With increasing demands on environmental protection in recent years, the Government agency concerned has recently proposed the strategies for shore protection and management, which aim for prevention and mitigation of coastal disaster and reduction in coastal erosion, as well as the creation of an environment with focus on landscape, ecology and community recreation. Soft and quasi-natural approach will be implemented to restore the glory of a stable coast. Based on the consideration of disaster prevention, this study investigates the beach profile changes, which include beach berm erosion and bar formation resulting from storm waves with different return periods. The SBEACH model is used to estimate the beach changes subject to variable conditions of beach berm width, medium sand grain diameter, beach slope and design water level etc. Regression analysis is then applied to establish a relationship between the storm beach buffer width and relevant physical parameters. Prior to this, the results of large wave tank tests on beach profile changes conducted by Coastal Engineering Research Center in the United States are used to calibrate the two main parameters K and £` used in SBEACH model. Beach profile changes can now be estimated systematically using a set of modified K and £` values. After having performed a series numerical studies, we may conclude that: (1) With storms of different return periods but identical non-dimensional fall velocity (H0/£sT), berm erosion increases and the location of the bar becomes further offshore as storm return period increases ; (2) With different sand grain sizes subject to identical storm wave conditions, beach berm erosion increases as grain size increased, but shoreline retreat decreases; and location of bar is further offshore for a beach consisting smaller sand grains; (3) Under the same storm return period and sand grain diameter (i.e., similar non-dimensional fall velocity), berm erosion increases as storm intensity and design water level increase, but shoreline retreat decreases and bar is located nearer; and vice versa; (4) from a series of calculations based on different sand grains and storm beach buffer width, it is found that larger buffer is required for beach with smaller grain size, in order to absorb the storm wave energy.

On the basis of coastal disaster mitigation and protection, a beach must have sufficient width for preventing the destruction to public facilities, as well as protecting the safety of life and private property during storm events. The requirement of such a horizontal extent from the initial shoreline to the probable erosion landward to safeguard against the onslaught of a storm is referred to as ¡¥storm beach buffer width¡¦. Upon neglecting the effects of global warming and sealevel rise on a beach and berm with profile in equilibrium, numerical calculations are conducted first to validate the range of the most important parameters (K »P £` ) in the SBEACH model using the results of profile changes available from the CERC¡¦s large wave tank (LWT) tests in 1960s. These results are then applied to assess the profile changes for a beach with a vertical seawall and the other without sufficient berm, subject to the normal incidence of storm waves over a specific duration. Finally, a total of 48 cases with sufficient beach width are then investigated, from which a multiple linear regression model is proposed to determine the extent of berm retreat, as well as the location and height of a submerged offshore bar, for the benefit of coastal profession on preliminary design of storm buffer. Our modeling results using SBEACH reveal that: (1) A seawall without or with insufficient fronting beach could result in serious scour at its toe and even the total loss of the entire beach berm; (2) A beach with sufficient berm, natural or artificially nourished, is capable of protecting the back beach, despite the temporary erosion in the early hours of a storm action; (3) Under the same conditions of wave height and period, a wide buffer is necessary for a beach with small mean sand grain, and the berm height should be designed at 1.6 times of the designed storm surge level, in order to effectively absorb storm wave energy and maintain the provision of a storm buffer; and (4) The multiple linear regression model proposed in this study can be used to evaluate the scour depth and retreat of the berm, as well as the width of a storm beach buffer, upon the input of wave conditions and mean beach sand grain etc.