Spelling suggestions: "subject:"electrooptic probing technique"" "subject:"electroooptic probing technique""
1 |
On-wafer 2-D electric-field-vector measurement using single-beam electro-optic probing techniqueChen, Wei-Hsuan 30 June 2000 (has links)
Electro-Optic(EO) probing techniques are advancing rapidly in recent years due to their superior performance in characterization of semiconductor devices and circuits. Although the conventional systems can only monitor the amplitude distribution of electric field, some advanced EO probing techniques are able to measure not only the electric-field amplitude, but also direction of the electric field. Because valuable information can be released in such as chamfered bending transmission lines, patch antennas and wireless devices, etc., EO probing technique becomes an important tool to the characterization of radio frequency devices. These systems often require two beams or two different EO crystals to differentiate the directions of the electric field under test because only one type of EO modulation, compressed/stretched deformation modulation, is utilized in the measurement. Therefore, the measurements are inaccurate and complicated due to the fact that the path length and EO interaction strength of the two probing beams are different. In this research, we demonstrate the EO probing technique with one beam and one EO crystal to extract 2-D electric-field vector using an additional modulation effect, i.e. rotational deformation modulation. This electric field vector measurement technique is compact, accurate and low cost.
We not only prove that on-wafer 2-D electric-field-vector measurement using single-beam electro-optic probing technique is feasible theoretically and experimentally, but also combine rotational deformation modulation and compressed/stretched deformation modulation to a practical circuit measurement. Commercial software, Ansoft Maxwell 3-D Field Simulator, is employed to verify our measurements. Good agreement is obtained between experiment and simulation results.
In addition to 2-D electric-field-vector measurement, we made an attempt to high-frequency real-time measurement. With the trend of low voltage operation in wireless communication, the most serious issue of high-frequency real-time EO probing technique is the improvement of signal to noise ratio. We tried to improve the stability of laser source, control the polarization of incident beam, and utilize Fabry-Perot filter in order to implement high-frequency real-time measurement. A bandwidth of 900 MHz was achieved, which is record-high to our knowledge.
|
2 |
High Frequency and Near Field Measurement of Electric-field Vector by Electro-optic Probing Technique.Pai, Chin-Hen 27 June 2001 (has links)
^¤åºKn
Electro-optic probing techniques are advancing rapidly in recent years. These techniques have been proven to be an effective tool in parameter extraction of semiconductor devices such as response time, delay time as well as scattering parameters. Not only the magnitude of the electric field but also the direction of the corresponding E-field direction are measured in several developed electro-optic probing system. By incorporated these techniques, the near-field electric field vectors can be estimated and they are valuable information for the analysis of RF circuit devices, e.g., micro-strip transmission line, patch antenna, etc. When probing the 2-D E-field vectors, one can only measure 1-D E-field direction, then rotate the device under test by 90¢X for another orthogonal tangential E-field direction. However the process not only reduces the probing accuracy but also increases the time interval for achieving measurement and lead to obstacles in use.
In the thesis, 2D E-field can be obtained without rotating the DUT by using two kinds of modulation schemes, i.e., compressed/stretched deformation modulation(CSDM) and rotational deformation modulation(RDM). These novel techniques provide a total solution for the above bottleneck and improve the sensitivity for different E-field direction. Besides, a heterodyne method is developed to measure the high frequency near-field 2D E-field distribution. By the heterodyne method, the EO probing system can incorporate the CW laser instead of the pulse laser for reducing the cost and enhancing the merits when applied.
|
Page generated in 0.113 seconds