Spelling suggestions: "subject:"electromagnetic.""
91 |
Swept-Frequency Sampled Grating Distributed Bragg Reflector Lasers Optimized for Optical Coherence Tomography ApplicationsGeorge, Brandon J 01 December 2009 (has links)
Swept Frequency Source Optical Coherence Tomography (OCT) requires high repetition rate and wide spectral width wavelength tunable sources at a low cost. The sampled grating distributed Bragg reflector (SG-DBR) laser provides wide wavelength tuning range while exhibiting a wavelength switching speed that is among the fastest currently available. The SG-DBR laser is used to generate linear frequency ramps with high repetition rates. Since the SG-DBR laser is currently used for the telecommunications industry in high volume, the price of the system is much lower than current OCT sources. Therefore the SG-DBR laser provides a practical solution for Swept Source OCT.
Four synchronized waveforms sent to the inputs of the laser control the linear frequency ramp. Three of the waveforms control the output frequency, while the fourth waveform controls the output amplifier of the laser to keep the output power stable. Two SG-DBR lasers with overlapping wavelength coverage are also concatenated to increase the bandwidth of the swept frequency source.
The linear ramp stitching points in the frequency ramps are investigated and methods are outlined to reduce them. Finally, experimental OCT tests are performed using the swept frequency sources created to analyze the linearity of our sources. From these test results, an evaluation can be made on the specifications and capabilities of the swept frequency sources and analyze their value for OCT applications.
|
92 |
Millimeter-wave Antenna Arrays with High EfficiencyLi, Jiantong January 2021 (has links)
No description available.
|
93 |
Using Leaky Coaxial Cables as Proximity Sensors: Numerical Modeling, Experiments, and InvestigationWang, Zhenyu January 2021 (has links)
No description available.
|
94 |
New Approaches to the Design of Next Generation RF Front End ComponentsSahu, Abhishek January 2018 (has links)
No description available.
|
95 |
COMPARATIVE STUDY OF INDUCTIVE WIRELESS POWER TRANSFERPAD TOPOLOGIES FOR ELECTRIC VEHICLE CHARGINGBiswas, Md Mamun January 2018 (has links)
No description available.
|
96 |
Direct Evaluation of Hyper-singularity in Integral Equation with Adaptive Mesh RefinementPeng, Shaoxin 02 October 2019 (has links)
No description available.
|
97 |
A Nondestructive Method to Identify Integrated Circuits Using a Microwave Cavity ResonatorGildenmeister, Kraig January 2019 (has links)
No description available.
|
98 |
A Three-Phase Overlapping Winding Based Wireless Charging System for Transportation ApplicationsChowdhury, Samir Rafsan 30 April 2021 (has links)
No description available.
|
99 |
Meta-Heuristic Optimization of Antennas for Biomedical ApplicationsHood, Aaron Zachary 14 December 2013 (has links)
Given the proper conditions, antennas applied in medicine can offer improved quality of life to patients. However the human body proves hostile to typical, analytical antenna design techniques as it is composed entirely of frequency- and temperature-dependent lossy media. By combining optimization techniques with numerical methods, many of these challenges may be overcome. Particle swarm optimization (PSO) models the solution process after the natural movement of groups such as swarms of bees as they search for food sources. This meta-heuristic procedure has proven adept at overcoming many challenging problems in the electromagnetics literature. Therefore, this dissertation explores PSO and some of its variants in the solution of two biomedical antenna problems. Recent advances in biosensor technology have led to miniaturized devices that are suitable for in vivo operation. While these sensors hold great promise for medical treatment, they demand a wireless installation for maximum patient benefit, which in turn demands quite specific antenna requirements. The antennas must be composed of biocompatible materials, and must be very small (no more than a few square centimeters) to minimize invasiveness. Here PSO is applied to design a 22.5 mm × 22.5 mm × 2.5 mm implantable serpentine planar inverted-F antenna for dual-band MedRadio and ISM operation. Measurements reveal the accuracy of the models. Hyperthermia is the process of elevating a patient’s temperature for therapeutic gain. Since the ancient Egyptians, physicians have employed hyperthermia in the destruction of cancerous tumors. Modern implementations typically apply electromagnetic radiation at radio and microwave frequencies to induce local or regional heating. In this dissertation PSO is used to evaluate candidate antennas for inclusion in an array of antennas with the aim of local adjuvant hyperthermia for breast cancer treatment. The nearield of the array is then optimized to induce a uniform specific absorption rate throughout the breast.
|
100 |
Analysis and Design of Non-Hermitian Optical SystemsKazemi Jahromi, Ali 01 January 2018 (has links) (PDF)
From a very general perspective, optical devices can be viewed as constructions based on the spatial engineering of the optical index of refraction. Sculpting the real part of the refractive index produces the wide variety of known passive optical devices, such as waveguides, resonators, gratings, among a plethora of other possibilities for managing the transport of light. Less attention has been directed to engineering the imaginary part of the refractive index – that is responsible for optical gain and absorption – in conjunction with the real part of the refractive index. Optical gain is the building block of amplifiers and lasers, while optical absorption is exploited in photovoltaic devices, photodetectors, and as dopants in lasing media. Recently, the field of non-Hermitian photonics has emerged in which the new opportunities afforded by the spatial engineering of the optical gain and loss in an optical device are being exploited. Indeed, the judicious design of such active devices can result in counterintuitive physical effects, new optical functionalities that enable unexpected applications, and enhanced performance of existing devices. In this work, we have theoretically and experimentally demonstrated four different non-Hermitian arrangements exhibiting novel non-trivial features. First, we show that the direction of energy flow can be controlled inside an active cavity by tuning the optical gain. Reversing the direction of the energy flow within the cavity – such that Poynting's vector points backwards towards the source – takes place when the cavity gain exceeds a certain threshold value, which we have named 'Poynting's threshold'. To realize this effect, we have employed a fiber-based arrangement that allows for unambiguous determining of the direction of the energy flow within the cavity. Second, we have studied the implication of Poynting's threshold with respect to spectral reflection from an active cavity. Surprisingly, the reflection at Poynting's threshold becomes spectrally flat and is guaranteed to attain unity reflectivity while maintaining non-zero transmission. In other words, at Poynting's threshold, the cavity becomes a 'transparent perfect mirror'. We have realized this effect in an on-chip active waveguide device and in an optical-fiber-based system. Third, we have examined a parity-time (PT) symmetric fiber-based cavity consisting of two coupled sub-cavities, one of which contains gain and the other loss. In contrast to all previous on-chip PT-symmetric micro-devices, the exotic features of such a system may be expected to vanish when the length of the cavity is extremely large (exceeding 1 km in our experiments) due to the strong fluctuations in the optical phase. Nevertheless, we have found that some of the central features of such a system survive; e.g., loss-induced enhancement of lasing power is still observable. Finally, we have demonstrated – for the first time – the interferometric perfect absorption of light in a weakly absorbing (erbium-doped) fiber system. Additionally, we verified that this coherent effect is the most efficient configuration with respect to utilizing the absorbing species in the medium.
|
Page generated in 0.2805 seconds