Global ETD Search

11	Laser assisted machining of high chromium white cast-iron Armitage, Kelly. January 2006 (has links) Thesis (MEng) - Swinburne University of Technology, Industrial Research Institute Swinburne - 2006. / A thesis submitted in fulfillment of the requirement for the degree of Master of Engineering by Research, Industrial Research Institute Swinburne, Faculty of Engineering and Industrial Sciences, Swinburne University of Technology - 2006. Typescript. Includes bibliographical references (p. 113-116). Laser beam cutting. Metal-cutting.
12	Dynamic cutting process identification by Dynamic Data System (DDS) models Ahn, Tai Young. January 1982 (has links) Thesis (Ph. D.)--University of Wisconsin--Madison, 1982. / Typescript. Vita. eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references (leaves 270-277). Metal-cutting. Metal-cutting tools.
13	Technicko-ekonomické srovnání tavného a oxidačního způsobu laserového dělení ocelových plechů pevnolátkovým laserem (ACO) / Techno-economical comparison of the fusing and flame method of laser cutting of steel sheets with a solid-state laser Vojteková, Lucia January 2018 (has links) The aim of diploma thesis is a comparison of flame and fusion laser cutting of thin metal sheets for ACO Industries k. s. company, where the experimental part was also realized. After consultation with company, the thesis was extended by data samples, which were cut by compressed air for comparison with other two gases. The optimization design of cutting parameters was created by Taguchi method. Afterwards the surface roughness of samples was measured. Based on Ra and Rz5 parameters, the samples were classified to classes based on their accuracy according to ISO 9013 standard. According to results the fusion method of laser cutting is more suitable method, especially for its good quality of cutting edge, which is not affected by the oxidic layer. Fusion method uses cutting speed two times higher than the flame method, which leads to decrease of time and financial consumption of the process despite of its higher hourly rate. In case of laser cutting of material by compressed air the quality of cut is insufficient in comparison with fusion or flame cutting method.
14	Investigation on the adaptive control with pressure feedback in electrochemical machining Karima, Medhat. January 1975 (has links) No description available. Electrochemical cutting. Electrochemical apparatus. Electric cutting machinery.
15	Assessment of metal machining process parameters and the development of adaptive control / Audy, Jaromir Unknown Date (has links) Thesis (PhD in Metallurgical Engineering)--University of South Australia, 1996 Cutting machines. Mechanical wear. Metal-cutting tools.
16	Assessment of metal machining process parameters and the development of adaptive control / Audy, Jaromir Unknown Date (has links) Thesis (PhD in Metallurgical Engineering)--University of South Australia, 1996 Cutting machines. Mechanical wear. Metal-cutting tools.
17	Multi-axis milling of flexible parts / Abrari, Farid. January 1998 (has links) Thesis (Ph.D.) -- McMaster University, 1998. / Includes bibliographical references (p. 149-156). Also available via World Wide Web.
18	Investigation on the adaptive control with pressure feedback in electrochemical machining Karima, Medhat. January 1975 (has links) No description available. Electrochemical cutting. Electrochemical apparatus. Electric cutting machinery.
19	Factors affecting wear land stress in metal cutting 潘榮光, Pun, Wing-kwong, Digby. January 1988 (has links) published_or_final_version / Industrial Engineering / Doctoral / Doctor of Philosophy Metal-cutting. Mechanical wear.
20	Micro-mechanisms of ductile fracture Druiff, Helen January 1990 (has links) No description available. 620.11223 Steel cutting

Search results