Chickpea (Cicer arietinum L.) production on the semi-arid Canadian Prairies is challenging due to a short growing season and low and variable moisture. The current recommended chickpea population density of 44 plants m-2 is based on preliminary studies and a narrow range of 20 to 50 plants m-2. The aims of this study were to i) determine optimum population density of varying chickpea canopy types, i.e., leaf type and growth habit, by investigating seed yield responses at 30 to 85 plants m-2 and ii) identify desirable parental traits for breeding programs by assessing growth and yield parameter responses to varying leaf types and growth habits at a range of population densities. Field experiments were conducted from 2002 to 2005. Canopy measurements and calculated variables included light interception, biomass, growth rate, seed yield, harvest index, ascochyta blight severity and radiation- and water use efficiencies. The plant density which produced the highest seed yield when averaged over years for each location for each treatment revealed that a plant density of at least 55 plants m-2 produced a 23% to 49% seed yield increase above that of the currently recommended plant density. This indicates that a higher seed yield average over the long term in spite of periodic low seed yield episodes will be more profitable to producers. Increasing plant density increased lowest pod height significantly in all except one location-year but did not explicitly increase ascochyta blight severity or decrease individual seed size. This suggests that increasing the recommended chickpea plant density on the Canadian Prairies will increase seed yield but would neither negatively impact individual seed size nor ascochyta blight severity, especially, when combined with good agronomic practices. Fern-leaved cultivars had significantly higher maximum intercepted light (62 to 91%), seed yield (136 to 369 g m-2), harvest index (0.33 to 0.53), yield-based water use efficiency (0.56 to 1.06 g m-2 mm-1) and lower ascochyta blight severity (3 to 27%) than the unifoliate cultivars in all location-years. The fern-leaved cultivars also tended to show significantly higher cumulative intercepted radiation (221 to 419 MJ m-2) and biomass (306 to 824 g m-2) but leaf type showed no consistent effect on radiation use efficiency. Cultivars with bushy growth habit generally performed better regarding maximum intercepted light (62 to 90%), cumulative intercepted radiation (233 to 421 MJ m-2), biomass (314 to 854 MJ m-2), seed yield (120 to 370 g m-2), harvest index (0.37 to 0.50), yield-based water use efficiency (0.56 to 1.06 g m-2 mm-1) and ascochyta blight severity (7 to 36%) than the erect cultivars. The overall performance of the spreading cultivar was generally intermediate between the bushy and erect cultivars except for ascochyta blight severity where the spreading cultivar exhibited significantly lower disease severity (3 to 36%). Radiation use efficiency was generally not influenced by growth habit. Increasing plant population density generally increased intercepted light, biomass and cumulative intercepted radiation on each sampling day after seeding resulting in a general increase in seed yield. Harvest index, however, remained constant and ascochyta blight severity was generally stable but radiation use efficiency decreased with increasing population density. Chickpea cultivars with fern leaves and bushy growth habit at higher than currently recommended population densities would best utilize the limited resources of the short-season Canadian prairie environment to maximize and stabilize seed yield.

Differences in pea (Pisum sativum L.) and chickpea (Cicer arietinum L.) microbial compatibility and/ or their associated farming practices may influence root fungi of the following crop and affect the yield. The main objective of this research was to explain the difference in durum wheat (Triticum turgidum L.) yield the year after pea and chickpea crops through changes in the functional diversity of wheat root fungi. The effect of fungicides used on chickpea on the root fungi of a following durum wheat crop was studied using plate culture and pyrosequencing. Pyrosequencing detected more Fusarium spp. in the roots of durum wheat after fungicide-treated chickpea than in non-fungicide treated chickpea. Plate culture revealed that the functional groups of fungi responded differently to fungicide use in the field but the effect on total community was non-significant. Highly virulent pathogens were not affected, but antagonists were suppressed. More fungal antagonists were detected after the chickpea CDC Luna than CDC Vanguard. Fungal species responded differently to the use of fungicides in vitro, but the aggregate inhibition effect on antagonists and highly virulent pathogens was similar. The effect of chickpea vs. pea previous crop and different chickpea termination times on root fungi of a following durum wheat crop was studied. The abundance of Fusarium spp. increased after cultivation of both cultivars of chickpea as compared to pea according to pyrosequencing and was negatively correlated with durum yield. Plate culture analysis revealed that fungal antagonists were more prevalent after pea than both cultivars of chickpea and chickpea CDC Vanguard increased the abundance of highly virulent pathogens. The abundance of highly virulent pathogens in durum wheat roots was negatively correlated to durum yield. Early termination of chickpea did not change the community of culturable fungi in the roots of a following durum crop. It is noteworthy that Fusarium redolens was identified for the first time in Saskatchewan and its pathogenicity was confirmed on durum wheat, pea and chickpea. The classical method of root disease diagnostics in cereals is based on the examination of the subcrown internode. I evaluated the method by comparing the fungal communities associated with different subterranean organs of durum wheat. The fungal community of the subcrown internode was different from that of roots and crown, suggesting cautious use of this method.

Chickpea (Cicer arietinum L.) production on the semi-arid Canadian Prairies is challenging due to a short growing season and low and variable moisture. The current recommended chickpea population density of 44 plants m-2 is based on preliminary studies and a narrow range of 20 to 50 plants m-2. The aims of this study were to i) determine optimum population density of varying chickpea canopy types, i.e., leaf type and growth habit, by investigating seed yield responses at 30 to 85 plants m-2 and ii) identify desirable parental traits for breeding programs by assessing growth and yield parameter responses to varying leaf types and growth habits at a range of population densities. Field experiments were conducted from 2002 to 2005. Canopy measurements and calculated variables included light interception, biomass, growth rate, seed yield, harvest index, ascochyta blight severity and radiation- and water use efficiencies. The plant density which produced the highest seed yield when averaged over years for each location for each treatment revealed that a plant density of at least 55 plants m-2 produced a 23% to 49% seed yield increase above that of the currently recommended plant density. This indicates that a higher seed yield average over the long term in spite of periodic low seed yield episodes will be more profitable to producers. Increasing plant density increased lowest pod height significantly in all except one location-year but did not explicitly increase ascochyta blight severity or decrease individual seed size. This suggests that increasing the recommended chickpea plant density on the Canadian Prairies will increase seed yield but would neither negatively impact individual seed size nor ascochyta blight severity, especially, when combined with good agronomic practices. Fern-leaved cultivars had significantly higher maximum intercepted light (62 to 91%), seed yield (136 to 369 g m-2), harvest index (0.33 to 0.53), yield-based water use efficiency (0.56 to 1.06 g m-2 mm-1) and lower ascochyta blight severity (3 to 27%) than the unifoliate cultivars in all location-years. The fern-leaved cultivars also tended to show significantly higher cumulative intercepted radiation (221 to 419 MJ m-2) and biomass (306 to 824 g m-2) but leaf type showed no consistent effect on radiation use efficiency. Cultivars with bushy growth habit generally performed better regarding maximum intercepted light (62 to 90%), cumulative intercepted radiation (233 to 421 MJ m-2), biomass (314 to 854 MJ m-2), seed yield (120 to 370 g m-2), harvest index (0.37 to 0.50), yield-based water use efficiency (0.56 to 1.06 g m-2 mm-1) and ascochyta blight severity (7 to 36%) than the erect cultivars. The overall performance of the spreading cultivar was generally intermediate between the bushy and erect cultivars except for ascochyta blight severity where the spreading cultivar exhibited significantly lower disease severity (3 to 36%). Radiation use efficiency was generally not influenced by growth habit. Increasing plant population density generally increased intercepted light, biomass and cumulative intercepted radiation on each sampling day after seeding resulting in a general increase in seed yield. Harvest index, however, remained constant and ascochyta blight severity was generally stable but radiation use efficiency decreased with increasing population density. Chickpea cultivars with fern leaves and bushy growth habit at higher than currently recommended population densities would best utilize the limited resources of the short-season Canadian prairie environment to maximize and stabilize seed yield.