Thesis (Ph.D.)--University of Illinois at Urbana-Champaign, 2007. / Source: Dissertation Abstracts International, Volume: 68-11, Section: B, page: 7040. Adviser: Robert M. Skirvin. Includes bibliographical references. Available on microfilm from Pro Quest Information and Learning.

Thesis (Ph. D.)--Pennsylvania State University, 2007. / (UMI)AAI3284934. Source: Dissertation Abstracts International, Volume: 68-10, Section: B, page: 6402.

Thesis (Ph.D.)--University of Illinois at Urbana-Champaign, 2006. / Source: Dissertation Abstracts International, Volume: 67-07, Section: B, page: 3932. Adviser: Yuanhui Zhang. Includes bibliographical references (leaves 135-142) Available on microfilm from Pro Quest Information and Learning.

Master of Science / Department of Biological and Agricultural Engineering / Mei He / Thermobifida fusca, an aerobic moderately thermophilic, filamentous soil bacterium is capable of producing butyric acid. Butyric acid is a 4-carbon short chain fatty acid that is widely used in the chemical, food, and pharmaceutical industries. Currently, butyric acid is primarily produced through petroleum-based chemical synthesis, but could be a candidate to be produced by fermentation. By producing through a fermentation platform, production of butyric acid can be shifted from a non-renewable to a renewable source. In an effort to make T. fusca produce a high yield of butyric acid, multiple fermentation parameters were explored and optimized. The effect of different carbon sources (mannose, xylose, lactose, cellobiose, glucose, sucrose, and acetates) on butyric acid production was studied, where cellobiose produced the highest yield of 0.67 g/g C (g-butyric acid/g-carbon input). The best stir speed and aeration rate for butyric acid production were found to be 400 rpm and 2 vvm in a 5-L fermentor. The maximum titer of 2.1 g/L butyric acid was achieved on 9.66 g/L cellulose. Fermentation was performed on ground corn stover as a substrate to evaluate the production of butyric acid on lignocellulosic biomass, and the optimized conditions resulted in a titer of 2.37 g/L butyric acid. The butyric acid synthesis pathway was identified involving five genes that catalyzed reactions from acetyl-CoA to butanyol-CoA in T. fusca. A study into the transcriptomics of T. fusca was begun by growing T. fusca under a variety of fermentation conditions, isolating the messenger RNA, and performing a sequence of the mRNA using whole transcriptome shotgun sequencing. The results of sequencing of various samples were plotted to determine correlation across numerous fermentation parameters. This correlation based analysis determined that the carbon to nitrogen ratio has the largest overall impact on gene transcription of T. fusca among all of the fermentation parameters studied. Overall, the work from this study proves that production of butyric acid is possible from a renewable cellulosic feedstock.

Doctor of Philosophy / Department of Biological & Agricultural Engineering / Ronaldo G. Maghirang / This research was conducted to investigate the potential of charged-water spray in controlling dust in livestock buildings. Specific objectives were to: (1) develop a method to measure the electrostatic charge of airborne particles; (2) characterize the size distribution and charge of airborne particles in a livestock building; (3) evaluate the effectiveness of charged-water spray in controlling dust concentration in enclosed spaces under laboratory conditions; (4) model the effectiveness of charged-water spray in controlling dust in an enclosed building; and (5) develop and evaluate an electrostatically-assisted particulate wet scrubber (EAPWS). A dynamic Faraday-cage sampler was developed for measuring the net charge-to-mass ratio of particles. The device involves collecting particles on a filter and measuring the charge induced. The sampler was calibrated and then used to measure the charge of dispersed particles (i.e., corn starch, NaHCO3, positively charged water spray, negatively charged water spray, and uncharged water spray). The corresponding net charge-to-mass ratios were -0.11 (SD=0.07), +0.20 (0.001), +7.24 (1.6), -6.47 (0.9), and -0.30 (0.12) mC/kg. Characterization of dust in a swine building showed mean dust concentration of 0.89 (SD=0.45) mg/m3, geometric mean diameter of particles of 9.34 μm, and geometric standard deviation of 2.11. The Faraday-cage sampler was also used in the swine building; the net charge-to-mass ratio of particles was +0.68 mC/kg (SD=0.31 mC/kg). The effectiveness of charged-water spray in reducing dust concentration was investigated in an experimental chamber. Test particles (i.e., corn starch, NaHCO3) were dispersed into the chamber and then charged water was sprayed into the chamber. The charged-water spray was significantly more effective than either the uncharged-water spray or no water spray. The removal efficiency of the charged water spray (4 min spray duration, 120 mL/min), based on mass, ranged from 88% to 92% for particles ≤ 10 µm equivalent aerodynamic diameter (EAD) and from 34% to 70% for particles ≤ 2.5 µm EAD. A model based on coagulation was used to predict the particle concentration after spraying of charged water. Predicted values of concentration and removal efficiency agreed well with measured values. A prototype EAPWS was also developed. Laboratory and field evaluations of the EAPWS indicated that it had significantly higher particle removal efficiency than either the control (i.e., no water spray) or the uncharged wet scrubber.

Master of Science / Department of Biological & Agricultural Engineering / James K. Koelliker / In 2003, the EPA changed Confined Animal Feedlot Operation (CAFO) regulations to allow an alternative treatment system for feedlot runoff if a 25-year simulation can show better performance for the alternative treatment system when compared to a traditional lagoon system. A continuous computer simulation model written in C was developed to compare the release of water, nitrogen (N), phosphorous (P) and chemical oxygen demand (COD) from a Vegetated Treatment Area (VTA) system and a conventional lagoon system in Kansas. The model simulates the transport of water and constituents in a feedlot, settling basin, lagoon, and VTA. The feedlot runoff is based on NRCS unit hydrograph method for the water balance and AnnAgNPS for the constituent runoff concentrations. The settling basin is a simple water balance with sediment, organic-N, P, and COD removed with settling of the solids. The VTA is designed to calculate infiltration with Green-Ampt Equation and overland flow with Manning's Law. The VTA removes organic-N and P with the Kentucky Filtration Model. The lagoon is derived from Koelliker et al. model water balance and pumping schedule with constituent balance from Miner et al. model. VTA portion of the model was analyzed for sensitivity and calibrated with three storms. The sensitivity analysis showed that the size of the VTA and conductivity of the soil in the VTA causes the greatest variability in the release of N, P, and COD. The calibration of the release of organic-N and P for mean particle diameter showed that a diameter of 1.5 µm produced the best agreement. The model was used for a lagoon and VTA system at two sites in Kansas with 35 years of weather data. The sites were located in Ottawa and Greenwood Counties, KS. The simulated results showed that the lagoon system performed better for both sites when comparing the mean values of total-N, total-P, and COD released over the 35 years. The VTA system performance was better when median values of total-P and COD were compared at Greenwood County. This model was designed for use in Kansas, but with modifications may be useful in other areas.

Doctor of Philosophy / Department of Biological & Agricultural Engineering / Donghai Wang, Scott Bean / The performance of soybean hulls and forage sorghum as feed stocks for ethanol production was studied. The main goal of this research was to increase fermentable sugars' yield through high-efficiency pretreatment technology. Soybean hulls are a potential feedstock for production of bio-ethanol due to their high carbohydrate content ([approximately equals]50%) of nearly 37% cellulose. Soybean hulls could be the ideal feedstock for fuel ethanol production, because they are abundant and require no special harvesting and additional transportation costs as they are already in the plant. Dilute acid and modified steam-explosion were used as pretreatment technologies to increase fermentable sugars yields. Effects of reaction time, temperature, acid concentration and type of acid on hydrolysis of hemicellulose in soybean hulls and total sugar yields were studied. Optimum pretreatment parameters and enzymatic hydrolysis conditions for converting soybean hulls into fermentable sugars were identified. The combination of acid (H[subscript]2SO[subscript]4, 2% w/v) and steam (140 °C, 30 min) efficiently solubilized the hemicellulose, giving a pentose yield of 96%. Sorghum is a tropical grass grown primarily in semiarid and dry parts of the world, especially in areas too dry for corn. The production of sorghum results in about 30 million tons of byproducts mainly composed of cellulose, hemicellulose, and lignin. Forage sorghum such as brown midrib (BMR) sorghum for ethanol production has generated much interest since this trait is characterized genetically by lower lignin concentrations in the plant compared with conventional types. Three varieties of forage sorghum and one variety of regular sorghum were characterized and evaluated as feedstock for fermentable sugar production. Fourier transform infrared spectroscopy (FTIR), scanning electron microscope (SEM) and X-Ray diffraction were used to determine changes in structure and chemical composition of forage sorghum before and after pretreatment and enzymatic hydrolysis process. Up to 72% of hexose yield and 94% of pentose yield were obtained using "modified" steam explosion with 2% sulfuric acid at 140°C for 30 min and enzymatic hydrolysis with cellulase (15 FPU/g cellulose) and [Beta]-glucosidase (50 CBU/g cellulose).

No description available.

No description available.

No description available.