Increasing commercial and military aircraft operations in arid environments are increasing the likelihood of sand and dust ingestion. Turbine engines are particularly susceptible to the ingestion of sand and dust, which can erode cold-section components and deposit onto hot-section components. Ultimately, the erosion and deposits will shorten the operational lifespan of these engines and limit their availability thereby increasing maintenance costs and risking safety. Mitigating these risks has become more prevalent in recent years due to increasing combustion temperatures in effort to increase fuel efficiency. Increasing combustion temperatures directly increases deposit formation onto hot-section components. Monitoring deposit formation on existing turbine engine platforms and improving deposit resilience on new designs has been the industry focus for the last two decades. This study focused on statistically modeling the initial onset of microparticle deposits onto an analogous hot-section surface. Generally, as deposits accumulate onto a hot-section surface, the existing deposit formation is more likely to bond with incoming particulate at a faster rate than an exposed bare surface. Predicting the initial deposits onto a bare surface can determine the accelerated deposition rate depending on subsequent particulate impinging onto the surface. To emulate the initial deposits, a HASTELLOY® X test coupon was exposed to 20 μm to 40 μm samples of Arizona Road Test Dust (ARD) at varying loadings and aerosol densities. The Virginia Tech Aerothermal Rig was used for all test scenarios at flow-particle temperatures between 1000°C to 1100°C. Several statistical models were developed as a function of many independent variables, culminating with a final sticking probability (SP) model. Overall, the SP of individual ARD particulate is a primary function of flow-particle temperature and normal impact momentum. Tangential impact momentum of a particle will decrease the SP, while surface temperatures reaching isothermal conditions with the flow will increase SP. However, there are specific cases where lower surface temperatures and high particle temperatures result in a high SP. Particle size was a strong predictor of SP where particles between 10 μm to 19 μm were 5 to 10 times greater than the 19 μm to 40 μm range. Additional studies will be necessary to examine some additional parameters that become more prominent with smaller particle sizes. Ultimately, the intention of the models is to assist turbine engine designers to improve resilience to deposit formation on hot-section components. / PHD

In the past several decades there has been an increased interest in sand, dust, and ash particulates ingestion study for gas turbine engine applications. Recently, there has been an increase in commercial and military fleets operating in medium to highly dusty environments, such as areas in Africa, the Middle East, and Asia. Dusty environments can cause blockage in turbine cooling circuits which can lead to early engine maintenance or removals. Ingested debris can melt, forming glassy or molten deposits on various hot section components in gas turbine engines. This thesis evaluates the onset of deposit formation using an experimental rig to perform testing in high temperature environment. In general, deposits on turbine components can affect the operating capacity and the overall operating efficiency of gas turbine engines. Particulate ingestion events can be catastrophic and cost millions of dollars in maintenance and repairs. The experimental work in this thesis focused only on quantifying the initial deposit formation in high temperature environment to aid in the development of resilient engine design and operational diagnostics. Testing was performed using HASTELLOY® X coupons and Arizona Road Dust with main gas flow temperatures between 1050°C and 1100°C. Arizona Road Dust sample with sizing between 2µm and 40µm were used for experimental testing. The sensitivity of the initial deposit formation on cooled HASTELLOY® X coupon surface was investigated by using an inline air heater. Three cooling test conditions: no cooling, 500°C cooling, and 250°C cooling, were used to alter the surface temperature of the coupon during testing. Results from testing indicated cooling test conditions used have a small impact on deposit formation. / Master of Science