Les déchets radioactifs sont stockés dans des milieux poreux multi-phasiques. Un nouveau modèle d'endommagement, formulé en variable indépendantes (contrainte nette, succion et contrainte thermique) est proposé pour ces géomatériaux. La variable d'endommagement est un tenseur d'ordre deux, dont les valeurs principales croissent avec la tension. Les relations contrainte/déformation sont dérivées de l'énergie libre, dont l'expression est postulée. Les rigidités dégradées sont calculées en appliquant le principe de l'Energie Elastique Equivalente pour chaque variable d'état. La fissuration est prise en compte dans les transferts d'humidité, au moyen de longueurs internes. Le modèle d'endommagement a été intégré dans le code d'Eléments Finis Θ-Stock. Le modèle mécanique a été validé en comparant des résultats numériques à des résultats expérimentaux et théoriques. Les tendances données par le modèle dans les études paramétriques sur des configurations réalistes complexes sont bonnes.

Clay shales are currently being assessed as possible host rock formations for the deep geological disposal of radioactive waste. However, one main concern is that the favourable long-term isolation properties of the intact rock mass could be negatively affected by the formation of an excavation damaged zone (EDZ) around the underground openings. This thesis investigated the deformation and failure process of a clay shale, namely Opalinus Clay, with particular focus on the influence of anisotropy on the short-term response of circular tunnels. To achieve this goal, a hybrid continuum-discontinuum numerical approach was used in combination with new field measurements from the Mont Terri underground research laboratory. The response of Opalinus Clay during the excavation of a full-scale emplacement (FE) test tunnel was characterized by geodetic monitoring of wall displacements, radial extensometers and longitudinal inclinometers. The deformation measurements indicated strong directionality induced by the combined effect of in situ stress field and presence of bedding planes striking parallel to the tunnel axis, with the most severe deformation occurring in the direction approximately perpendicular to the material layering. Computer simulations were conducted using a newly-extended combined finite-discrete element method (FEM/DEM), a numerical technique which allows the explicit simulation of brittle fracturing and associated seismicity. The numerical experimentation firstly focused on the laboratory-scale analysis of failure processes (e.g., acoustic activity) in brittle rocks, and on the role of strength and modulus anisotropy in the failure behaviour of Opalinus Clay in tension and compression. The fracturing behaviour of unsupported circular excavations in laminated rock masses was then analyzed under different in situ stress conditions. Lastly, the modelling methodology was applied to the aforementioned FE tunnel to obtain original insights into the possible EDZ formation process around emplacement tunnels for nuclear waste. The calibrated numerical model suggested delamination along bedding planes and subsequent extensional fracturing as key mechanisms of the damage process potentially leading to buckling and spalling phenomena. Overall, the research findings may have a potential impact on the constructability and support design of an underground repository as well as implications for its long-term safety assessment procedure.

Clay shales are currently being assessed as possible host rock formations for the deep geological disposal of radioactive waste. However, one main concern is that the favourable long-term isolation properties of the intact rock mass could be negatively affected by the formation of an excavation damaged zone (EDZ) around the underground openings. This thesis investigated the deformation and failure process of a clay shale, namely Opalinus Clay, with particular focus on the influence of anisotropy on the short-term response of circular tunnels. To achieve this goal, a hybrid continuum-discontinuum numerical approach was used in combination with new field measurements from the Mont Terri underground research laboratory. The response of Opalinus Clay during the excavation of a full-scale emplacement (FE) test tunnel was characterized by geodetic monitoring of wall displacements, radial extensometers and longitudinal inclinometers. The deformation measurements indicated strong directionality induced by the combined effect of in situ stress field and presence of bedding planes striking parallel to the tunnel axis, with the most severe deformation occurring in the direction approximately perpendicular to the material layering. Computer simulations were conducted using a newly-extended combined finite-discrete element method (FEM/DEM), a numerical technique which allows the explicit simulation of brittle fracturing and associated seismicity. The numerical experimentation firstly focused on the laboratory-scale analysis of failure processes (e.g., acoustic activity) in brittle rocks, and on the role of strength and modulus anisotropy in the failure behaviour of Opalinus Clay in tension and compression. The fracturing behaviour of unsupported circular excavations in laminated rock masses was then analyzed under different in situ stress conditions. Lastly, the modelling methodology was applied to the aforementioned FE tunnel to obtain original insights into the possible EDZ formation process around emplacement tunnels for nuclear waste. The calibrated numerical model suggested delamination along bedding planes and subsequent extensional fracturing as key mechanisms of the damage process potentially leading to buckling and spalling phenomena. Overall, the research findings may have a potential impact on the constructability and support design of an underground repository as well as implications for its long-term safety assessment procedure.

Sedimentary rocks are characterized with very low permeability (in the order of 10-22 m2), low diffusivity, a possible self-healing of fractures, and a good capacity to retard radionuclide transport. In recent years, sedimentary rocks are investigated by many research groups for their suitability for the disposal of radioactive waste. Development of deep geologic repositories (DGRs) for the storage of radioactive waste within these formations causes progressive modification to the state of stress, to the groundwater regime, and to the chemistry of the rock mass. Thermal effects due to the ongoing nuclear activity can cause additional disturbances to the system. All these changes in the system are coupled and time-dependent processes. These coupled processes can result in the development of an excavation damaged zone (EDZ) around excavations. More permeable than the undisturbed rock, the EDZ is likely to be a preferential pathway for water and gas flow. Consequently, the EDZ could be a potential exit pathway for the radioactive waste to biosphere. An investigation of the Hydraulic-Mechanical (HM) and Thermal-Hydraulic-Mechanical-Chemical (THMC) behaviour of sedimentary rock formations is essential for the development of DGRs within such formations. This research work consists of (1) an experimental investigation of the mechanical behaviour of the anisotropic Tournemire argillite, (2) modeling of the mechanical behaviour of the Tournemire argillite, and (3) numerical simulations of the mechanical and hydromechanical behavior of two host sedimentary rocks, the Tournemire argillite and Cobourg limestone, for deep geological repository for nuclear wastes. The experimental program includes the measurements of the physical properties of the Tournemire argillite and its mechanical response to loading during uniaxial compression tests, triaxial compression tests with different confining pressures, unconfined and confined cyclic compression tests, Brazilian tests, and creep tests. Also, acoustic emission events are recorded to detect the initiation and propagation of microcracks within the rock during the uniaxial testing. The approach for modeling the mechanical behaviour of the Tournemire argillite consists of four components: elastic properties of the argillite, a damage model, the proposed concept of mobilized strength parameters, and the classical theory of elastoplasticity. The combination of the four components results in an elastoplastic-damage model for describing the mechanical behaviour of the Tournemire argillite. The capabilities of the model are evaluated by simulating laboratory experiments. Numerical simulations consist of: (1) a numerical simulation of a mine-by-test experiment at the Tournemire site (France), and (2) numerical simulations of the mechanical and hydromechanical behaviour of the Cobourg limestone within the EDZ (Canada). The parameters influencing the initiation and evolution of EDZ over time in sedimentary rocks are discussed.

Sedimentary rocks are characterized with very low permeability (in the order of 10-22 m2), low diffusivity, a possible self-healing of fractures, and a good capacity to retard radionuclide transport. In recent years, sedimentary rocks are investigated by many research groups for their suitability for the disposal of radioactive waste. Development of deep geologic repositories (DGRs) for the storage of radioactive waste within these formations causes progressive modification to the state of stress, to the groundwater regime, and to the chemistry of the rock mass. Thermal effects due to the ongoing nuclear activity can cause additional disturbances to the system. All these changes in the system are coupled and time-dependent processes. These coupled processes can result in the development of an excavation damaged zone (EDZ) around excavations. More permeable than the undisturbed rock, the EDZ is likely to be a preferential pathway for water and gas flow. Consequently, the EDZ could be a potential exit pathway for the radioactive waste to biosphere. An investigation of the Hydraulic-Mechanical (HM) and Thermal-Hydraulic-Mechanical-Chemical (THMC) behaviour of sedimentary rock formations is essential for the development of DGRs within such formations. This research work consists of (1) an experimental investigation of the mechanical behaviour of the anisotropic Tournemire argillite, (2) modeling of the mechanical behaviour of the Tournemire argillite, and (3) numerical simulations of the mechanical and hydromechanical behavior of two host sedimentary rocks, the Tournemire argillite and Cobourg limestone, for deep geological repository for nuclear wastes. The experimental program includes the measurements of the physical properties of the Tournemire argillite and its mechanical response to loading during uniaxial compression tests, triaxial compression tests with different confining pressures, unconfined and confined cyclic compression tests, Brazilian tests, and creep tests. Also, acoustic emission events are recorded to detect the initiation and propagation of microcracks within the rock during the uniaxial testing. The approach for modeling the mechanical behaviour of the Tournemire argillite consists of four components: elastic properties of the argillite, a damage model, the proposed concept of mobilized strength parameters, and the classical theory of elastoplasticity. The combination of the four components results in an elastoplastic-damage model for describing the mechanical behaviour of the Tournemire argillite. The capabilities of the model are evaluated by simulating laboratory experiments. Numerical simulations consist of: (1) a numerical simulation of a mine-by-test experiment at the Tournemire site (France), and (2) numerical simulations of the mechanical and hydromechanical behaviour of the Cobourg limestone within the EDZ (Canada). The parameters influencing the initiation and evolution of EDZ over time in sedimentary rocks are discussed.