Simulating blood flow in microvessels is a major challenge because of the numerous blood cells suspended in the blood. Furthermore, red blood cells (RBCs), which constitute 45% of the total blood volume, are highly deformable. RBCs deformation and RBC-RBC interactions determine the complex rheology of the blood. In this research, we simulate the blood flow in periodic two dimensional channels and conduct numerical experiments on the cell-free layer which appears near the wall. We use the boundary integral method and the smooth particle mesh Ewald method to represent the blood flow, and cells are modeled as deformable capsules. In the numerical experiments, we examine four possible mechanisms that may contribute to the cell-free layer: RBC deformation, RBC aggregation, configuration constraint, and the lubrication mechanism. Our simulations correctly represent hemodynamic phenomena such as the blunt velocity profile and the Fåhræus effect. We observed that more deformable RBCs migrate more away from the wall, and, consequently, the thickness of the cell-free layer increases. However, RBC aggregation increased the cell-free layer thickness by only 5%. In the experiment on the configuration constraint, no cell-free "layer" was detected when we removed cells which intersected an artificial constraint in the microvessel. In the last experiment on the lubrication mechanism, the cell-free layer disappeared at a no-shear stress boundary, and the hematocrit profile was similar to that in the constraint test. Therefore, this research clearly shows that the cell-free layer is generated by the lateral migration of deformable RBCs due to the lubrication mechanism. / text

Blood flow through microcirculation in both simple and complex geometry has been difficult to predict due to the composition and complex behavior of blood at the microscale. Blood is a dense suspension of deformable red blood cells that is comparable in dimensions to the microchannels that it flows through. As a result, rheological properties at the microscale can vastly differ from bulk rheological properties due to non-continuum effects. To further develop our understanding of blood microflow; experimental techniques should be explored. In this work, we explore micro-particle image velocimetry (μPIV) and two-beam fluorescence cross-correlation spectroscopy (2bFCCS) in the application of characterizing blood in microflow conditions. For the development of the μPIV analysis, a polydimethylsiloxane co-flow channel is used to observe blood flow in controlled conditions. Flow conditions (velocity profile and blood layer thickness) are selected based on an analytical model and compared to experimental measurement. The experimental results presented indicate that current flow conditions are inadequate in providing a controlled rate of shear on the blood layer in the co-flow channel and further optimization are required to improve the measurement of the velocity profile. For the development of the 2bFCCS application for blood flow analysis, a wide glass capillary microfluidic device is used to complete the verification of fluorescence fluid admissibility, the effect of laser intensity on inducing photobleaching and the velocity measurement performance. The experimental measurement of the velocity profile is validated against the theoretical profile for a rectangular channel. Results of the velocity profile of high concentration red blood cells show promise in the technique’s ability to measure blood microflows closer to physiological conditions.