Symmetric nonaqueous redox flow batteries (RFBs) use negative and positive battery solutions of the same solution composition to operate at high cell voltages. This research effort targets these systems since they offer performance improvements derived from using nonaqueous systems and symmetric active species. Nonaqueous solutions permit significantly higher cell voltages than state-of-the-art aqueous RFBs and symmetric active species chemistries reduce the required complexity of cell reactors. Both performance advantages correspond to significant cost improvements beyond already commercially competitive aqueous RFB chemistries. This document focuses on two classes of symmetric nonaqueous RFB chemistries: coordination complexes such as vanadium acetylacetonate [V(acac)₃] or chromium acetylacetonate [Cr(acac)₃], and organic active species such as 9,10-diphenylanthracene (DPA). V(acac)₃ delivers reversible electrochemistry that supports a 2.2 V equilibrium cell potential, but there are some gaps in the understanding of its degradation mechanisms. Cr(acac)₃ supports redox reactions that suggest cell potentials above 4 V, but shows signs of irreversibility in voltammetry experiments and is not yet well understood. Finally, the DPA system could be interesting because it does not use metal active species, and its voltammetry promises cell potentials above 3 V. Yet DPA suffers from low solubility in nonaqueous solvents that limit its practicality. These three systems show promise for symmetric nonaqueous RFBs and offer avenues for further improvement. Voltammetry and spectroelectrochemical electrolysis experiments on the metal coordination complexes clarify the mechanisms behind the voltammetry on these symmetric chemistries. Ligand dissociation causes the irreversible behavior observed in voltammetry on Cr(acac)₃. The same experiments reaffirm the expected cyclability of V(acac)₃. Chemical functionalization of the DPA center is performed to investigate the solubility and reactivity of various derivatives. Functionalizing DPA with ethylene glycol chains to form 'DdPA' significantly increases solubility limits from 0.6 mM and 44 mM for DPA in acetonitrile and 1,2-dimethoxyethane, respectively, to 12 mM and 0.21 M for DdPA in the same solvents. At the same time, DdPA retains redox activity that promises 3 V cell potentials. Ultimately, a custom, nonaqueous-compatible redox flow reactor was designed and used to test the performance of V(acac)₃, DPA, and DdPA under various operating conditions. Contradicting previous reports, V(acac)₃ delivers stable cycling over the 21- cycle experimental protocol. Exploration over a range of flow rates and current densities give energy and power densities up to 1.09 WhL^-1 and 0.16 Wcm^-2, respectively, for the battery solution compositions examined. These experiments further predict values up to 28 WhL^-1 and at least 0.22 Wcm^-2 for optimized V(acac)₃ battery solutions. DPA and DdPA deliver the highest operating potential observed from organic nonaqueous RFBs, discharging at 3 V and 2.9 V, but require further work to understand degradation in the systems.

Les objectifs de cette thèse sont articulés autour de deux axes principaux : la synthèse et l’étude de cages moléculaires photo-modulables, et la génération de nano-cristaux d’or par photo-catalyse supramoléculaire. Ces deux thématiques sont reliées entre elles par l’exploitation des propriétés photophysiques et photochimiques d’un motif commun, le 9,10-diphénylanthracène (DPA). Dans un premier temps, de nouvelles architectures tridimensionnelles photo-modulables de type cage moléculaire ont été conçues et étudiées. En présence d’oxygène, l’irradiation directe ou sensibilisée du DPA permet de former réversiblement le dérivé endoperoxyde et ainsi moduler les propriétés de complexation de la cage. Les différentes stratégies de synthèse mises en place reposent sur l’exploitation conjuguée de la réactivité de la 2,4,6-trichloro-1,3,5-triazine, et de réactions de chimie « click » (métathèse des oléfines, cycloaddition de Huisgen). L’étude et la modulation des propriétés des reconnaissances ont été effectuées sur des sels de cations alcalins (sodium et césium) et suivies par émission de fluorescence et spectroscopie d’absorption UV-visible. Les résultats obtenus avec deux cages possédant des constantes d'associations élevées (logK = 8,7 pour le cation sodium) montrent une augmentation de la constante d’association d’un facteur 10 et 20 pour respectivement le sodium et le césium entre la forme DPA et la forme endoperoxyde. Dans un second temps, des photocatalyseurs supramoléculaires basés sur le chromophore DPA ont été étudiés en vue de la synthèse de nano-cristaux d’or nus. L’association du chromophore avec des thioéthers permet de former un complexe en phase organique par extraction de sels d’or(III) depuis une phase aqueuse. L’irradiation à 400nm permet la réduction de l’or(III) par transfert d’énergie depuis le 9,10-diphénylanthracène. Les atomes d’or sont ensuite relargués en phase aqueuse pour former des nano-cristaux nus qui ont pu être caractérisés par MET, XPS, AFM et DLS. Par ailleurs, ce procédé est catalytique dans le toluène et un système de réduction en flux continu a été mis au point permettant un turnover moyen de 150. / The goals of this thesis are organized around two major axes: the synthesis and study of photo-gated molecular cages, and the generation of gold nanocrystals by supramolecular photocatalysis. These two themes are connected by the use of the photochemical and photophysical properties of a common chromophore, 9,10-diphenylanthracene (DPA). Three-dimensional photo-gated cage-like architectures were designed and synthesized. Various synthetic strategies based on the combined use of the 2,4,6-trichloro-1,3,5-triazine unit and "click" chemistry reactions (olefin metathesis, Huisgen cycloaddition) were employed for the synthesis. In the presence of oxygen, sensitized or direct irradiation of the DPA chromophore forms the corresponding endoperoxide derivative, thereby modulating the binding properties of the cage. The study and the modulation of the recognition properties were performed on various alkali metal cations and a strong binding of sodium and cesium was evidenced by fluorescence emission and UV-visible absorption spectroscopy. The cages investigated possessed high association constants towards sodium and cesium cations (logK = 8.7 for the sodium cation) which could be reversibly increased by a factor 10 and 20 for sodium and cesium, respectively, upon formation of the endoperoxide. Supramolecular photocatalysis of gold(III) reduction based on the DPA chromophore was also studied for the preparation of uncapped gold nanocrystals. The combination of the DPA chromophore with thioether chains allows the formation of a complex in the organic phase by extraction of gold(III) chloride from an aqueous phase. Irradiation at 400 nm enables the reduction gold(III) by energy transfer from the 9,10-diphenylanthracene followed by oxidation of the solvent. The gold atoms are subsequently released in the aqueous phase to form uncapped nanocrystals characterized using TEM, XPS, AFM, and DLS techniques. Furthermore, the process is catalytic in toluene, where a continuous flow reactor was developed. The latter allowed an average catalytic turnover of 150 to be determined.

Mit Lösungen von 9,10-Diphenylanthracen und N(C2H5)4ClO4 oder N(C4H9)4ClO4 als Leitsalz im Lösungsmittel Acetonitril wurden Elektrochemilumineszenz (ECL)-Experimente durchgeführt. Dazu wurden die Elektroden mit Folgen von jeweils drei in bestimmten zeitlichen Abständen aufeinander folgenden Potentialsprüngen polarisiert. Es wird gezeigt, dass bei entsprechender Wahl der Potentiale und der Haltezeiten anodische und kathodische ECL-Emissionen gleicher Intensität erzeugt werden können. Sodann wurde ECL in den Derivaten von Poly(p-phenylen-vinylen), MEH-PPV und DB-PPV erzeugt. Diese leitfähigen Polymere wurden als dünne Schichten auf Platin-Elektroden aufgebracht und wie bei ECL aus der Lösungsphase in Acetonitril-Elektrolyten mit Tetralkylammonium-Leitsalzen Potentialsprüngen unterworfen. Bei geeigneter Einstellung der Potentialsprünge und Haltezeiten konnten anodische und kathodische ECL gleicher Intensität erhalten werden. Dies ist das erste Mal, dass symmetrische ECL mit polymerbeschichteten Elektroden erhalten wurde. Die Kinetik der ECL weicht deutlich von der aus der Lösungsphase ab. Der ECL-Prozess verläuft langsamer als in der Lösungsphase, und der Leitelektrolyt hat einen signifikanten Einfluss auf das elektrochemische Verhalten der Polymerschicht. Die Ursachen dafür wurden über Modellrechnungen analysiert, mit denen die Ladungstransportprozesse in der Polymerschicht simuliert wurden. In derartigen Simulationsrechnungen konnten die Geschwindigkeitskonstanten der ECL-Reaktion sowohl im Polymer als auch in der Lösung bestimmt werden. Um die Stabilität der Polymerschichten zu erhöhen, wurde versucht, die Polymerketten mit Synchrotronstrahlung zu vernetzen. Diese Experimente brachten nicht das erwartete Ergebnis. Die Ursachen dafür werden auf der Grundlage von Ex-Situ-Raman-spektroskopischen Untersuchungen diskutiert. / Electrochemiluminescence (ECL) has been generated in solution phase using 9,10-diphenylanthracene (DPA) with TEAClO4 (or TBAClO4) in acetonitrile solvent. Triple potential step was used for the generation of ECL. It was found that anodic and cathodic ECL of equal intensities can be generated by proper choice of potential step magnitude, width and the waiting period (tw) between successive triple potential steps. ECL was then generated in conducting polymers poly(2-ethylhexyloxy-5-methoxy-1,4-phenylenevinylene) (MEH-PPV) and poly(2,3-dibutoxy-1,4-phenylenevinylene) (DB-PPV) by coating them on Pt electrodes and subjecting to potential steps in tetraalkylammonium salt solutions with acetonitrile. Similar to the case of solution phase ECL, symmetrical anodic and cathodic ECL could be observed by the appropriate choice of the potential step parameters. But the kinetics of the ECL was found to be different from that of the solution phase ECL. The time scale of the ECL process was found to be longer than that in the solution phase ECL. The nature of supporting electrolyte had a remarkable impact on the electrochemistry of conducting polymers. The reasons were analyzed by theoretical calculations evoking the concept of charge transport characteristics of conducting polymers. The rate constants of the ECL process were calculated by separate simulation procedure in the solution phase as well as in the polymer phase ECL. To enhance the stability of conducting polymers, synchrotron radiation induced cross-linking was performed. The effects were different from expected which were analyzed and rationalized by ex-situ Raman spectroscopic studies.