Multiple-input multiple-output (MIMO) systems have received much attention due to their multiplexing and diversity capabilities. It is possible to obtain remarkable improvement in spectral efficiency for wireless systems by using MIMO based schemes. However, sophisticated equalization and decoding structures are required for reliable communication at high rates. In this thesis, capacity achieving practical transceiver structures are proposed for MIMO wireless channels depending on the availability of channel state information at the transmitter (CSIT). First, an adaptive MIMO scheme based on the use of quantized CSIT and reduced precoding idea is proposed. With the help of a very tight analytical upper bound obtained for limited rate feedback (LRF) MIMO capacity, it is possible to construct an adaptive scheme varying the number of beamformers used according to the average SNR value. It is shown that this strategy always results in a significantly higher achievable rate than that of the schemes which does not use CSIT, if the number of transmit antennas is greater than that of receive antennas. Secondly, it is known that the use of CSIT does not bring significant improvement over capacity, when similar number of transmit and receive antennas are used / on the other hand, it reduces the complexity of demodulation at the receiver by converting the channel into noninterfering subchannels. However, it is shown in this thesis that it is still possible to achieve a performance very close to the outage probability and exploit the space-frequency diversity benefits of the wireless fading channel without compromising the receiver complexity, even if the CSIT is not used. The proposed receiver structure is based on iterative forward and backward filtering to suppress the interference both in time and space followed by a spacetime decoder. The rotation of multidimensional constellations for block fading channels and the single-carrier frequency domain equalization (SC-FDE) technique for wideband MIMO channels are studied as example applications.

Multipath propagation and mobility in wireless communication systems give rise to variations in the amplitude and phase of the transmitted signal, commonly referred to as fading. Many wireless applications are affected by slowly varying fading, where the channel is non-ergodic, leading to non-reliable transmission during bad channel realizations. These communication scenarios are well modeled by the block-fading channel, where the reliability is quantatively characterized by the outage probability. This thesis focuses on the analysis and design of adaptive transmission schemes to improve the outage performance of both single- and multiple-antenna transmission over the block-fading channel, especially for the cases where discrete input constellations are used. Firstly, a new lower bound on the outage probability of non-adaptive transmission is proposed, providing an efficient tool for evaluating the performance of non-adaptive transmission. The lower bound, together with its asymptotic analysis, is essential for efficiently designing the adaptive transmission schemes considered in the thesis. Secondly, new power allocation rules are derived to minimize the outage probability of fixed-rate transmission over block-fading channels. Asymptotic outage analysis for the resulting schemes is performed, revealing important system design criteria. Furthermore, the thesis proposes novel suboptimal power allocation rules, which enjoy low-complexity while suffering minimal losses as compared to the optimal solution. Thus, these schemes facilitate power adaptation in low-cost devices. Thirdly, the thesis considers incremental-redundancy automatic-repeat-request (INR-ARQ) strategies, which perform adaptive transmission based on receiver feedback. In particular, the thesis concentrates on multi-bit feedback, which has been shown to yield significant gains in performance compared to conventional single-bit ARQ schemes. The thesis proposes a new information-theoretic framework for multi-bit feedback INR-ARQ, whereby the receiver feeds back a quantized version of the accumulated mutual information. Within this framework, the thesis presents an asymptotic analysis which yields the large gains in outage performance offered by multi-bit feedback. Furthermore, the thesis proposes practical design rules, which further illustrates the benefits of multi-bit feedback in INR-ARQ systems. In short, the thesis studies the outage performance of transmission over block-fading channels. Outage analysis is performed for non-adaptive and adaptive transmission. Improvements for the existing adaptive schemes are also proposed, leading to either lower complexity requirements or better outage performance. Still, further research is needed to bring the benefits offered by adaptive transmission into practical systems. / Thesis (PhD)--University of South Australia, 2010

Multipath propagation and mobility in wireless communication systems give rise to variations in the amplitude and phase of the transmitted signal, commonly referred to as fading. Many wireless applications are affected by slowly varying fading, where the channel is non-ergodic, leading to non-reliable transmission during bad channel realizations. These communication scenarios are well modeled by the block-fading channel, where the reliability is quantatively characterized by the outage probability. This thesis focuses on the analysis and design of adaptive transmission schemes to improve the outage performance of both single- and multiple-antenna transmission over the block-fading channel, especially for the cases where discrete input constellations are used. Firstly, a new lower bound on the outage probability of non-adaptive transmission is proposed, providing an efficient tool for evaluating the performance of non-adaptive transmission. The lower bound, together with its asymptotic analysis, is essential for efficiently designing the adaptive transmission schemes considered in the thesis. Secondly, new power allocation rules are derived to minimize the outage probability of fixed-rate transmission over block-fading channels. Asymptotic outage analysis for the resulting schemes is performed, revealing important system design criteria. Furthermore, the thesis proposes novel suboptimal power allocation rules, which enjoy low-complexity while suffering minimal losses as compared to the optimal solution. Thus, these schemes facilitate power adaptation in low-cost devices. Thirdly, the thesis considers incremental-redundancy automatic-repeat-request (INR-ARQ) strategies, which perform adaptive transmission based on receiver feedback. In particular, the thesis concentrates on multi-bit feedback, which has been shown to yield significant gains in performance compared to conventional single-bit ARQ schemes. The thesis proposes a new information-theoretic framework for multi-bit feedback INR-ARQ, whereby the receiver feeds back a quantized version of the accumulated mutual information. Within this framework, the thesis presents an asymptotic analysis which yields the large gains in outage performance offered by multi-bit feedback. Furthermore, the thesis proposes practical design rules, which further illustrates the benefits of multi-bit feedback in INR-ARQ systems. In short, the thesis studies the outage performance of transmission over block-fading channels. Outage analysis is performed for non-adaptive and adaptive transmission. Improvements for the existing adaptive schemes are also proposed, leading to either lower complexity requirements or better outage performance. Still, further research is needed to bring the benefits offered by adaptive transmission into practical systems. / Thesis (PhD)--University of South Australia, 2010