Abstract Advanced multiple-input multiple-output (MIMO) transceiver structures which utilize the knowledge of channel state information (CSI) at the transmitter side to optimize certain link parameters (e.g., throughput, fairness, spectral efficiency, etc.) under different constraints (e.g., maximum transmitted power, minimum quality of services (QoS), etc.) are considered in this thesis. Adaptive transmission schemes for point-to-point MIMO systems are considered first. A robust link adaptation method for time-division duplex systems employing MIMO-OFDM channel eigenmode based transmission is developed. A low complexity bit and power loading algorithm which requires low signaling overhead is proposed. Two algorithms for computing the sum-capacity of MIMO downlink channels with full CSI knowledge are derived. The first one is based on the iterative waterfilling method. The convergence of the algorithm is proved analytically and the computer simulations show that the algorithm converges faster than the earlier variants of sum power constrained iterative waterfilling algorithms. The second algorithm is based on the dual decomposition method. By tracking the instantaneous error in the inner loop, a faster version is developed. The problem of linear transceiver design in MIMO downlink channels is considered for a case when the full CSI of scheduled users only is available at the transmitter. General methods for joint power control and linear transmit and receive beamformers design are provided. The proposed algorithms can handle multiple antennas at the base station and at the mobile terminals with an arbitrary number of data streams per scheduled user. The optimization criteria are fairly general and include sum power minimization under the minimum signal-to-interference-plus-noise ratio (SINR) constraint per data stream, the balancing of SINR values among data streams, minimum SINR maximization, weighted sum-rate maximization, and weighted sum mean square error minimization. Besides the traditional sum power constraint on the transmit beamformers, multiple sum power constraints can be imposed on arbitrary subsets of the transmit antennas.This extends the applicability of the results to novel system architectures, such as cooperative base station transmission using distributed MIMO antennas. By imposing per antenna power constraints, issues related to the linearity of the power amplifiers can be handled as well. The original linear transceiver design problems are decomposed as a series of remarkably simpler optimization problems which can be efficiently solved by using standard convex optimization techniques. The advantage of this approach is that it can be easily extended to accommodate various supplementary constraints such as upper and/or lower bounds for the SINR values and guaranteed QoS for different subsets of users. The ability to handle transceiver optimization problems where a network-centric objective (e.g., aggregate throughput or transmitted power) is optimized subject to user-centric constraints (e.g., minimum QoS requirements) is an important feature which must be supported by future broadband communication systems.