1 |
Experimental Investigation of Flow Structure Development in Air-water Two-phase FlowsDoup, Benjamin 20 June 2012 (has links)
No description available.
|
2 |
Environmental impact assessment and process simulation of the tidal current energy resource in the Strait of MessinaEl-Geziry, Tarek Mohamed Ahmed January 2010 (has links)
Interest in exploring renewable energy resources has increased globally, especially with recent worldwide intentions to maintain the global climate. Looking at the oceans as a vast sustainable clean energy resource to satisfy present high humankind energy demands has been strongly recommended. Several types of renewable energy resources exist in the oceans: waves, tides, thermal and salinity variations, currents, and offshore winds. Exploiting tidal currents is considered one of the most effective approaches to the generation of electricity. Tidal turbines are deployed beneath the sea surface to transfer the kinetic energy in tidal currents to mechanical energy suitable for ongoing conversion to electricity and subsequent transmission. However, choosing a suitable site to deploy these turbines is not a trivial process. Various constraints must be satisfied subject to basic criteria dependent upon local factors, technology limitation and economic consideration. In addition, an important issue to consider is taking care to harness energy from tidal currents with minimum possible impact on the surrounding environment. The present study justifies the nomination of the Strait of Messina as an exceptional tidal current energy resource within the Mediterranean Sea basin. The maximum tidal current velocity at spring peak tide through the Strait may exceed 3 m/s. This mainly results from the tidal phase-difference (180°) between the northern (Tyrrhenian Sea) and southern (Ionian Sea) tips of the Strait, associated with a difference of 0.27 m in tidal wave amplitudes. In addition, the complex coastline configuration of the Strait plays an important role in enhancing tidal current velocities. Therefore, the Strait of Messina fulfils the basic criterion (2 m/s tidal current velocity) to be considered as a valid tidal current energy resource. This massive tidal current energy resource is assessed in the present study. A detailed full desk-based Environmental Impact Assessment (EIA) study is performed using the interactive matrix approach in order to investigate the anticipated environmental impacts on the marine ecosystem of the Strait of Messina resulting from the harnessing of energy from its tidal currents. Through the EIA study the different environmental components, both biotic and abiotic, which may be affected by the energy extraction process, are explained. In addition, the proposed key project activities are listed; the likelihood of occurrence and the magnitude of impact interaction with the environmental components are evaluated. The final judgment matrix guides to make a right decision on the proposed project. From the resulted matrix, the major impacts do not exceed 10% of the total anticipated effects. The positive point is that all the expected impacts, including the majors, can be controlled and minimised to the lowest possible limits by applying a good monitoring programme. The University of Edinburgh “Tidal Flow Development (TFD)” numerical model is used to mimic the tidal environment of the Strait of Messina in different cases. The model successfully simulates the tidal flow regime within the Strait under some exceptional conditions. Modifications to the main numerical code and coefficients were necessary in the present research to adjust the model according to each case study. In the three different cases of simulation, using these exceptional coefficients, the model simulates the main tidal characteristics of the tidal flow within the Strait. According to the results of the numerical simulation process, tidal currents are more intensive close to the eastern coast of the Strait of Messina near to Punta Pezzo. This area is far from any ferry route between Italy and Sicily. The best location to deploy tidal turbines for the energy extraction process is therefore recommended to be within these surroundings. Finally, a physical (laboratory) model is used to simulate the flow regime within the Strait of Messina. The Particle Image Velocimetry (PIV) technique was applied in the flow-table tank at the University of Edinburgh. The physical model simulates the flow behaviour within the Strait of Messina to a satisfactory degree. The cyclonic and anti-cyclonic motions observed at the southern extremity of the Strait are also very well simulated. The results of the present study assure confidence in the use of tidal currents within the Strait of Messina as a renewable energy resource. The safety of the environment must be ensured by following environmental guidelines, respecting the energy extraction limits and by applying an effective monitoring programme. The later is strongly recommended to be an adaptive one in which higher environmental authorities are able to watch, revise and control the environmental team within the project. These authorities are also able to postpone the project in case of any severe environmental case. The simulation processes emphasize the effect of morphometry and topography in enhancing tidal currents in the Strait of Messina. Moreover, numerical simulation assures that the complex morphometry and bathymetry, in addition to the open boundaries of the Strait of Messina, are challenging issues for modellers in order to mimic the real tidal current resource in the case of the Strait of Messina. The study also strongly recommends applying a more effective numerical model than TFD to assess the tidal hydrodynamical environment before and after any proposed energy extraction process. This will certainly, with the EIA of the marine ecosystem, help to make a right decision about the proposed project in order to achieve the goal of using clean and clear renewable energy resources while maintaining both natural and hydrodynamical environments to the most possible safest degree.
|
3 |
Investing Flow over an Airfoil at Low Reynolds Numbers Using Novel Time-Resolved Surface Pressure MeasurementsGerakopulos, Ryan 06 April 2011 (has links)
An aluminum NACA 0018 airfoil testbed was constructed with 95 static pressure taps and 25 embedded microphones to enable novel time-resolved measurements of surface pressure. The main objective of this investigation is to utilize time-resolved surface pressure measurements to estimate salient flow characteristics in the separated flow region over the upper surface of an airfoil. The flow development over the airfoil was examined using hot wire anemometry and mean surface pressure for a range of Reynolds numbers from 80x103 to 200x103 and angles of attack from 0° to 18°. For these parameters, laminar boundary layer separation takes place on the upper surface and two flow regimes occur: (i) separation is followed by flow reattachment, so that a separation bubble forms and (ii) separation occurs without subsequent reattachment. Measurements of velocity and mean surface pressure were used to characterize the separated flow region and its effect on airfoil performance using the lift coefficient. In addition, the transition process and the evolution of disturbances were examined. The lift curve characteristics were found to be linked to the rate of change of the separation, transition, and reattachment locations with the angle of attack. For both flow regimes, transition was observed in the separated shear layer. Specifically, the amplification of disturbances within a band of frequencies in the separated shear layer resulted in laminar to turbulent transition. Validation of time-resolved surface pressure measurements was performed for Rec = 100x103 at α = 8° and α = 12°, corresponding to regimes of flow separation with and without reattachment, respectively. A comparative analysis of simultaneous velocity and time-resolved surface pressure measurements showed that the characteristics and development of velocity fluctuations associated with disturbances in the separated shear layer can be extracted from time-resolved surface pressure measurements. Specifically, within the separated flow region, the amplitude of periodic oscillations in the surface pressure signal associated with disturbances in the separated shear layer grew in the streamwise direction. In addition, the frequency at the spectral peak of the amplified disturbances in the separated shear layer was identified. Based on the results of the validation analysis, time-resolved surface pressure measurement analysis techniques were applied for a Reynolds number range from 60x103 to 130x103 and angles of attack from 6° to 16°. Within the separated flow region, the streamwise growth of surface pressure fluctuations is distinctly different depending on the flow regime. Specifically, within the separation bubble, the RMS surface pressure fluctuations increase in the streamwise direction and reach a peak just upstream of the reattachment location. The observed trend is in agreement with that observed for other separating-reattaching flows on geometries such as the forward and backward facing step and splitter plate with fence. In contrast to the separation bubble formation, when the separated shear layer fails to reattach to the airfoil surface, RMS surface pressure fluctuations increase in the streamwise direction with no maximum and the amplitude is significantly lower than those observed in the separation bubble. Surface pressure signals were further examined to identify the frequency, convective velocity, and spanwise uniformity of disturbances in the separated shear layer. Specifically, for both flow regimes, the fundamental frequency and corresponding Strouhal number exhibit a power-law dependency on the Reynolds number. Based on the available data for which velocity measurements were obtained in the separated flow region, the convective velocity matched the mean velocity at the wall-normal distance corresponding to the maximum turbulence intensity. A distinct increase in the convective velocity of disturbances in the separated shear layer was found when the airfoil was stalled in comparison to that found in the separation bubble. From statistical analysis of surface pressure signals in the spanwise direction, it was found that disturbances are strongly two-dimensional in the laminar portion of the separated shear layer and become three-dimensional through the transition process.
|
4 |
Investing Flow over an Airfoil at Low Reynolds Numbers Using Novel Time-Resolved Surface Pressure MeasurementsGerakopulos, Ryan 06 April 2011 (has links)
An aluminum NACA 0018 airfoil testbed was constructed with 95 static pressure taps and 25 embedded microphones to enable novel time-resolved measurements of surface pressure. The main objective of this investigation is to utilize time-resolved surface pressure measurements to estimate salient flow characteristics in the separated flow region over the upper surface of an airfoil. The flow development over the airfoil was examined using hot wire anemometry and mean surface pressure for a range of Reynolds numbers from 80x103 to 200x103 and angles of attack from 0° to 18°. For these parameters, laminar boundary layer separation takes place on the upper surface and two flow regimes occur: (i) separation is followed by flow reattachment, so that a separation bubble forms and (ii) separation occurs without subsequent reattachment. Measurements of velocity and mean surface pressure were used to characterize the separated flow region and its effect on airfoil performance using the lift coefficient. In addition, the transition process and the evolution of disturbances were examined. The lift curve characteristics were found to be linked to the rate of change of the separation, transition, and reattachment locations with the angle of attack. For both flow regimes, transition was observed in the separated shear layer. Specifically, the amplification of disturbances within a band of frequencies in the separated shear layer resulted in laminar to turbulent transition. Validation of time-resolved surface pressure measurements was performed for Rec = 100x103 at α = 8° and α = 12°, corresponding to regimes of flow separation with and without reattachment, respectively. A comparative analysis of simultaneous velocity and time-resolved surface pressure measurements showed that the characteristics and development of velocity fluctuations associated with disturbances in the separated shear layer can be extracted from time-resolved surface pressure measurements. Specifically, within the separated flow region, the amplitude of periodic oscillations in the surface pressure signal associated with disturbances in the separated shear layer grew in the streamwise direction. In addition, the frequency at the spectral peak of the amplified disturbances in the separated shear layer was identified. Based on the results of the validation analysis, time-resolved surface pressure measurement analysis techniques were applied for a Reynolds number range from 60x103 to 130x103 and angles of attack from 6° to 16°. Within the separated flow region, the streamwise growth of surface pressure fluctuations is distinctly different depending on the flow regime. Specifically, within the separation bubble, the RMS surface pressure fluctuations increase in the streamwise direction and reach a peak just upstream of the reattachment location. The observed trend is in agreement with that observed for other separating-reattaching flows on geometries such as the forward and backward facing step and splitter plate with fence. In contrast to the separation bubble formation, when the separated shear layer fails to reattach to the airfoil surface, RMS surface pressure fluctuations increase in the streamwise direction with no maximum and the amplitude is significantly lower than those observed in the separation bubble. Surface pressure signals were further examined to identify the frequency, convective velocity, and spanwise uniformity of disturbances in the separated shear layer. Specifically, for both flow regimes, the fundamental frequency and corresponding Strouhal number exhibit a power-law dependency on the Reynolds number. Based on the available data for which velocity measurements were obtained in the separated flow region, the convective velocity matched the mean velocity at the wall-normal distance corresponding to the maximum turbulence intensity. A distinct increase in the convective velocity of disturbances in the separated shear layer was found when the airfoil was stalled in comparison to that found in the separation bubble. From statistical analysis of surface pressure signals in the spanwise direction, it was found that disturbances are strongly two-dimensional in the laminar portion of the separated shear layer and become three-dimensional through the transition process.
|
5 |
Stanovení ekonomické efektivnosti developerského projektu / Determination of Economic Efficiency of the Development ProjectHrdinová, Denisa January 2015 (has links)
The work deals with the determination of cash flows and evaluating the economic efficiency of a development project for the construction of residential buildings. The theoretical part explains the concepts of economic efficiency and putting their indicators, describes the business plan development activities and cash flows. The thesis also addressed the possibility of financing investment projects, as well as an analysis of the current situation of the Czech economy. In the practical part of the description is made of the entire completed project, determining the cash flows of the project and its subsequent evaluation and assessment of economic efficiency.
|
6 |
Hodnocení ekonomické efektivnosti investičního záměru / Evaluation of Economic Efficiency of Investment ProjectDanyśová, Ester January 2017 (has links)
The thesis focuses on determination of cash flow and evaluation of economic efficiency of the development project of the residential construction in Brno. The theoretical part deals with basic evaluation of economic efficiency of investment project including the most used indicators and gives insight into the developing activity including risks that companies must count with in such projects. The practical part deals with the particular project where cash flows are determined and its economic efficiency is evaluated.
|
7 |
Management investičních rizik výstavbového projektu / Investment Risk Management of Construction ProjectPluháčková, Darinka January 2019 (has links)
The goal of this paper is to evaluate economic efficiency of a development project, including sensitivity and probability analysis of selected residential development project. In theoretical part, the term "development project" is explained and project lifecycle is described. In this part there is also mentioned, how cash flow is determined, how cash flow report is created, and how economic efficiency indicators are calculated. It also describes specific risks of a development project. In the end of theoretical part, possible risk identification and evaluation methods are described. Practical part is focused on an actual development project. It evaluates the project using economic efficiency indicators, sensitivity analysis and probability analysis.
|
8 |
Ekonomická efektivnost a finanční proveditelnost podnikatelského záměru / Economic Efficiency and Finacial Feasibility of the Business PlanTroanská, Eva January 2015 (has links)
The work aims to determine the economic efficiency and financial feasibility of the business plan, the construction of residential housing complex using a sensitivity analysis to determine the risk that the economic efficiency of most influence. The theoretical part of this work are the basic areas relating to the evaluation of economic efficiency, cash flow, sensitivity analysis and development project. The practical part deals with a specific project CAMPUS REZIDENČNÍ AREÁL II. Showing cash flows on the project and determining the various indicators of economic efficiency. The study also prepared a sensitivity analysis for the project scenario and determine the maximum risk that may threaten the economic efficiency of the project.
|
Page generated in 0.0953 seconds