No description available.

Concrete undergoes volumetric changes throughout its service life. These changes are a result of applied loads and shrinkage. Applied loads result in an instantaneous recoverable elastic deformation and a slow, time dependent, inelastic deformation called creep. Creep without moisture loss is referred to as basic creep and with moisture loss is referred to as drying creep. Shrinkage is the combination of autogeneous, drying, and carbonation shrinkage. The combination of creep, shrinkage, and elastic deformation is referred to as total strain. The prestressed concrete beams in the Chickahominy River Bridge have been fabricated with a lightweight, high strength concrete mixture (LTHSC). Laboratory test specimens have been cast using the concrete materials and mixture proportions used in the fabrication of the bridge beams. Two standard cure and two match cure batches have been loaded for 329 and 251 days, respectively. Prestress losses are generally calculated with the total strain predicted by the American Concrete Institute Committee 209 recommendations, ACI 209, or the European design code, CEB Model Code 90. Two additional models that have been proposed are the B3 model by Bazant and Baweja, and the GL2000 model proposed by Gardner and Lockman. The four models are analyzed to determine the most precise model for the LTHSC mixture. Only ACI 209 considered lightweight aggregates during model development. GL2000 considers aggregate stiffness in the model. ACI 209 was the best predictor of total strain and individual time dependent deformations for the accelerated cure specimens. CEB Mode Code 90 was the best predictor of total strain for the standard cure specimens. The best overall predictor of time dependent deformations was the GL2000 model for the standard cure specimens. / Master of Science

Concrete experiences volume changes throughout its service life. When loaded, concrete experiences an instantaneous recoverable elastic deformation and a slow inelastic deformation called creep. Creep of concrete is composed of two components, basic creep, or deformation under load without moisture loss and drying creep, or deformation under drying conditions only. Deformation of concrete in the absence of applied load is often called shrinkage. The deformation due to creep is attributed to the movement of water between the different phases of the concrete. When an external load is applied, it changes the attraction forces between the cement gel particles. This change in the forces causes an imbalance in the attractive and disjoining forces. However, the imbalance is gradually eliminated by the transfer of moisture into the pores in cases of compression, and away from the pores in cases of tension. Designs typically use one of the two code models to estimate creep and shrinkage strain in concrete, ACI 209 model recommended by the American Concrete Institute or the CEB 90 Eurocode 2 model recommended by the Euro-International Committee. The ASSHTO LRFD is based on the ACI 209 model. Three other models are the B3 model, developed by Bazant; the GZ model, developed by Gardner; and the SAK model developed by Sakata. The development of concrete performance specifications that limit the amount of compressive creep of concrete mixtures used by the Virginia Department of Transportation, specifically concrete mixtures used for prestressed members (A-5 Concrete) were assessed, along with determining the accuracy and precision of the creep models presented in the literature. The CEB 90 Eurocode 2 model for creep and shrinkage is the most precise and accurate predictor. The total strain for the VDOT portland cement concrete mixtures discussed in this study were found to be between 1200 ± 110 microstrain at 28 days, and 1600 ± 110 microstrain at 97 days, at a five percent significant level. / Master of Science