1 |
Aerial Rendezvous Between an Unmanned Air Vehicle and an Orbiting Target VehicleOwen, Mark Andrew 18 October 2011 (has links) (PDF)
In this thesis we develop methods that facilitate an aerial rendezvous between two air vehicles. The objective of this research is to produce a method that can be used to insert a miniature air vehicle behind a rendezvous vehicle and then track that vehicle to enable a visual rendezvous. For this research we assume the rendezvous vehicle is following a relatively stable and roughly elliptical orbit. Path planners and controllers have been developed that can be used to effectively intercept the rendezvous vehicle by inserting the MAV onto the orbit of interest. A method for planning and following time-optimal Dubins airplane interception paths between a miniature air vehicle and the rendezvous vehicle is presented. We demonstrate how a vector field path following a scheme can be used for navigation along these time-optimal Dubins airplane paths. A post-orbit insertion tracking method is also presented which can be used to track the target vehicle on an arbitrarily oriented elliptical orbit while maintaining a specified following distance. We also present controllers that can be used for disturbance rejection during the orbit-insertion and interception operations. All of these methods were implemented in simulation and with hardware. Results from these implementations are presented and analyzed.
|
2 |
Vision-Based Guidance for Air-to-Air Tracking and Rendezvous of Unmanned Aircraft SystemsNichols, Joseph Walter 13 August 2013 (has links) (PDF)
This dissertation develops the visual pursuit method for air-to-air tracking and rendezvous of unmanned aircraft systems. It also shows the development of vector-field and proportional-integral methods for controlling UAS flight in formation with other aircraft. The visual pursuit method is a nonlinear guidance method that uses vision-based line of sight angles as inputs to the algorithm that produces pitch rate, bank angle and airspeed commands for the autopilot to use in aircraft control. The method is shown to be convergent about the center of the camera image frame and to be stable in the sense of Lyapunov. In the lateral direction, the guidance method is optimized to balance the pursuit heading with respect to the prevailing wind and the location of the target on the image plane to improve tracking performance in high winds and reduce bank angle effort. In both simulation and flight experimentation, visual pursuit is shown to be effective in providing flight guidance in strong winds. Visual pursuit is also shown to be effective in guiding the seeker while performing aerial docking with a towed aerial drogue. Flight trials demonstrated the ability to guide to within a few meters of the drogue. Further research developed a method to improve docking performance by artificially increasing the length of the line of sight vector at close range to the target to prevent flight control saturation. This improvement to visual pursuit was shown to be an effective method for providing guidance during aerial docking simulations. An analysis of the visual pursuit method is provided using the method of adjoints to evaluate the effects of airspeed, closing velocity, system time constant, sensor delay and target motion on docking performance. A method for predicting docking accuracy is developed and shown to be useful for predicting docking performance for small and large unmanned aircraft systems.
|
Page generated in 0.0691 seconds