1 |
Inline rise-time measurement using amplitude histograms for fiber-optic communication systems /Chen, Hui. January 2003 (has links)
Thesis (M. Phil.)--Hong Kong University of Science and Technology, 2003. / Includes bibliographical references (leaves 64-66). Also available in electronic version. Access restricted to campus users.
|
2 |
Using Transverse Optical Patterns for Ultra-Low-Light All-Optical SwitchingDawes, Andrew M. C. January 2008 (has links)
Thesis (Ph. D.)--Duke University, 2008.
|
3 |
Spread spectrum techniques for distributed multimeasurand optical fiber sensors /K. C., Ravikumar, January 1993 (has links)
Thesis (M.S.)--Virginia Polytechnic Institute and State University, 1993. / Vita. Abstract. Includes bibliographical references (leaves 81-82). Also available via the Internet.
|
4 |
Evaluation of spectrally efficient indoor optical wireless transmission techniquesFath, Thilo Christian Martin January 2014 (has links)
Optical wireless communications (OWC) has the potential to become a remedy for the shortage of the radio frequency (RF) spectrum. Especially in indoor environments, OWC could enable wireless home networking systems which offload data traffic from existing RF systems. In OWC, data is transmitted by modulating the intensity of light sources, typically incoherent light emitting diodes (LEDs). Thus, OWC systems employ intensity modulation (IM) and direct detection (DD) of the optical carrier. Since off-the-shelf LEDs have a limited modulation capability, the transmission bandwidth of practical OWC systems is restricted. Consequently, the available bandwidth has to be used efficiently. In this thesis, spectrally efficient optical wireless transmission techniques are evaluated. Firstly, multiple transmitter-receiver techniques are investigated. These multiple-input-multiple-output (MIMO) techniques provide high spectral efficiency, and therefore high data rates. Specifically, the MIMO techniques repetition coding (RC), spatial multiplexing (SMP) and spatial modulation (SM) are analysed for indoor OWC. The performance of these techniques is evaluated analytically and by means of computer simulations. It is shown that inducing power imbalance between the multiple optical transmitters can substantially improve the performance of optical MIMO techniques as the power imbalance improves the differentiability of the multiple channels. In addition, it is found that link blockage and the utilisation of transmitters having different optical wavelengths enhance channel differentiability as well. These methods enable the utilisation of optical MIMO techniques under conditions which typically disallow the application of MIMO schemes due to little differences between the multiple links. Secondly, a novel optical wireless transmitter concept is developed. This concept uses discrete power level stepping to generate intensity modulated optical signals, such as orthogonal frequency division multiplexing (OFDM) waveforms. The transmitter consists of several on-off-switchable LED groups which are individually controlled to emit scaled optical intensities. As a result, the digital-to-analogue conversion of the signals to be sent is done in the optical domain. This method enables the implementation of low-complex and power-efficient optical transmitter front-ends – the major shortcoming of conventional optical OFDM transmitters. Thirdly, a novel approach for wireless data transmission within an aircraft cabin is presented. The data is transferred by 2-dimensional visual code sequences. These sequences are displayed on the in-flight entertainment (IFE) screen and are captured by the built-in camera of a user device which acts as receiver. Transmission experiments within an aircraft cabin mock-up demonstrate the functionality of the implemented system under realistic conditions, such as ambient illumination and geometric configuration. Altogether, this thesis has analysed the potential of spectrally efficient optical wireless transmission techniques. It is shown that OWC systems can greatly benefit from these techniques.
|
5 |
High speed energy efficient incoherent optical wireless communicationsTsonev, Dobroslav Antonov January 2015 (has links)
The growing demand for wireless communication capacity and the overutilisation of the conventional radio frequency (RF) spectrum have inspired research into using alternative spectrum regions for communication. Using optical wireless communications (OWC), for example, offers significant advantages over RF communication in terms of higher bandwidth, lower implementation costs and energy savings. In OWC systems, the information signal has to be real and non-negative. Therefore, modifications to the conventional communication algorithms are required. Multicarrier modulation schemes like orthogonal frequency division multiplexing (OFDM) promise to deliver a more efficient use of the communication capacity through adaptive bit and energy loading techniques. Three OFDM-based schemes – direct-current-biased OFDM (DCO-OFDM), asymmetrically clipped optical OFDM(ACO-OFDM), and pulse-amplitude modulated discrete multitone (PAM-DMT) – have been introduced in the literature. The current work investigates the recently introduced scheme subcarrier-index modulation OFDM as a potential energy-efficient modulation technique with reduced peak-to-average power ratio (PAPR) suitable for applications in OWC. A theoretical model for the analysis of SIM-OFDMin a linear additive white Gaussian noise (AWGN) channel is provided. A closed-form solution for the PAPR in SIM-OFDM is also proposed. Following the work on SIM-OFDM, a novel inherently unipolar modulation scheme, unipolar orthogonal frequency division multiplexing (U-OFDM), is proposed as an alternative to the existing similar schemes: ACO-OFDMand PAM-DMT. Furthermore, an enhanced U-OFDMsignal generation algorithm is introduced which allows the spectral efficiency gap between the inherently unipolar modulation schemes – U-OFDM, ACO-OFDM, PAM-DMT – and the conventionally used DCO-OFDM to be closed. This results in an OFDM-based modulation approach which is electrically and optically more efficient than any other OFDM-based technique proposed so far for intensity modulation and direct detection (IM/DD) communication systems. Non-linear distortion in the optical front-end elements is one of the major limitations for high-speed communication in OWC. This work presents a generalised approach for analysing nonlinear distortion in OFDM-based modulation schemes. The presented technique leads to a closed-form analytical solution for an arbitrary memoryless distortion of the information signal and has been proven to work for the majority of the known unipolar OFDM-based modulation techniques - DCO-OFDM, ACO-OFDM, PAM-DMT and U-OFDM. The high-speed communication capabilities of novel Gallium Nitride based μm-sized light emitting diodes (μLEDs) are investigated, and a record-setting result of 3.5Gb/s using a single 50-μm device is demonstrated. The capabilities of using such devices at practical transmission distances are also investigated, and a 1 Gb/s link using a single device is demonstrated at a distance of up to 10m. Furthermore, a proof-of-concept experiment is realised where a 50-μm LED is successfully modulated using U-OFDM and enhanced U-OFDM to achieve notable energy savings in comparison to DCO-OFDM.
|
6 |
Active optical filters based integrated photonic circuits /Tong, Jian, January 2006 (has links)
Thesis (Ph. D.)--University of Texas at Dallas, 2006. / Includes vita. Includes bibliographical references (leaves 51-54).
|
7 |
Event-driven dynamic power-on for Giga-bit very short reach optical transceiversWang, Xingle. January 2006 (has links)
Thesis (Ph.D.)--University of Delaware, 2006. / Principal faculty advisor: Fouad Kiamilev, Dept. of Electrical and Computer Engineering. Includes bibliographical references.
|
8 |
Versatile photonic processor based on fiber optical parametric amplifiersLiang, Yu, January 2009 (has links)
Thesis (M. Phil.)--University of Hong Kong, 2009. / Includes bibliographical references. Also available in print.
|
9 |
Optical multiple input and multiple output (MIMO) in multimode fibreLi, Ran January 2013 (has links)
Recently, there has been a dramatic increase in the amount of data transmission within short range local area networks (LAN). Multimode fibre (MMF) is widely used in local area networks because of its coupling and alignment along with the low cost of related components. Graded index MMF has become common due to the reduction in pulse spreading; however, as demands for high bandwidth increase towards a future gigabit rate network, the typical MMF using conventional transmission methods will not be suitable. Meanwhile, this increasing demand for high speed data transmission will soon reach the Shannon capacity limit of single mode fibres. After multiple input and multiple output (MIMO) technology was successfully used in wireless communication, the researcher realised that the same idea could also be applied to an optical fibre network. Optical MIMO techniques are gaining interest in order to create parallel channels over orthogonal modes in a MMF or a few mode fibre (FMF). This approach could lead to a significant increase in the bandwidth distance product and be employed in the next 40Gb/s or even 100Gb/s optical fibre transmission systems. Generally speaking, optical MIMO appears to be the best solution to the bandwidth limitation problem in either short distance MMF or long distance FMF systems. This thesis focuses on designing a simple, cost-effective, and energy efficient optical MIMO system based on MMFs. This proposed system can be realised by combining radial offset launching and annular multi-segment detectors. First, in the initial work, we performed a theoretical and numerical study of the key impairments of MMFs, and the mode propagation in an MMF was analysed mathematically. The variation in electrical field intensity for linearly polarised (LP) modes in the core region of an MMF and the analytical solutions for power coupling coefficients in either radial offset launching or centre launching were presented. In addition, the modal time delays, impulse response, and transfer function were all introduced. Subsequently, the near field intensity pattern (NFP) was simulated at the output facet of the MMF, which indicated that the overall NFP suffered from blurring when it contained mode mixing, and that the intensity pattern was particularly sensitive to the random phase. According to the spatial distribution of the NFP, the annular detector can be exploited more efficiently. All of the results were calculated and plotted using the MATLAB program. Secondly, the optical MIMO model in the multimode fibre was briefly summarised, including the MIMO channel matrix H expression, a mathematical expression of optical MIMO capacity, MIMO channel estimation and an equalization method. Two metrics can be used to characterise the MIMO channel performance: condition number and crosstalk at each receiver. The numerical results demonstrated that the new type of annular multi-segment detector exhibits superior performance compared to the conventional multiple single mode fibre (SMF) detectors, making them attractive for future optical MIMO systems. Finally, the core work of this thesis can be divided into two parts: the modelling of a 10Gb/s intensity modulation direct detection (IM-DD) optical MIMO MMF system; and the modelling of an advanced 10Gb/s coherent differential phase shift keying (DPSK) MIMO FMF system. In both simulation systems, the important transmission parameters of intra-group mode mixing, modal dispersion, chromatic dispersion, and mode attenuation were considered and discussed in detail. In the IM-DD optical MIMO system, the optimization of the transceiver can be based upon the laser spot size and the power flux distribution emitted by the transmitter. Results from the simulation showed that the intra-group mode mixing had a limited impact on system performance, and due to its inability to compensate for linear impairments, the IM-DD optical MIMO was not favourable for long distance transmission systems. Nevertheless, the new type of optical fibre FMF seems to be the most promising candidate for use in long haul transmission systems. Therefore, the well-known DPSK modulation format in conjugation with the coherent detection deployed in FMF was studied. Both heterodyne and intradyne detection schemes were analysed followed by mathematical derivation and numerical simulation; the results illustrated that similar system performances can be achieved in both schemes. Meanwhile, the coherent DPSK simulation results also demonstrated that the linear impairments were almost compensated by the frequency domain MIMO equalization process, which resulted in system performance being independent to transmission distance for up to 10km. This advantage proved that the coherent optical DPSK MIMO system can be employed in long haul networks. As with an IM-DD optical MIMO system, optimization of a coherent MIMO system was also possible. However, in contrast to the optimization of an IM-DD MIMO system, a trade-off had to be made between sufficient spatial diversity at the transceiver and differential modal delay caused by modal dispersion; consequently, the numerical results showed that the proposed coherent optical DPSK MIMO gained reasonable good results without using any active device, such as a spatial light modulator and a mode converter. In conclusion, this proposed optical MIMO system provided easy implementation and integration and is feasible for use in future optical communication systems.
|
10 |
Lightpath topology configuration for wavelength-routed IP/MPLS networks in a multi-layered environment integrated models, algorithms, and analysis /Agrawal, Gaurav, Medhi, Deepankar. January 2007 (has links)
Thesis (Ph. D.)--School of Computing and Engineering. University of Missouri--Kansas City, 2007. / "A dissertation in computer networking and telecommunication networking." Advisor: Deep Medhi. Typescript. Vita. Title from "catalog record" of the print edition Description based on contents viewed Jan. 24, 2008. Includes bibliographical references (leaves 130-138). Online version of the print edition.
|
Page generated in 0.1162 seconds