<p>The objective with this thesis project was to with the simulations software Delmia make a working build philosophy for the new concept of the fixed leading edge for the Airbus A320 airliner, but also to make two conceptual fixtures in the modular framework BoxJoint for pre-drilling of two sub assemblies.</p><p> </p><p>Everything started with a study in Delmia to both recap on previous knowledge and to learn more about it. This was followed by early simulations on the new concepts that were provided by project partners. Then a study was made in the Affordable Reconfigurable tooling, ART-concept. A suggested build philosophy was created and possible areas for automation were identified. These areas were all the drilling and fettling operations except the drilling in the last stage where the pre-drilled holes are opened up. More investigations needs to be done to see if a robot can install and remove slave pins that are used in the last stage. Two conceptual designs on fixtures were created where one uses two industrial robots with vision systems to get the correct accuracy when drilling the product. The other was build to be able to use a Tau-Gantry robot solution together with a vision system.</p>

The objective with this thesis project was to with the simulations software Delmia make a working build philosophy for the new concept of the fixed leading edge for the Airbus A320 airliner, but also to make two conceptual fixtures in the modular framework BoxJoint for pre-drilling of two sub assemblies.   Everything started with a study in Delmia to both recap on previous knowledge and to learn more about it. This was followed by early simulations on the new concepts that were provided by project partners. Then a study was made in the Affordable Reconfigurable tooling, ART-concept. A suggested build philosophy was created and possible areas for automation were identified. These areas were all the drilling and fettling operations except the drilling in the last stage where the pre-drilled holes are opened up. More investigations needs to be done to see if a robot can install and remove slave pins that are used in the last stage. Two conceptual designs on fixtures were created where one uses two industrial robots with vision systems to get the correct accuracy when drilling the product. The other was build to be able to use a Tau-Gantry robot solution together with a vision system.