Hand condensation was compared to ultrasonic condensation. Eighty polyethylene tubes were divided into four groups of twenty tubes each. The tubes in the four groups were prepared to receive 3, 5, 7 and 10-mm lengths of MTA respectively. Each group of twenty tubes was then subdivided so that ten samples of each length would have MTA placed and condensed by the hand method and the other ten by the ultrasonic method. After condensation the samples were evaluated with a light microscope and radiographs for the degree of adaptation of the MTA to the tube walls and for the presence of voids within the MTA material itself. The results demonstrated an 80% agreement for findings between the light microscopy and radiographic evaluation. Hand condensation resulted in better adaptation to the tube walls and less voids than the ultrasonic method. There was no significant difference in the results for any of the four lengths of MTA placed by the hand method (p> 0.9). At this time hand condensation should be considered the preferred method for placement of MTA.
|
2 |
An Environment For Specifying and Executing Adaptable Software ComponentsUnhale, Sudeep Prabhakar 27 April 2003 (has links)
One of the difficulties of Component Based Software Engineering (CBSE) [1] in reusing pre-existing components is the need to adapt these components to work within the desired target systems [2, 3, 4, 5, 6]. Third-party or in-house Commercial Off-the-shelf (COTS) components may not always have the required exact functionality demanded by the builders of the target system, so these systems have to be either modified [2, 3, 4, 5, 6] or adapted to provide this required functionality. Modifying these components may not be always practically possible. In this thesis, we propose an infrastructure that supports the active interface adaptation technique [3, 8, 9, 10]. This infrastructure directly addresses the problem of effectively packaging components for third-party use, adaptation, and deployment. Doing so we support both component designers and third party application builders. Further we evaluate our approach using several adaptations over the case studies.
|
Page generated in 0.1216 seconds