Via the viewpoint of fuel and oxidant supply in this study, we compare heterogeneous carbon fiber bipolar plates with graphite bipolar plates that apply to fuel cell. In operating condition with different gas inlet pressure and compressing pressure, we study the penetrability of reactant gases that come into the carbon cloth under the rib of a bipolar plate. Eventually the output voltage and power density are measured to prove the advantages of the new bipolar plate. The experimental results show that carbon fiber bipolar bunch in low compressing pressure 2bar already display high gas penetrability. Its dimensionless flow rate is about quadruple of graphite bipolar plates. The reactant gas can enter the carbon cloth either from the side or from the top of the penetrating carbon fiber bipolar bunch. In addition, carbon fiber bipolar plates are affected slightly by compressing pressure. Further, the total electrical resistant of carbon fiber bipolar plates with carbon cloth already decreases to 18.5mΩ*cm² in low compressing pressure 2bar. Therefore, by appling the new bipolar plate, the fuel cell in compressing pressure 2bar and inlet fuel pressure 1.15bar(absolute pressure) can developed a power rate 180mW/cm². Concerning graphite bipolar plates, we can find that compressing pressure increase from 1bar to 4bar due to the reduction in total resistance so the output voltage and power density can increase to maximum value 113mW/cm2. However, while we augment more compressing pressure, the influence in reducing total resistance is much smaller than that in reducing the porosity of carbon cloth. Therefore, the output power density decreases. Also, output voltage of carbon fiber bipolar plates at 0.5mA/cm2 is 0.38 V and is higher than that of graphite bipolar plate 0.2 V.