Continental rifting ultimately creates a deep accommodation space for sediment. When a major river flows into a late-stage rift, thick deltaic sediment can change the thermal regime and alter the mechanisms of extension and continental breakup. The Salton Trough, the northernmost rift segment of the Gulf of California plate boundary, has experienced the same extension as the rest of the Gulf, but is filled to sea level by sediment from the Colorado River. Unlike the southern Gulf, seafloor spreading has not initiated. Instead, seismicity, high heat flow, and minor volcanoes attest to ongoing rifting of thin, transitional crust. Recently acquired controlled-source seismic refraction and wide-angle reflection data in the Salton Trough provide constraints upon crustal architecture and active rift processes. The crust in the central Salton Trough is only 17-18 km thick, with a strongly layered but relatively one-dimensional structure for ~100 km in the direction of plate motion. The upper crust includes 2-3 km of Colorado River sediment. The basement below the sediment is interpreted to be similar sediment metamorphosed by the high heat flow and geothermal activity. Meta-sedimentary rock extends to at least 7-8 km depth. A 4-5 km thick layer in the middle crust is either additional meta-sedimentary rock or stretched pre-existing continental crust. The lowermost 4-5 km of the crust is rift-related mafic magmatic material underplated from partial melting in the hot upper mantle. North American lithosphere in the Salton Trough has been almost or completely rifted apart. The gap has been filled by ~100 km of new transitional crust created by magmatism from below and sedimentation from above. These processes create strong lithologic, thermal, and rheologic layering. Brittle extension occurs within new meta-sedimentary rock. The lower crust, in comparison, stretches by ductile flow and magmatism is not localized. This seismic interpretation is also supported by 1D thermal and rheological modeling. In this passive rift driven by far-field extensional stresses, rapid sedimentation keeps the crust thick and ductile, which delays final breakup of the crust and the initiation of seafloor spreading. / Ph. D.

Dense array seismic techniques can be applied to multiple types of seismic data to understand regional tectonic processes via analysis of crustal velocity structure, imaging reflection surfaces, and calculating high-resolution hypocenter locations. The two regions presented here include an intraplate seismogenic fault zone in Virginia and a steep cratonic margin in eastern Oregon and Idaho. The intraplate seismicity study in Virginia consisted of using 201 short-period vertical-component seismographs, which recorded events as low as magnitude -2 during a period of 12 days. Dense array analysis revealed almost no variation in the seismic velocity within the hypocentral zone, indicating that the aftershock zone is confined to a single crystalline-rock terrane. The 1-2 km wide cloud of hypocenters is characterized by a 29° strike and 53° dip consistent with the focal mechanism of the main shock. A 5° bend along strike and a shallower dip angle below 6 km points toward a more complex concave shaped fault zone. The seismic study in Idaho and Oregon was centered on the inversion of controlled-source wide-angle reflection and refraction seismic P- and S-wave traveltimes to determine a seismic velocity model of the crust beneath this part of the U.S. Cordillera. We imaged a narrow, steep velocity boundary within the crust that juxtaposes the Blue Mountains accreted terranes and the North American craton at the western Idaho shear zone. We found a 7 km offset in Moho depth, separating crust with different seismic velocities and Poisson's ratios. The crust beneath the Blue Mountains terranes is consistent with an intermediate lithology dominated by diorite. In the lower crust there is evidence of magmatic underplating which is consistent with the location of the feeder system of the Columbia River Basalts. The cratonic crust east of the WISZ is thicker and characterized by a felsic composition dominated by granite through most of the crust, with an intermediate composition layer in the lower crust. This sharp lithologic and rheologic boundary strongly influenced subsequent deformation and magmatic events in the region. / Ph. D. / Dense array seismic techniques involve using many instruments deployed closely together to record natural or man-made ground shaking. These techniques can be applied to different types of seismic data to understand the regional composition and behavior of the Earth’s crust, and identify locations where earthquakes have occurred. The two regions presented here include a zone in Virginia known to have small earthquakes and a location in eastern Oregon and Idaho where younger crust meets older crust across a very steep boundary. The seismicity study in Virginia consisted of using 201 instruments to record earthquake aftershocks with very small magnitudes during a period of 12 days. Dense array analysis techniques revealed almost no variation in the speed that seismic waves travel within the zone of aftershocks, indicating that the aftershocks are confined to a single crystalline-rock region. The 1-2 km wide zone of sub-surface aftershock locations is consistent with the rupture orientation of the main earthquake on 23 August 2011. The zone’s slightly concave shape indicates a complex region of rock movement. The seismic study in Idaho and Oregon was centered on analyzing seismic waves that are generated by explosions and travel through the crust, bending and reflecting when they pass through variations in the rock. We imaged a narrow, steep boundary that juxtaposes the younger Blue Mountains crust and the older North American craton at the western Idaho shear zone (WISZ). We found a sharp ~7 km step between the thicknesses of the two regions and different seismic velocities on either side of the boundary. The crust beneath the Blue Mountains terranes is consistent with an intermediate rock type dominated by diorite. In the lower crust there is evidence of a layer that is consistent with un-erupted material from the Columbia River Basalts. The continental crust east of the WISZ is thicker and dominated by granite through most of the crust, with an intermediate composition layer in the lower crust. This sharp boundary strongly influenced subsequent deformation and magmatic events in the region.

Abstract The crustal and upper mantle structures of the Shield on the regional scale were investigated using the data of the POLENET/LAPNET passive seismic array and the previously published models of active and passive seismic experiments in the study area. This area is centred in northern Finland and it extends to surrounding areas in Sweden, Norway and northwestern Russia. The bedrock there is mostly of the Archaean origin and the lithosphere of the region was reworked by two orogenies during Palaeoproterozoic. One of the results of the thesis was a new map of the Moho depth of the study area, for which new estimates of the crustal thickness were obtained using receiver function method and complemented by published results of receiver function studies and controlled source seismic profiles. The map differs from the previously published maps in two locations, where we found significant deepening of the Moho. The 3D structure of the upper mantle was studied using teleseismic traveltime tomography method. The resulting model shows high seismic velocities below three cratonic units of the study area, which may correspond to non-reworked fragments of cratonic lithosphere and a low velocity anomaly separating these cratonic units from each other. The regional scale studies were complemented by two smaller scale studies in upper crust level using combined interpretation of seismic profiling and gravity data. These studies were centred on Archaean Kuhmo Greenstone Belt in eastern Finland and central Lapland in northern Finland located in the crust reworked during Palaeoproterozoic. Both areas are considered as prospective ones for mineral exploration. Both studies demonstrate the advantage of gravity data inversion in studying 3D density structure of geologically interesting formations, when the Bouguer anomaly data is combined with a priori information from petrophysical and seismic datasets.