1 |
Design and performance of an ammonia measurement systemBoriack, Cale Nolan 25 April 2007 (has links)
Ammonia emissions from animal feeding operations (AFOs) have recently come
under increased scrutiny. The US Environmental Protection Agency (EPA) has come
under increased pressure from special interest groups to regulate ammonia. Regulation
of ammonia is very difficult because every facility has different manure management
practices. Different management practices lead to different emissions for every facility.
Researchers have been tasked by industry to find best management practices to reduce
emissions. The task cannot be completed without equipment that can efficiently and
accurately compare emissions. To complete this task, a measurement system was
developed and performance tested to measure ammonia. Performance tests included
uncertainty analysis, system response, and adsorption kinetics.
A measurement system was designed for measurement of gaseous emissions
from ground level area sources (GLAS) in order to sample multiple receptors with a
single sensor. This multiplexer may be used in both local and remote measurement
systems to increase the sampling rate of gaseous emissions. The increased data
collection capacity with the multiplexer allows for nearly three times as many samples to
be taken in the same amount of time while using the same protocol for sampling.
System response analysis was performed on an ammonia analyzer, a hydrogen
sulfide analyzer, and tubing used with flux chamber measurement. System responses
were measured and evaluated using transfer functions. The system responses for the
analyzers were found to be first order with delay in auto mode. The tubing response was
found to be a first order response with delay. Uncertainty analysis was performed on an ammonia sampling and analyzing
system. The system included an analyzer, mass flow controllers, calibration gases, and
analog outputs. The standard uncertainty was found to be 443 ppb when measuring a 16
ppm ammonia stream with a 20 ppm span.
A laboratory study dealing with the adsorption kinetics of ammonia on a flux
chamber was performed to determine if adsorption onto the chamber walls was
significant. The study found that the adsorption would not significantly change the
concentration of the output flow 30 minutes after a clean chamber was exposed to
ammonia concentrations for concentrations above 2.5 ppm.
|
2 |
Precipitation of Phosphate Minerals from Effluent of Anaerobically Digested Swine ManureLin, Alex Y. 01 January 2012 (has links)
Swine production represents approximately 40% of the world's meat production, and its wastes contain high concentrations of organic carbon, nitrogen (N), and phosphorus (P). Anaerobic digestion is an increasingly popular technology for treating animal wastes while simultaneously generating energy. Its propagation and ability to solubilize organic N and P make adding a struvite recovery process attractive. Recovering struvite (MgNH4PO4) from anaerobically digested swine waste can address global P shortages, meet P discharge guidelines, and produce slow-release fertilizer, which can be sold for revenue.
Anaerobic digesters were operated with at organic loading rates of 3.4-3.9 g volatile solids per liter per day to provide consistent effluent for struvite precipitation studies. Three research questions about struvite precipitation were addressed in this study, specifically what is the (1) required Mg:PO4 ratio, (2) effect of organic matter, and (3) effect of storage time and conditions on struvite precipitation from effluent of anaerobically digested swine manure? Mg:PO4 ratios between 1.3-1.8 were determined to be the economic optimum and precipitated 81-90% of P from synthetic wastewater with calcium phosphate minerals dominating. Under P-limited conditions, a chemical equilibrium model (Visual MINTEQ v.3.0) predicted over 99% P removal with a precipitate mixture of struvite, calcium phosphates, and magnesite. Synthetic wastewater experiments without organic matter removed approximately 85% P with a precipitate mixture of struvite, dolomite, calcite, brucite, and calcium phosphates. Real swine effluent removed more than 95% of P and had a similar mixture of precipitates as synthetic wastewater, but in different concentrations. Organic acids were suspected to prevent struvite formation. Stored anaerobically digested swine wastewater under varying conditions all suggest calcium phosphates form naturally over time. Precipitation of struvite is best carried out as soon as possible to increase the purity of struvite. Although struvite recovery was possible, the conditions for struvite precipitation must be controlled carefully to obtain highly pure struvite.
|
3 |
Advanced embedded systems and sensor networks for animal environment monitoringDarr, Matthew J. 10 December 2007 (has links)
No description available.
|
4 |
Air emissions measurements at cattle feedlotsBaum, Kristen A. January 1900 (has links)
Master of Science / Department of Agronomy / Jay M. Ham / The potential environmental impact of animal feeding operations on air quality has created the need for accurate air emissions measurements. Of particular concern are ammonia emissions from cattle feedlots, operations that contribute a large portion of the agricultural ammonia emissions inventory. Micrometeorological methods are ideal for emissions measurements from large, open-source areas like feedlot pens; however, theoretical assumptions about the boundary layer must be made, which may not hold true above the heterogeneous, fetch-limited surface of the feedlot. Thus, the first objective of this work was to characterize the surface boundary layer of an open-air cattle feedlot and provide insight into how micrometeorological techniques might be applied to these non-ideal sites. Eddy covariance was used to measure fluxes of momentum, heat, water, and carbon dioxide from a commercial cattle feedlot in central Kansas. Data supported the use of eddy covariance and similar methods (i.e., relaxed eddy accumulation) for flux measurements from both cattle and pen surfaces. The modeled cumulative source area contributing to eddy covariance measurements at a 6 m sample height was dominated by just a few pens near the tower, making the characteristics of those pens especially important when interpreting results. The second objective was to develop a system for measuring ammonia fluxes from feedlots. A new type of relaxed eddy accumulation system was designed, fabricated, and tested that used honeycomb denuders to independently sample ammonia in up-moving and down-moving eddies. Field testing of the relaxed eddy accumulation system at a feedlot near Manhattan, KS showed fluxes of ammonia ranged between 60 and 130 μg m-2 s-1 during the summer of 2007. Even in the high ammonia environment (e.g., 300-600 μg m-3), the honeycomb denuders had enough capacity for the 4-hour sampling duration and could be used to measure other chemical species that the denuders could be configured to capture. Results provide a foundation for emissions measurements of ammonia and other gases at cattle feedlots and help address some of the challenges that micrometeorologists face with any non-ideal source area.
|
Page generated in 0.101 seconds