- About
-
The Global ETD Search service is a free service for researchers
to find electronic theses and dissertations. This service is
provided by the
Networked Digital Library of Theses and Dissertations.
Our metadata is collected from universities around the world. If you manage a university/consortium/country archive and want to be added, details can be found on the NDLTD website.
Search results
Showing 21 to 30 of 40 (0.078 seconds)| 21 |
Short range order and development of long range order in nickel - 20 atomic percent molybdenum alloyChakravarti, Bhaven 08 1900 (has links)
No description available.
|
| 22 |
The stress corrosion susceptibility of stress coined fastener holes in aircraft structuresCarter, Aubrey Edward 12 1900 (has links)
No description available.
|
| 23 |
Linear cellular copper in bending, compression and shearTotty, Jennifer L. 05 1900 (has links)
No description available.
|
| 24 |
The effects of composition on the dihedral angles and interface energies in some ternary aluminum alloysMorris, Thomas Otis 08 1900 (has links)
No description available.
|
| 25 |
Fretting fatigue crack nucleation in Ti-6A1-4VWallace, Jon Michael 08 1900 (has links)
No description available.
|
| 26 |
Durability of the residual stresses surrounding cold expanded fastener holes in 7050-T7451 aluminumClark, David A. 12 1900 (has links)
No description available.
|
| 27 |
A critical assessment of the potential of shape memory alloys for seismic resistant designs and retrofitsSmith, Brian J. 08 1900 (has links)
No description available.
|
| 28 |
The time-temperature-sensitization behavior of alloy 800 as determined by the electrochemical potentiokinetic reactivation test and the modified strauss testEdgemon, Glenn Leon 12 1900 (has links)
No description available.
|
| 29 |
The effect of high speed machining on the surface integrity of certain titanium alloysVan Trotsenburg, Samantha 15 August 2012 (has links)
M.Ing. / This dissertation documents the stages involved in determining the parameters that define surface integrity. Chapter one gives a basic introduction to the project; the problem statement; scope of work and project obstacles. This chapter laid down the requirements for the literature study in Chapters two and three. The literature study discusses machining, high-speed machining, titanium alloys and high speed machining of titanium alloys. Information from the literature study was used to determine the experimental program presented in Chapter 4. Two materials were investigated in this study: grade 2 titanium (commercially pure) and grade 5 titanium (an alloy containing 6% Aluminium and 4% Vanadium). A fixed feed rate of 0.25mm/rev was selected. Two depths of cut were used: 0.2mm and 1mm. Cuts were performed both lubricated and un-lubricated. Different cutting speeds were used both inside and outside recommended ranges. Surface roughness tests, optical microscopy, scanning-electron microscopy, microhardness tests and x-ray diffraction were used in the experimental program. Results obtained presented trends seen in previous work on surface integrity. Efforts were made to reduce errors in obtaining and examining data. Conclusions were drawn with regards to each surface integrity parameter tested for. It was found that different cutting speeds affect each surface integrity parameter differently.
|
| 30 |
Microstructural characterization of titanium alloys with fretting damageSwalla, Dana Ray 01 December 2003 (has links)
No description available.
|
Page generated in 0.0844 seconds